Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

BuickBuick Roadmaster

1991–1996 · 1 gerações · 11 defeitos documentados · 1 mercados
Gerações
Todas as geraçõesVIII1991–199611209
Ano do modelo
MercadoTodosNA
RecallCríticoSuspensãoNA

Suspensão

As porcas das rodas destes veículos podem não ter sido apertadas conforme as especificações durante a montagem. Isto pode resultar na fratura dos pinos das rodas, o que pode fazer com que a roda se separe do veículo. Se isto acontecer enquanto o veículo está em movimento, pode ocorrer uma colisão sem aviso prévio. Correção: As porcas das rodas serão apertadas conforme as especificações.

Transport Canada13 de dez. de 19961996205Anos-modelo 1996Traduzido automaticamente · original: inglêsVer detalhes →
RecallCríticoSuspensãoNA

Wheels:Lugs/nuts/bolts/studs

The wheel lug nuts were not tightened to the proper specification during assembly.

NHTSA · Estados Unidos10 de dez. de 199696V245000Anos-modelo 1995–1996Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoMotorNA

Fuel System

The fuel tank attachment strap fasteners are below the specified torque. These loose fasteners could, in time, become completely detached. This could allow the fuel tank to sag down to the point of striking something in the road or the road surface resulting in a possible fuel leak and an under-vehicle fire. Correction: Fuel tank strap fasteners will be torqued to the proper specifications.

Transport Canada3 de nov. de 19941994170Anos-modelo 1994Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoMotorNA

Fuel system, gasoline:Storage:Tank assembly:Mounting

The fuel tank attachment strap fasteners were not properly tightened. The fasteners can completely detach, eventually allowing the fuel tank to sag and the bottom of the tank to strike the roadway.

NHTSA · Estados Unidos25 de out. de 199494V210000Anos-modelo 1994Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoSuspensãoNA

Wheels:Lugs/nuts/bolts/studs

Paint on the wheel mounting surfaces can act as a shim between the wheel and the rotor/drum. As the vehicle is driven, the wheel imbeds into the paint, loosening the lug nut and causing a loss of clamp load.

NHTSA · Estados Unidos16 de abr. de 199494V076000Anos-modelo 1994Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoMotorNA

Engine

On certain vehicles, the engine oil cooler inlet hose may contact the steering gear and wear through. This could allow engine oil to leak onto hot engine components and cause an engine compartment fire. Correction: Oil cooler hose will be repositioned and inspected. If wear is evident, the hose will be replaced.

Transport Canada25 de mar. de 19941994064Anos-modelo 1994Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoMotorNA

Engine and engine cooling:Cooling system:Hoses/lines/piping/fittings

The engine oil cooler inlet hose may have been installed too close to the steering gear causing chafing. The chafing can eventually wear through the hose's protective sleeve resulting in engine oil leaking onto the engine.

NHTSA · Estados Unidos21 de mar. de 199494V049000Anos-modelo 1994Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoFreiosNA

Travões

O modulador ABS pode corroer e libertar fluido do circuito de travão dianteiro. A fuga de fluido dos travões pode reduzir a eficácia dos travões e aumentar as distâncias de travagem. Isto pode resultar num acidente sem aviso prévio. Correção: Os concessionários vão remover a corrosão existente do modulador ABS e instalar um kit para prevenir corrosão futura.

Transport Canada11 de dez. de 19971997219Anos-modelo 1992Traduzido automaticamente · original: inglêsVer detalhes →
RecallModeradoSuspensãoNA

Suspension

Note: Includes caprice police sedans, taxi cabs and special service wagons; fleetwood hearse and limousine. The lower control arm ball joint attachment may be loose. This condition can cause the lower control arm ball joint to loosen, fatigue and separate from the front suspension knuckle. If separation were to occur with the vehicle in motion, loss of vehicle control could occur, which could result in a vehicle crash. Correction: Front lower control arm ball joint attachment nuts will be inspected for proper torque. If the ball joint has loosened from the knuckle, both the ball joint and knuckle will be replaced.

Transport Canada12 de fev. de 19961996025Anos-modelo 1995–1996Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoSuspensãoNA

Suspension:Front:Control arm:Lower ball joint

Defective lower control arm ball joint attachment nuts were not properly torqued and can loosen.

NHTSA · Estados Unidos30 de jan. de 199696V019000Anos-modelo 1994–1995Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoCarroceriaNA

Structure

These vehicles do not comply with c.M.V.S.S. 102 - transmission shift control sequence. A misadjusted transmission shift control linkage may allow the transmission to be shifted out of the "p"(park) position with the ignition key removed. In the event of this condition occurring, the vehicle may roll from its parked position and cause potential damage and/or injury. Correction: Shift control linkage system will be adjusted.

Transport Canada29 de nov. de 19951995211Anos-modelo 1995Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoCâmbioNA

Power train:Automatic transmission

These vehicles were produced with an improperly adjusted transmission shift control linkage. This does not meet with the requirements of fmvss no. 114, "theft protection."

NHTSA · Estados Unidos16 de nov. de 199595V221000Anos-modelo 1995Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoMotorNA

Engine

Certain vehicles do not comply with CMVSS 124 - Accelerator Control Systems. At low temperatures there may be excessive movement friction in the accelerator pedal assembly. In the event of a failure of a throttle return spring the engine speed may not decrease to the level anticipated by the driver when the foot is lifted from the accelerator pedal. Loss of accelerator control could result in a vehicle crash without prior warning. Correction: Accelerator pedal assembly will be replaced.

Transport Canada24 de abr. de 19951995074Anos-modelo 1994–1995Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoMotorNA

Vehicle speed control:Springs

These vehicles fail to conform to fmvss no. 124, "accelerator control systems." at low temperatures, excessive friction can occur in the accelerator pedal assembly.

NHTSA · Estados Unidos24 de abr. de 199595V082000Anos-modelo 1994–1995Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoInteriorNA

Seat belts

The shoulder belt guide loop plastic covering may crack and expose the steel sub-plate.

NHTSA · Estados Unidos1 de jul. de 199292V094000Anos-modelo 1991–1992Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoInteriorNA

Seats And Restraints

Note: 1991 caprice sedans and wagons and roadmaster wagons and 1992 roadmaster sedans. The shoulder belt guide loop plastic covering may crack and expose the steel sub-plate. In the event of a severe vehicle crash, the exposed steel sub-plate may cut the safety belt webbing and result in an increased possibility and/or severity of injury to the affected seat occupant. Correction: New shoulder belt guide loops will be installed on involved vehicles.

Transport Canada29 de jun. de 19921992076Anos-modelo 1991–1992Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoCarroceriaNA

Structure

The secondary hood latches on these vehicles can corrode causing a very high latch release effort and possibly preventing the hood from latching properly when it is closed. If the secondary hood latch is not properly engaged the hood could open unexpectedly. If this were to occur while the vehicle was in motion, the driver's forward vision would be impaired possibly resulting in a vehicle crash. Correction: A new scondary hood latch assembly with improved corrosion resistance will be installed on affected vehicles.

Transport Canada31 de out. de 19911991147Anos-modelo 1991–1992Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoCarroceriaNA

Latches/locks/linkages:Hood:Latch

Secondary hood latch assemblies can corrode, causing a high latch release effort and possibly preventing the hood from latching properly when it is closed.

NHTSA · Estados Unidos29 de out. de 199191V186000Anos-modelo 1991–1992Exibido no inglês original · tradução pendenteVer detalhes →
RecallLeveInteriorNA

Air bags

These vehicles were shipped with both the supplemental inflatable restraint caution label and a roof rack caution label installed on the same side of the sun visor. This does not meet the requirements of fmvss no.208, "occupant crash protection."

NHTSA · Estados Unidos3 de nov. de 199595V215000Anos-modelo 1995–1996Exibido no inglês original · tradução pendenteVer detalhes →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0).