Este dossiê reúne os defeitos conhecidos do BMW 8 (E31), escritos e documentados pela comunidade. A leitura é livre; uma conta gratuita permite contribuir. Um defeito recebe o selo quando colaboradores reconhecidos suficientes o validam.
Os proprietários relatam muitas vezes problemas de exterior lighting neste carro (12 queixas), mas ninguém explicou ainda a causa. Sabe qual é?Redigir a ficha
12 owners in the United States reported problems with the exterior lighting of this car to NHTSA (model years 1991–1997), typically at around 81,000 miles. Most often named: headlights (83%). Reported consequences: 1 fire.
✓ Análise Mecafile de dados oficiais1991–1997Exibido no inglês original · tradução pendenteVer detalhes →
On certain vehicles, failure of a cooling system component such as thermostat, water pump or fan belt can result in a significant increase in coolant temperature and system pressure. Increased system pressure could result the formation of a crack or separation of a seam in the heater core end piece which would cause hot coolant to be expelled from the heater core. This hot fluid could contact car occupants resulting in possible personal injury and/or fogging of the interior window surfaces. Correction: Radiator cap will be replaced with a new design cap in order to avoid buildup of excessive pressure in the cooling system.
Transport Canada14 de out. de 19981998197Anos-modelo 1991–1995Exibido no inglês original · tradução pendenteVer detalhes →
Vehicle description: Passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, can result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.
NHTSA · Estados Unidos4 de ago. de 199898V178000Anos-modelo 1991–1995Exibido no inglês original · tradução pendenteVer detalhes →
On certain 318IC, 318IS, 318TI, 325I, 325IC, 325IS, 525I, 525IT, 530I, 530IT, 540I, 740I, 740IL, 840CI and M3, the cruise control and throttle cable are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break causing the outer cable housing to separate from the bushing. Throttle pedal application without cruise control engagement could cause the outer tube to catch on the edge of the broken bushing resulting in the throttle valve remaining partially open. If this were to occur, the car might not decelerate as expected and a crash could occut. Correction: A spring clip will be installed on the outer tube of each cable to prevent dislodgment from the bushing.
Transport Canada9 de out. de 19971997173Anos-modelo 1994–1997Exibido no inglês original · tradução pendenteVer detalhes →
The condenser on affected vehicles may develop a leak due to contact corrosion (pitting) between the plate and the flat tubes. *tw
NHTSA · boletim do fabricante52199Anos-modelo 1993Exibido no inglês original · tradução pendenteVer detalhes →
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0).