Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

BMW Série 7 E38

1994–2001 · 9 defeitos documentados · 3 mercados
Ano do modelo
RecallCríticoSuspensãoJP

かじ取ギヤボックス

かじ取り装置において、ギアボックスにある油圧パイプの取り付けボルトの締め付けトル クが不適切なため、走行時の振動等で当該ボルトがゆるむものがあり、そのままの状態で 使用を続けると、パワーステアリングの作動油が漏れてかじ取りハンドルの操舵力が増大 し、最悪の場合、漏れた作動油が着火して火災に至るおそれがある。

MLIT · Japão11 de mar. de 20031210100Anos-modelo 2000Exibido no japonês original · tradução pendenteVer detalhes →
RecallCríticoCâmbioNA

Power train:Driveline:Differential unit

Vehicle description: Passenger vehicles. The differential pinion shaft within the differential case assembly was produced without the appropriate surface hardening. This can result in the shaft experiencing premature wear.

NHTSA · Estados Unidos22 de jun. de 199898V142000Anos-modelo 1998Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoSuspensãoJP

スプリング/エアサス

緩衝装置において、前輪側のコイルスプリングの形状が不適切なため、そのままの状態で 主に積雪地帯での使用をすると、当該スプリングと下部のパッドとの間に蓄積された異物 により生じた傷から腐食することがあり、最悪の場合、折損し、走行安定性を損なうおそ れがある。

MLIT · Japão27 de set. de 20011209040Anos-modelo 1994–1996Exibido no japonês original · tradução pendenteVer detalhes →
RecallModeradoElétricaNA

Electrical

On certain 323I, 328I, 528I, 528IT, 540I, 540IT, 740I, 740IL, 750IL and M5 vehicles, the brake light switch capacitor housing may be cracked and in high humidity conditions the capacitor and switch housing could become overheated and deformed. As a result, a short circuit or an open circuit could occur in the switch. This could cause the switch to remain either in the "brake lamps off" position or the "brake lamps on" position. If the switch remains in the "off" position, the brake lamps will be rendered inoperative. Conversely, if the switch remains in the "on" position, the brake lamps will be continuously illuminated when the ignition switch is in the "on" position. Correction: Brake lamp switch will be replaced with an improved switch.

Transport Canada9 de mar. de 20002000065Anos-modelo 2000Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoFreiosJP

制動灯

制動灯の制御回路において、制動灯用スイッチに一部製造不良のものがあり、そのままの 状態で使用を続けると電子回路が故障し、最悪の場合、ブレーキペダルの操作とは関係な く、制動灯が点滅もしくは点灯し続けてしまうおそれがある。

MLIT · Japão17 de fev. de 20001207850Anos-modelo 1999Exibido no japonês original · tradução pendenteVer detalhes →
RecallModeradoFreiosNA

Exterior lighting:Brake lights:Switch

Vehicle description: Passenger vehicles. The brake lamps in these vehicles are controlled by a switch activated by the movement of the brake pedal. This switch could fail internally, causing it to remain either in the "brake lamps off" position or in the "brake lamps on" position.

NHTSA · Estados Unidos17 de fev. de 200000V048000Anos-modelo 2000Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoFreiosUK

Brake lights may fail to operate remain on or flicker

There is a possibility that the brake light switch circuits may become defective and cause the brake light circuit to fail stay on continuously or flicker. In extreme cases the brake switch could overheat.

DVSA · Reino Unido15 de dez. de 1999R/1999/104Anos-modelo 1999Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoElétricaNA

Electrical system:12v/24v/48v battery:Cables

Vehicle description: Passenger vehicles. The thickness of the main positive electrical cable (generator to starter) insulation is less than specified, making it susceptible to being abraded or cut by the clip that secures the cable to the generator.

NHTSA · Estados Unidos4 de jan. de 199999V004000Anos-modelo 1999Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoCâmbioNA

Power train:Automatic transmission

Vehicle description: Passenger vehicles equipped with a 5hp24 automatic transmission. Premature wear of the ring gear can occur, leading to the loss of 1st, 2nd, 3rd, and reverse gears.

NHTSA · Estados Unidos4 de jan. de 199999V005000Anos-modelo 1999Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoInteriorNA

Aquecedor e Desembaçador

Em determinados veículos, a falha de um componente do sistema de arrefecimento, como o termostato, a bomba d'água ou a correia do ventilador, pode resultar em um aumento significativo da temperatura do líquido de arrefecimento e da pressão do sistema. O aumento da pressão do sistema pode provocar a formação de uma trinca ou a separação de uma costura na extremidade do núcleo do aquecedor, o que faria com que o líquido de arrefecimento quente fosse expelido do núcleo do aquecedor. Esse fluido quente pode atingir os ocupantes do veículo, resultando em possíveis lesões pessoais e/ou embaçamento das superfícies internas dos vidros. Correção: o tampão do radiador será substituído por um novo tampão de projeto diferente, a fim de evitar o acúmulo de pressão excessiva no sistema de arrefecimento.

Transport Canada14 de out. de 19981998197Anos-modelo 1994–1995Traduzido automaticamente · original: inglêsVer detalhes →
RecallModeradoMotorNA

Engine and engine cooling:Cooling system

Vehicle description: Passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, can result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.

NHTSA · Estados Unidos4 de ago. de 199898V178000Anos-modelo 1994–1995Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoCâmbioNA

Powertrain

On certain 540I, 540IA, 740IA, 740ILA and 750ILA, the differential pinion shaft in the differential case assembly was not properly surface hardened. This condition will result in premature wear which can lead to noisy operation and ultimately to a lack of drive capability through the rear axle. Correction: Entire differential assembly will be replace on affected vehicles.

Transport Canada15 de jul. de 19981998134Anos-modelo 1998Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoSuspensãoNA

Suspension

On certain 740I, 740IL and 750IL vehicles, road grit and gravel associated with winter road conditions can penetrate the rubber of the lower front spring mounts and accumulate in the mounts causing notches or pits to develop. Eventually this could cause the coild spring to crack and break at a bottom coild. This could adversely affect the vehicle's dynamic stability and reduce driver control. Correction: Both front springs and lower spring mounts will be replace on affected vehicles.

Transport Canada9 de out. de 19971997174Anos-modelo 1995–1997Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoMotorNA

Engine

On certain 318IC, 318IS, 318TI, 325I, 325IC, 325IS, 525I, 525IT, 530I, 530IT, 540I, 740I, 740IL, 840CI and M3, the cruise control and throttle cable are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break causing the outer cable housing to separate from the bushing. Throttle pedal application without cruise control engagement could cause the outer tube to catch on the edge of the broken bushing resulting in the throttle valve remaining partially open. If this were to occur, the car might not decelerate as expected and a crash could occut. Correction: A spring clip will be installed on the outer tube of each cable to prevent dislodgment from the bushing.

Transport Canada9 de out. de 19971997173Anos-modelo 1995–1997Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoMotorNA

Vehicle speed control

The cruise control and throttle cables are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break due to environmental influences coupled with vibration. If the bushing breaks, the outer cable housing can separate from the bushing. In this case, during application of the throttle pedal without cruise control being engaged, the outer tube could catch on the edge of the broken bushing.

NHTSA · Estados Unidos19 de ago. de 199797V131000Anos-modelo 1994–1997Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoElétricaNA

Lights And Instruments

On certain 325I, 325IC, 325IS, 525I, 525IT, 530I, 530IT, 535I, 540I, 735I, 735IL, 740I, 740IL and 750I, the brake light switch may fail due to a reduction of contact force on the "snap contact" system which the switch incorporates. This could cause heat induced distortion of the plastic internal switch parts in the area of the electrical contacts. This could cause the switch to remain either in the ON or the OFF position resulting in the brake lights being continuously illuminated or inoperative regardless of brake pedal operation. Correction: Switch will be replaced with on that utilizes a different contact system.

Transport Canada7 de out. de 19961996158Anos-modelo 1994Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoFreiosNA

Exterior lighting:Brake lights:Switch

The brake light switch can fail allowing the switch to remain in the "brake lights off" position or in the "brake lights on" position.

NHTSA · Estados Unidos1 de jul. de 199696V111000Anos-modelo 1994Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoMotorJP

燃料ホース/パイプ

エンジンル-ム内の金属製燃料パイプの端部形状が不適切なため、車両の振動等により 当該パイプに接続するゴム製燃料ホースが損傷し、そのままの状態で使用を続けると燃料 が漏れるおそれがある。

MLIT · Japão8 de fev. de 19961205812Anos-modelo 1994–1995Exibido no japonês original · tradução pendenteVer detalhes →
RecallModeradoSuspensãoJP

その他(緩衝装置)

後輪右側の緩衝装置を構成するホイールキャリア(ホイール取付用部品)に鋳造不良の ものがあり、そのままの状態で使用を続けると、鋳造不良の部分が破損し、走行安定性を 損なうおそれがある。

MLIT · Japão8 de fev. de 19961205811Anos-modelo 1995Exibido no japonês original · tradução pendenteVer detalhes →
RecallModeradoSuspensãoNA

Suspension

On certain 740I, 740IL and 750IL vehicles, the lower suspension arm mounting eye on the right side rear axle hub carrier could have a casting flaw. It is possible that the carrier eye could crack and break during driving. If this were to occur, the right rear wheel would no longer function as designed and the driver's ability to maintain control of the vehicle would be considerably reduced. Correction: Right side rear axle hub carrier will be inspected for the presence of the casting flaw and replaced if the flaw is present.

Transport Canada23 de out. de 19951995189Anos-modelo 1995Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoSuspensãoNA

Suspension:Rear

The lower suspension arm mounting eye on the right side rear axle hub carrier was produced with a casting flaw.

NHTSA · Estados Unidos11 de out. de 199595V192000Anos-modelo 1995Exibido no inglês original · tradução pendenteVer detalhes →
RecallLeveCarroceriaNA

Equipamento:Outros:Etiquetas

US Specs está retirando de circulação um Porsche Carrera 2002, um BMW 750iL 1997 e dois BMW 635 CSI 1986 por não cumprirem a Norma Federal de Segurança de Veículos Automotores nº 111, "Retrovisores". Durante modificações de conformidade para o mercado dos EUA, foram aplicadas etiquetas com tamanho de fonte incorreto no espelho retrovisor do lado do passageiro.

NHTSA · Estados Unidos26 de fev. de 201313V063000Anos-modelo 1997Traduzido automaticamente · original: inglêsVer detalhes →
RecallLeveSuspensãoNA

Suspension:Front:Springs:Coil springs

Vehicle description: Passenger vehicles. Road grit and gravel associated with winter road conditions can penetrate the rubber of the lower front spring mounts and accumulate in the mounts causing notches or pits to develop. These notches can develop cracks resulting in breakage of a bottom coil of the spring.

NHTSA · Estados Unidos22 de ago. de 199797V140000Anos-modelo 1995–1997Exibido no inglês original · tradução pendenteVer detalhes →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).