Ball joint failures (US safety investigation)
NHTSA, the US road safety agency, opened a preliminary evaluation (PE89155) into this problem on 15 August 1989 for 1988 models; it was closed on 9 January 1990 without a recall.
🔔 Crie uma conta gratuita para receber alertas por e-mail sobre Isuzu Impulse I
Este dossiê reúne os defeitos conhecidos do Isuzu Impulse I, escritos e documentados pela comunidade. A leitura é livre; uma conta gratuita permite contribuir. Um defeito recebe o selo quando colaboradores reconhecidos suficientes o validam.
NHTSA, the US road safety agency, opened a preliminary evaluation (PE89155) into this problem on 15 August 1989 for 1988 models; it was closed on 9 January 1990 without a recall.
THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.
The steering wheel center hub can fracture during certain frontal and near frontal vehicle collisions.
The clearance between the brake line at the rear axle and fuel tank retaining band is not wide enough and allows the line to contact the band during severe operating conditions. Continued contact may cause the damaged brake line to restrict the flow of brake fluid, or rupture, resulting in loss of brake fluid. Consequence of defect: Loss of brake fluid or restriction of brake fluid flow results in loss of braking ability of rear wheel which could cause an accident.
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0).