Boletim
Buick: Recalibration of body control module (bcm) has been developed and reprogram, to lengthen life of stop and tail lamp bulb that burns out. *pe
🔔 Crie uma conta gratuita para receber alertas por e-mail sobre Buick Excelle GT (todas as gerações)
Os boletins técnicos (TSB) são instruções de reparação que os fabricantes enviam aos concessionários sobre problemas conhecidos. Não são recalls de segurança, mas muitas vezes confirmam um defeito.
Buick: Recalibration of body control module (bcm) has been developed and reprogram, to lengthen life of stop and tail lamp bulb that burns out. *pe
CSP-Windshield Water Leak
Este boletim preliminar fornece informações sobre uma possível condição normal de uma sensação de travamento no volante após longos períodos de condução.
This preliminary bulletin provides information on a possible normal condition for a sticking feel in steering wheel after drive for long periods.
13054 - Customer Satisfaction Program. The windshield may not be completely sealed to the body at the lower left side of the windshield. Water could leak into the vehicle at this point and drip onto the body harness connector, causing corrosion on the terminals or shorting between terminals. Depending on the terminal(s) involved, it could cause one or more of the following conditions: automatic OnStar emergency calls, flashing of the park brake light, rough engine operation, improper air conditioning system operation, illumination of the Service Engine Soon light, and other malfunctions. Dealers will perform a water test to detect a water leak. If a leak is found, dealers will reseal the area and perform another water test. If leaking is still present, the windshield will be reinstalled. If evidence of a leak is found, the connectors will be inspected to determine if any terminals are corroded. Corroded terminals will be replaced.
This Preliminary Information communication provides information to the technician about vehicles that have a water leak on the driver side floor. Vehicles also may have intermittent no fob detected, no crank no start, park brake light flashing, a rough running concern, Service Engine Soon light on, power locks locking on their own, Service Park Assist message. Technician should inspect the X200 for water intrusion or corrosion and replace any of the terminals that are corroded. If water intrusion is found inspect the windshield for voids in seam sealer and reseal the windshield.
Chevrolet/buick: Near center position, a stick/slip or notchy felling is felt in steering wheel, after making lane changes during a time on highway, due to overcoming an increase effort of residual friction inside steering gear. Model 2011-12 cruze, volt, 2012 verano. *pe
Buick: See document search button for owner letter. On some vehicles, corrosion on terminals or shorting between terminals is caused by water leaking into vehicle at this point, body at lower left side of windshield was not completely sealed, and dripped onto body harness connector. Terminals need to be replaced, windshield needs to be replaced, if necessary, after sealing and water testing and connectors inspected. Models 2012 verano. *pe
Velocímetro Indica 6% Acima no Painel
This preliminary information bulletin provides information regarding all the components that are included when ordering a new service 2.4L Ecotec engine.
This preliminary information bulletin provides information regarding all the components that are included when ordering a new service 2.4L Ecotec engine.
This preliminary informational bulletin provides repair information to correct a customer concern of poor radio hands-free voice recognition performance or sound quality after OnStar upgrade.
This preliminary information bulletin provides a procedure to inspect and tighten the clamps on the air duct due to the (SES) light on with DTCs P0171, P1101, and/or P0101 being set.
This preliminary information bulletin provides a procedure for replacement of the heated oxygen sensor to remove the (SES) light being on due to the heated oxygen sensor from coming into contact with the axle shaft.
This preliminary information bulletin provides a procedure for right side engine mount replacement due to an engine mount that is not dampening the engine/suspension vibrations as designed to eliminate a hollow or knocking noise at low speeds.
This Preliminary Information communication provides information to the technician about vehicles that have a squeak, scrape, or rub-type noise coming from the seat area during a clutch pedal apply. Technician will apply anti-itch tape between the seat cover and outboard trim panel.
This preliminary informational bulletin provides information on poor radio hands-free voice recognition performance or sound quality after the onstar upgrade.
Summary to be provided on a future date.
Summary to be provided on a future date.
Summary to be provided on a future date.
Summary to be provided on a future date.
Summary to be provided on a future date.
Summary to be provided on a future date.
Summary to be provided on a future date.
Summary to be provided on a future date.
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).