Vehicle description: Passenger vehicles equipped with bi-fuel compressed natural gas (cng) vehicles. The cng fuel line and the cng high pressure regulator coolant lines can contact other fuel (gasoline) and brake lines on the vehicle. Abrasion from contact can cause a leak in the brake pipe, fuel pipe, or both.
NHTSA · Estados Unidos28 de fev. de 200000V053000Anos-modelo 1998Exibido no inglês original · tradução pendenteVer detalhes →
Small creases on the underside of the fuel tank may fatigue and crack resulting in a fuel leak. If the leak is undetected and there is an external source of ignition, a fire could result. Correction: Vehicles will be inspected and fuel tanks replaced as required.
Transport Canada20 de jan. de 19891989011Anos-modelo 1989Exibido no inglês original · tradução pendenteVer detalhes →
Note: Certain 1997-99 vehicles in Ontario, Quebec and the Atlantic provinces and 1995-99 vehicles in all other provinces and territories. Moisture may enter the Powertrain Control Module (PCM) as a result of corrosion after extended exposure to road salt. This can lead to symptoms including illumination of the "Check Engine" light or the engine running rough. If these symptoms are ignored the engine may stall and may not be able to be restarted. Correction: Dealers will seal the Powertrain Control Module (PCM) in a protective shield/cover assembly.
Transport Canada28 de abr. de 20002000109Anos-modelo 1995–1999Exibido no inglês original · tradução pendenteVer detalhes →
On certain vehicles located in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland, Moisture entering the Powertrain Control Module (PCM) as a result of corrosion can cause illumination of the "Check Engine" light or cause the engine to run rough. If these symptoms are ignored, the engine may stall and may not be able to be restarted. Correction: Dealers will inspect, clean and/or replace the Powertrain Control Module (PCM), then seal the PCM in a protective shield/cover assembly.
Transport Canada15 de fev. de 19991999016Anos-modelo 1995–1996Exibido no inglês original · tradução pendenteVer detalhes →
Certain vehicles may not comply with CMVSS 1105 - Evaporative Emissions. Fuel injectors may exhibit leakage of fuel vapour due to a stress of the plastic encapsulant. Correction: fuel injectors on affected vehicles will be inspected for involved date codes and replaced if necessary.
Transport Canada20 de jun. de 19961996094Anos-modelo 1996Exibido no inglês original · tradução pendenteVer detalhes →
The accelerator control cable could have been kinked during assembly causing high accelerator pedal effort, sticking accelerator control cable, or a broken accelerator control cable.
NHTSA · Estados Unidos23 de out. de 199595V201000Anos-modelo 1996Exibido no inglês original · tradução pendenteVer detalhes →
The accelerator control cable may have been damaged (kinked) during vehicle assembly. A kinked accelerator control cable may result in high pedal effort, sticking cable, or broken cable. If the accelerator control cable sticks or breaks, unwanted acceleration and/or loss of throttle control may result. If this were to occur while the vehicle was in motion, a crash could occur without prior warning. Correction: Dealers will replace the accelerator control cable assembly.
Transport Canada20 de out. de 19951995188Anos-modelo 1996Exibido no inglês original · tradução pendenteVer detalhes →
Accelerator control cable may contain water which could freeze while vehicle is parked causing travel of accelerator control cable to become restricted when throttle is initially opened.
NHTSA · Estados Unidos9 de fev. de 198787V011000Anos-modelo 1987Exibido no inglês original · tradução pendenteVer detalhes →
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).