Se o aquecedor cerâmico for usado na potência máxima por um período prolongado, o terminal do aquecedor pode queimar. Embora não tenha havido incêndios até o momento, existe uma possibilidade muito remota de que ocorra combustão.
DVSA · Reino Unido30 de jun. de 2005R/2004/195Traduzido automaticamente · original: inglêsVer detalhes →
On certain vehicles equipped with 4WD and torque-on-demand automatic transmission, in certain high speed frontal crashes, relative movement and abrasion of internal components can cause the potential for fuel leakage due to separation of the fuel hose and fuel line or a severed fuel hose. Correction: Dealers will install a revised fuel hose.
Transport Canada29 de jan. de 20012001015Anos-modelo 2000–2001Exibido no inglês original · tradução pendenteVer detalhes →
Vehicle description: Sport utility vehicles equipped with 4-wheel drive and automatic transmissions built with tod (torque-on-demand). In certain high speed, frontal crashes, movement of engine compartment components can cause the potential for fuel leakage.
NHTSA · Estados Unidos14 de nov. de 200000V376000Anos-modelo 2000–2001Exibido no inglês original · tradução pendenteVer detalhes →
Vehicle description: Sport utility vehicles equipped with 4-wheel drive and automatic transmissions built with tod (torque-on-demand). In certain high speed frontal crashes, an interior fuel line and fuel hose can be separated, allowing fuel to leak.
NHTSA · Estados Unidos7 de set. de 200000V253000Anos-modelo 2000Exibido no inglês original · tradução pendenteVer detalhes →
Vehicles with 3.2 litre engines may experience dislodging of the camshaft end plug(s) from the cylinder heads causing rapid oil loss. Oil spilling on the exhaust system could result in an engine compartment fire. Correction: A camshaft end plug retaining plate kit will be installed on affected vehicles.
Transport Canada29 de jul. de 19941994124Anos-modelo 1992–1994Exibido no inglês original · tradução pendenteVer detalhes →
Constant expansion and contraction of the cylinder head causes the camshaft seal end plug can become dislodged from the cylinder head. This allows oil to leak from the camshaft.
NHTSA · Estados Unidos19 de jul. de 199494V132000Anos-modelo 1992–1994Exibido no inglês original · tradução pendenteVer detalhes →
Nota: Veículos equipados com motor V6 e transmissão automática. A vareta de nível da transmissão automática deve ser corretamente recolocada após a verificação do nível do fluido. Se a vareta não estiver travada, o fluido da transmissão automática que vazar poderá entrar em contato com o coletor de escape e causar um incêndio no compartimento do motor. Correção: Uma etiqueta de advertência será instalada na tampa da vareta para servir como lembrete de sempre travar a vareta após verificar o nível do fluido e de não encher demais a transmissão automática com fluido.
Transport Canada22 de set. de 19931993133Anos-modelo 1990–1991Traduzido automaticamente · original: inglêsVer detalhes →
Due to insufficient clearance between a bolt that fixes the heater to the vehicle body and a fuel delivery pipe and between a rear heater hose clip, use under servere conditions could cause pipe rupture and fuel leakage.
NHTSA · Estados Unidos4 de dez. de 198989V001000Anos-modelo 1987–1988Exibido no inglês original · tradução pendenteVer detalhes →
It is possible that the internal contact resistance of the crimped joints for the grounding between the throttle position sensor (TPS) and engine control module may increase due to engine vibration. This can lead to an increased TPS voltage output which could lead to an increase in engine revolutions whilst at idle without any throttle input.
DVSA · Reino Unido15 de jan. de 2012R/2011/154Anos-modelo 1993–2003Exibido no inglês original · tradução pendenteVer detalhes →
Due to excessive clearance within the fuel injectors fuel may leak into the cylinder bores and then into the sump causing engine oil dilution. If this situation is ignored engine damage can occur additionally the engine revs may show an unintentional increase.
DVSA · Reino Unido3 de mar. de 2006R/2005/179Anos-modelo 1998–2003Exibido no inglês original · tradução pendenteVer detalhes →
On certain vehicles, after approximately nine or more years of use, the accelerator cable cover in the subject vehicles may deteriorate causing the cable rubber boot to adhere to the inner throttle cable. This can cause the accelerator cable to delay RPM and vehicle speed reduction for several seconds after the accelerator pedal is released, which, in turn, can lead to a crash. Correction: Dealer will replace the throttle cable rubber boot.
Transport Canada23 de abr. de 20042004144Anos-modelo 1992–1995Exibido no inglês original · tradução pendenteVer detalhes →
On certain sport utility vehicles, the accelerator cable can stick so that the engine speed will not immediately decrease upon release of the accelerator pedal.
NHTSA · Estados Unidos22 de abr. de 200404V199000Anos-modelo 1992–1995Exibido no inglês original · tradução pendenteVer detalhes →
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).