Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

IsuzuIsuzu Ascender

2002–2008 · 1 gerações · 7 defeitos documentados · 1 mercados
Gerações
Todas as geraçõesAscender2002–200871250

Os boletins técnicos (TSB) são instruções de reparação que os fabricantes enviam aos concessionários sobre problemas conhecidos. Não são recalls de segurança, mas muitas vezes confirmam um defeito.

Ano do modelo
MercadoTodosNA
BoletimModeradoCarroceriaNA

Boletim

Isuzu diesel engines available in the above affected vehicles meet the california air resource board's (carb) optional idling emissions standard of 30 grams per hour of oxides of nitrogen (nox) with no increase in the emission of other regulated pollutants. As a result these vehicles have been approved as "certified clean idle" and are "exempt" from the engine shutdown system (ess) requiremnet pursuant ot section 1956.8 of title 13, california code of regulations. As required by the ess regulation, for "certificed clean idle" vehicles, isuzu has introduced a tamper resistance "certified clean idle" label located on the driver's side door panel. It is important that this label remain, permanently, on the vehicle to identify it as "certified clean idle." carb requires this label as evidence that, at hte time of manufacture, the engine installed met the applicable emission standards. Should the label be found missing or damged during an inspection, a citation and penalties may be issued. If the vehicle is operated in california with a damaged or missing clean idle label, isuzu recommends vehicle operators follow the 5 minute ess requirement by manually turning off the engine. Following this ess requiremnet will keep the vehicle operation compliant until a replacement label can be installed. "clean air idle" labels are printed with a serial number and registered to an individual vin. As a result, a replacemnet label will also include a new serial number which must be registered to the vehicle's vin by the manufacturer. The below information is provided to assit in acquiring, replacing and registering a replacement label.

NHTSA · boletim do fabricante10178754Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
BoletimModeradoCâmbioNA

Boletim

This Preliminary Information communication provides information to the technician with the axel setup information from American Axle Manufacturing. Technician should be advised that the maximum pinion shim to be used or stacked behind the pinion is 0.050?, and the minimum pinion shim is 0.020? for an 8.6 axle. The range for available pinion depth shims for the 10.5? axle is 0.006? to 0.024?. When setting the backlash it should be set between 0.003? to 0.005? on a new ring and pinion for any American Axle Manufacturing application. The ring and pinion can be reused or adjusted if the mileage is less than 500 miles, if not used for towing. Technician should be advised that a ?roller coaster? or ?hourglass? pattern on the bearings may be normal up to 10,000 miles and possibly longer. With a mis-machined housing you may get a heel pattern on both sides of the gear teeth at build up can generally be corrected with backlash adjustments. When setting up an 8.6? axle with a 5 cut gear set is to use a 0.035? pinion shim and set backlash to 0.004?. When using the newer 2 cut gear set also use a 0.035? pinion shim and still set backlash to 0.004?. To set the gear pattern use backlash to adjust the pattern heel to toe. Use the pinion shim to adjust the height of the pattern. The proper drive pinion bearing pre-load is from 15 - 30 inch pounds with new bearings. The total torque to turn after the differential case is installed should increase 5 - 10 inch pounds at the pinion. A new pinion nut must be used whenever the old one is removed. The axle shaft end play specification is 0.012? per side and the radial specification is 0.002? - 0.003?. Technician should be advised that synthetic lube can be used in all new American Axle Manufacturing axle assemblies. The new pinion seal for the 8.6? axle assembly is a two piece design.

NHTSA · boletim do fabricante10112600Anos-modelo 2004Exibido no inglês original · tradução pendenteVer detalhes →
BoletimModeradoInteriorNA

Boletim

Airbag light on, passenger airbag status indicator reads off, dtc b0092. *kb

NHTSA · boletim do fabricante10022540Anos-modelo 2007Exibido no inglês original · tradução pendenteVer detalhes →
BoletimModeradoCâmbioNA

Boletim

4l60-e automatic transmission fluid leak from oil pump or bell housing area. *kb

NHTSA · boletim do fabricante10020537Anos-modelo 2006Exibido no inglês original · tradução pendenteVer detalhes →
BoletimModeradoSuspensãoNA

Boletim

Revised steering wheel replacement procedure (service manual revision). *tt

NHTSA · boletim do fabricante10006663Anos-modelo 2003Exibido no inglês original · tradução pendenteVer detalhes →
BoletimModeradoOutroNA

Boletim

Intermittent hesitation, stumble or idle stall after soak, harsh 1-2 shift, slipping 1-2 shift followed by a harsh engagement. *tt

NHTSA · boletim do fabricante10006094Anos-modelo 2003Exibido no inglês original · tradução pendenteVer detalhes →
BoletimModeradoSuspensãoNA

Boletim

Revised steering wheel replacement procedure. *tt

NHTSA · boletim do fabricante10005165Anos-modelo 2003Exibido no inglês original · tradução pendenteVer detalhes →
BoletimModeradoSuspensãoNA

Boletim

Squeak noise coming from the steering column while turning the steering wheel. *tt

NHTSA · boletim do fabricante10001769Anos-modelo 2003Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveOutroNA

Boletim

Policies and procedures update for all commercial vehicles. This bulletin provides instructions with regard to the Isuzu Commercial Vehicle (CV) Warranty Parts Center on the topics of parts retention, parts preparation for shipping, and administration.

NHTSA · boletim do fabricante10243651Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveElétricaNA

Boletim

This technical bulletin provides a procedure to clear the codes and re-evaluate the XM radio channels to correct a condition of audio muting when listening to some Sirius XM channels but if they change channels they will find others that experience normal audio. This could be due to interference from transmitting sources outside of Sirius XM?s frequency range.

NHTSA · boletim do fabricante10139099Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveOutroNA

Boletim

This informational bulletin is a revision for 10-00-89-005B to add the 2014 model year and labor codes.

NHTSA · boletim do fabricante10139026Anos-modelo 2008Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveElétricaNA

Boletim

This technical bulletin provides a procedure to clear the codes and re-evaluate the XM radio channels to correct a condition of audio muting when listening to some Sirius XM channels but if they change channels they will find others that experience normal audio. This could be due to interference from transmitting sources outside of Sirius XM?s frequency range.

NHTSA · boletim do fabricante10135290Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveOutroNA

Boletim

This informational bulletin provides Information Regarding Servicing Components Located Near SIR Components and how to properly disable the SIR system for repairs at or near

NHTSA · boletim do fabricante10116912Anos-modelo 2009Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveMotorNA

Boletim

This informational bulletin provides dealership personnel with information on flexible fuel vehicles (FFVs) and the usage of E85 fuel in GM vehicles.

NHTSA · boletim do fabricante10113662Anos-modelo 2003Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveMotorNA

Boletim

Isuzu: 2008 ascender. It may develop a crack in the exhaust manifold which will cause increased exhaust noise. *rm

NHTSA · boletim do fabricante10041391Anos-modelo 2008Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveElétricaNA

Boletim

Izuzu: 2006 ascender. The malfunction light won't turn on when there is a fault in the air injector system. *rm

NHTSA · boletim do fabricante10039116Anos-modelo 2006Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveOutroNA

Boletim

Pass-thru programming only for 2008 model year. *nj

NHTSA · boletim do fabricante10022919Anos-modelo 2008Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveOutroNA

Boletim

Product enhancement for inventory and customer vehicles - obd system improvement. *kb

NHTSA · boletim do fabricante10022538Anos-modelo 2006Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveCâmbioNA

Boletim

Malfunction indicator lamp (mil) on, diagnostic trouble code (dtc) p0894, harsh 1-2 shift with 4l60-e auto transmission. *kb

NHTSA · boletim do fabricante10021354Anos-modelo 2006Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveElétricaNA

Boletim

Service update for inventory and customer vehicles fuel sending unit port fracture-extended starts/sluggish acceleration/check engine light-expires with base warranty. *kb

NHTSA · boletim do fabricante10021202Anos-modelo 2007Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveMotorNA

Boletim

Reduced engine power mil illuminated. *kb

NHTSA · boletim do fabricante10021196Anos-modelo 2006Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveElétricaNA

Boletim

Malfunction indicator lamp illuminated with engine cooling fan system performance dtc p0483 currently set or stored in history. *kb

NHTSA · boletim do fabricante10020538Anos-modelo 2007Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveCâmbioNA

Boletim

Product enhancement for inventory vehicles only engine/powertrain control module reprogram. *kb

NHTSA · boletim do fabricante10020535Anos-modelo 2007Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveCâmbioNA

Boletim

Oil life monitoring system - powertrain control module (pcm) reset. *tt

NHTSA · boletim do fabricante10016591Anos-modelo 2004Exibido no inglês original · tradução pendenteVer detalhes →
BoletimLeveElétricaNA

Boletim

Onstar system inoperative onstar system status light is red radio locked in phone mode or dtc b1000. *eh

NHTSA · boletim do fabricante10014832Anos-modelo 2003Exibido no inglês original · tradução pendenteVer detalhes →
Mais antigos →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).