Fuel system, gasoline:Storage:Tank assembly
A fuel tank leak could occur due to small creases on the tank underside cracking during pressure cycling which occurs during normal operation.
🔔 Crie uma conta gratuita para receber alertas por e-mail sobre Buick Skyhawk (todas as gerações)
A fuel tank leak could occur due to small creases on the tank underside cracking during pressure cycling which occurs during normal operation.
As mangueiras e/ou tubulações de alimentação e retorno de combustível podem rachar ou se separar, permitindo que o combustível vaze para a área do cofre do motor.
On vehicles with 2.0l engines, the fuel feed and return hose assemblies may have been manufactured with improperly crimped fittings.A hose assembly with this condition may crack or separate from the fittng, allowing fuel to leak in the underhood area. This could result in an underhood fire. Correction:Hose assemblies will be replaced.
The engine air cleaner plastic trim cover could fall off the air cleaner assembly and land on the exhaust manifold creating a fire hazard. Consequence of defect: If the car is being operated at the time that the plastic trim cover falls off, an engine compartment fire could occur without warning.
The brake proportioner valves may break and separate from the master cylinder during braking. This will result in a loss of brake fluid and a partial loss of braking action
Possible fuel leakage could occur at the throttle body injection fuel feed pipe connection on the involved vehicles.
Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. The fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. Leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full.
Under certain conditions the hose clamps on the fuel filler pipe and fuel tank filler vent pipe could fracture. This could cause seepage of fuel at any one of the four pipe to hose connections when the fuel tank is above 3/4 full creating the possibility of fire.
A corrosão interna do conjunto da válvula de retenção do Pulsair pode permitir que os gases de escape derretam a válvula de corte de plástico e arrastem peças da válvula para o filtro de ar e para o corpo da borboleta.
Em veículos com assento do motorista de ajuste manual, a barra de ancoragem do assoalho metálico pode sofrer fadiga e se romper próximo ao pino de ajuste externo dianteiro esquerdo do assento. Isso pode permitir que o pino se separe da barra de ancoragem e faça o assento do motorista inclinar-se inesperadamente para trás, resultando em possível perda de controle e colisão do veículo, sem aviso prévio. Correção: Será instalado um suporte de reforço na barra de ancoragem do assoalho.
The metal floor pan anchor bar could fatigue and break around the left front outer seat adjuster stud of the drivers seat, allowing the stud to separate from the floor pan anchor bar.
Parking brake lever mechanisms may not properly engage when applied as required by fmvss 105. Consequence of defect: Vehicle could unexpectedly roll away uncontrolled, which could result in a vehicle crash.
These vehicles do not comply with c.M.V.S.S.108 - lighting equipment. Buick skyhawk custom 2 and 4 door sedans and limited 4 door sedans.
Incorrect tail lamp lens were installed, lens do not conform to fmvss 108, lamp reflective device and associated equipment. Consequence of defect: In times of reduced visibility, an approaching vehicle may not be aware of this vehicle which could result in a vehicle crash without prior warning.
On certain vehicles, the front seat back locks may not lock under forward load conditions and are therefore not in compliance with CMVSS 207 - Seat Anchorages.
Some vehicles have bucket seat back locks that do not conform to federal motor vehicle safety standard 207, anchorage of seats. In event of a crash, the seat back lock may not function.
The brake proportioner valves may break and separate from the master cylinder. This would allow brake fluid to leak and would result in a partial loss of the brake system.
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).