Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

Honda Prelude

1978– · 6 gerações · 16 defeitos documentados · 1 mercados
Gerações
Ano do modelo
Prelude II · 1982–1987Prelude III · 1987–1991
RecallCríticoMotorNA

Fuel system, gasoline

If the plastic coating of the fuel filler and/or breather pipe is damaged, salt water may accumulate between the plastic coating and the steel pipes, and the accumulation could cause corrosion which would eventually rust through the affected pipes, allowing gasoline fumes and fuel to leak.

NHTSA · Estados Unidos15 de abr. de 199392V028001Anos-modelo 1983–1987Exibido no inglês original · tradução pendenteVer detalhes →
Prelude II · 1982–1987Prelude III · 1987–1991
RecallCríticoMotorNA

Fuel System

On certain vehicles, road salt may cause the fuel filler and/or breather pipe to rust through, resulting in fuel leakage. In the presence of an igntion source a vehicle fire could occur. Correction: Vehicles will be inspected and repaired if necessary.

Transport Canada6 de mar. de 19921992025Anos-modelo 1983–1987Exibido no inglês original · tradução pendenteVer detalhes →
Prelude I · 1978–1982
RecallModeradoMotorUK

Interruptor de ignição pode falhar

Os contatos elétricos no interior do interruptor de ignição sofrem desgaste prematuro. Com o tempo, isso pode fazer com que o motor pare repentinamente, sem aviso.

DVSA · Reino Unido6 de ago. de 2002R/2002/071Traduzido automaticamente · original: inglêsVer detalhes →
Prelude V · 1996–2001
RecallModeradoMotorJP

始動装置

原動機の始動装置において、イグニッションスイッチの接点部に流れる電流値が大きい ため、主電源を入れる瞬間に大きなアーク放電が生じ、始動操作の繰り返しにより接点が 過度に摩耗して接触圧力が低下するため、走行時の振動等で接点が動き、炭化物に乗り上 げ導通不良となることがあり、最悪の場合、突然原動機が停止するおそれがある。 なお、始動操作で、接点が摺動し炭化物を除去するため、再始動は可能である。

MLIT · Japão24 de mai. de 20021108420Anos-modelo 1996–1999Exibido no japonês original · tradução pendenteVer detalhes →
Prelude IV · 1991–1996
RecallModeradoMotorJP

Motor principal

Em motores, se a instrução de montagem do retentor de óleo do eixo balanceador estiver inadequada, continuar usando o veículo nesse estado pode reduzir a força de retenção do retentor e, no pior caso, o retentor pode sair de sua posição, causando vazamento de óleo do motor.

MLIT · Japão19 de set. de 20001106710Anos-modelo 1993–1995Traduzido automaticamente · original: japonêsVer detalhes →
Prelude III · 1987–1991
RecallModeradoMotorNA

Engine

On certain vehicles, the accelerator pedal stopper may be bent when excessive downward force is applied after the pedal has contacted the stopper. In the worst case, the edge of the pedal can be caught and held down by the bent stopper. This could result in loss of vehicle control and a crash without prior warning. Correction: A support will be installed to prevent the stopper from bending.

Transport Canada12 de jun. de 19891989085Anos-modelo 1988Exibido no inglês original · tradução pendenteVer detalhes →
Prelude III · 1987–1991
RecallModeradoMotorNA

Engine

On certain Prelude SI vehicles, throttle body castings may contain slight porosity. During vehicle usage, coolant seepage may occur and eventually residue may accumulate on the throttle valve. The residue could cause the throttle valve to return slowly from the slightly open position to the idle position when the accelerator pedal is released. Correction: The throttle body assembly will be replaced.

Transport Canada5 de ago. de 19871987080Anos-modelo 1988Exibido no inglês original · tradução pendenteVer detalhes →
Prelude III · 1987–1991
RecallModeradoMotorNA

Vehicle speed control

A small amount of coolant seepage may occur, and eventually residue may accumulate on the throttle valve.

NHTSA · Estados Unidos4 de ago. de 198787V122000Anos-modelo 1988Exibido no inglês original · tradução pendenteVer detalhes →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).