Os boletins técnicos (TSB) são instruções de reparação que os fabricantes enviam aos concessionários sobre problemas conhecidos. Não são recalls de segurança, mas muitas vezes confirmam um defeito.
Due to an implementation error in various OBD diagnostics in the vehicle's control units, in very rare cases itmay happen that stored fault memory codes (DTCs) and the MIL (warning light) are not automaticallydeleted even though the underlying malfunction has already been rectified. This does not comply with the statutory OBD specifications.
NHTSA · boletim do fabricante11034449Anos-modelo 2025Exibido no inglês original · tradução pendenteVer detalhes →
When navigation is selected, only the start animation with the text Starting navigation system... isdisplayed. The Navigation application does not start. This only applies to vehicles where Navigation hasbeen enabled and has been verified to work previously.
NHTSA · boletim do fabricante11019572Anos-modelo 2025Exibido no inglês original · tradução pendenteVer detalhes →
There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.
NHTSA · boletim do fabricante11016472Anos-modelo 2020Exibido no inglês original · tradução pendenteVer detalhes →
Due to an installation error, the crankshaft sensor connector may not have been properly locked. In very rare cases, the plug connection may become disconnected. If no signal is sent by the crankshaftsensor, the engine will switch to emergency operation and a Check Control message will occur.
NHTSA · boletim do fabricante11008104Anos-modelo 2024Exibido no inglês original · tradução pendenteVer detalhes →
There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.
NHTSA · boletim do fabricante11006766Anos-modelo 2023Exibido no inglês original · tradução pendenteVer detalhes →
Please have the starter motor checked and, if necessary, replaced in the vehicles concerned (according tothe vehicle identification number selection) if possible before vehicle delivery. If vehicles have already been delivered, please have the measure carried out the next time the vehiclesenter the workshop. A bolting fault on the long bolt screws can cause the magnets in the starter motor to twist. As a result, thepower of the starter motor decreases. As a result, the engine does not start.
NHTSA · boletim do fabricante11006719Anos-modelo 2024Exibido no inglês original · tradução pendenteVer detalhes →
There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.
NHTSA · boletim do fabricante11002858Anos-modelo 2023Exibido no inglês original · tradução pendenteVer detalhes →
There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.
NHTSA · boletim do fabricante11000500Anos-modelo 2024Exibido no inglês original · tradução pendenteVer detalhes →
BMW Remote Software Upgrade (RSU) is not possible. The Remote Software Upgrade menu shows thefollowing text: A remote software upgrade and the activation of functions are not possible. Please contact your servicepartner to restore functionality. Additionally, certain purchased BMW ConnectedDrive Upgrades that require RSU for installation cannot be activated. After the purchase, the status of the upgrade displayed the CID remains In Activation.
NHTSA · boletim do fabricante10246221Anos-modelo 2024Exibido no inglês original · tradução pendenteVer detalhes →
Low Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full : The low washer fluid warning is illuminated even though the washer fluid reservoir is full. There are no faults stored in the system for the washer fluid level switch. A non-approved washer fluid was used that is silicone-based. Silicone-based fluids are not compatible with the contactless capacitive level sensor. Fluids that contain a silicone additive are normally colored other than blue.
NHTSA · boletim do fabricante10169468Anos-modelo 2019Exibido no inglês original · tradução pendenteVer detalhes →
HU-H3 MGU HEAD UNIT DOES NOT START CID REMAINS BLACK: If the ignition is briefly switched off and without the vehicle entering sleep mode the MGU (Media Graphics Unit) head unit does not start The CID display remains black.
NHTSA · boletim do fabricante10166391Anos-modelo 2019Exibido no inglês original · tradução pendenteVer detalhes →
ERRONEOUS FAULT 1F2505 IS STORED IN THE DME This Service Information bulletin replaces SI B12 30 18 dated November 2018. This fault does not cause any drivability complaints or engine warning lamps.
NHTSA · boletim do fabricante10163998Anos-modelo 2019Exibido no inglês original · tradução pendenteVer detalhes →
SERVICE ACTION: N63M ENGINES - CHECK AND REPLACE THE FRESH AIR INTAKE DUCT. The incorrect crankcase ventilation non return valves may have been installed in the vehicle. The engine malfunction indicator may be illuminated with FC 160509 pressure sensor crankcase signal: pressure implausible stored in the DME.
NHTSA · boletim do fabricante10160330Anos-modelo 2019Exibido no inglês original · tradução pendenteVer detalhes →
The Low Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full This Service Information bulletin supersedes SI B61 23 15 dated April 2016.
NHTSA · boletim do fabricante10160350Anos-modelo 2019Exibido no inglês original · tradução pendenteVer detalhes →
SERVICE ACTION: N63M ENGINES - CHECK AND REPLACE THE FRESH AIR INTAKE DUCT. The incorrect crankcase ventilation non return valves may have been installed in the vehicle. The engine malfunction indicator may be illuminated with FC 160509 pressure sensor crankcase signal: pressure implausible stored in the DME.
NHTSA · boletim do fabricante10160247Anos-modelo 2019Exibido no inglês original · tradução pendenteVer detalhes →
The Low Washer Fluid Warning Light is illuminated when the Washer Fluid Tank is Full This Service Information bulletin supersedes SI B61 23 15 dated April 2016.
NHTSA · boletim do fabricante10160267Anos-modelo 2019Exibido no inglês original · tradução pendenteVer detalhes →
In the event of an accident, the two-battery Dual Storage System (DSS) is disconnected from the electrical system via an internal relay. In some cases, the relay is stuck closed, and a fault is set. In these circumstances:
- A crash shutdown of the DSS does not occur.
- The power distribution box is supplied with power until the DSS is fully discharged.
After programming the vehicle via ISTA/RSUto I-level 26-03-5xx, customer may reportsome of the interior ambient lighting strips(arrows) may begin to fail sporadically after adeep sleep cycle. This concern is temporary and the interiorambient lighting will be restored on its ownafter the vehicle is locked/unlocked or colorselection setting is changed.
NHTSA · boletim do fabricante11037532Anos-modelo 2024Exibido no inglês original · tradução pendenteVer detalhes →
Potential customer complaints with no fault codes stored / No MIL displayed. 1. Rough idle after idling for a longer period of time 2. Vehicle feels like it is misfiring at idle The automatic Start/Stop function is deactivated. The vehicle is stopped and the engine runs at idle speed. After prolonged idle operation (approximately 30 to 50 seconds), a slight jolt or slight change in idlespeed may be noticeable. There are no relevant errors in the DME fault code memory. No mixture control error, no misfiring, no error relating to a relevant component of the drive system. Motor vehicles affected: 1. Only MHEVs (mild hybrid electric vehicle) with crankshaft-driven starter generator. 2. Only vehicles with optional equipment 01CE = recuperation system 3. Affected I-levels: I-level 24-07-500 or higher
NHTSA · boletim do fabricante11037505Anos-modelo 2024Exibido no inglês original · tradução pendenteVer detalhes →
After programming the vehicle via ISTA/RSUto I-level 26-03-5xx, some of the interiorambient lighting strips (arrows) may begin tofail sporadically after a deep sleep cycle.
NHTSA · boletim do fabricante11036381Anos-modelo 2024Exibido no inglês original · tradução pendenteVer detalhes →
Depois que o Módulo de Telemática (TCB2) entra em modo de suspensão, um gatilho do BMW Data Services para os Remote Services (partida remota do motor, travar/destravar, climatização) não consegue reativar o TCB2. Devido a esse problema, os Remote Services não funcionarão no veículo quando estacionado e trancado.
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).