Este dossiê reúne os defeitos conhecidos do Jeep Liberty, escritos e documentados pela comunidade. A leitura é livre; uma conta gratuita permite contribuir. Um defeito recebe o selo quando colaboradores reconhecidos suficientes o validam.
Os proprietários relatam muitas vezes problemas de suspension neste carro (1673 queixas), mas ninguém explicou ainda a causa. Sabe qual é?Redigir a ficha
Os proprietários relatam muitas vezes problemas de airbags neste carro (1044 queixas), mas ninguém explicou ainda a causa. Sabe qual é?Redigir a ficha
1,673 owners in the United States reported problems with the suspension of this car to NHTSA (model years 2001–2006), typically at around 61,000 miles. Most often named: front:control arm:lower ball joint (55%). Reported consequences: 117 crashes, 5 fires, 105 injuries, 6 deaths.
✓ Análise Mecafile de dados oficiais2001–2006Exibido no inglês original · tradução pendenteVer detalhes →
1,044 owners in the United States reported problems with the airbags of this car to NHTSA (model years 2001–2005), typically at around 111,000 miles. Reported consequences: 250 crashes, 6 fires, 341 injuries, 10 deaths.
✓ Análise Mecafile de dados oficiais2001–2005Exibido no inglês original · tradução pendenteVer detalhes →
352 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2001–2006), typically at around 86,000 miles. Reported consequences: 6 crashes, 32 fires, 7 injuries, 1 death.
✓ Análise Mecafile de dados oficiais2001–2006Exibido no inglês original · tradução pendenteVer detalhes →
The rear lower control arms may experience excessive corrosion eventually resulting in a fracture A fractured rear control arm could cause reduced vehicle control and can cause a vehicle crash without prior warning
DVSA · Reino Unido24 de ago. de 2018R/2018/202Anos-modelo 2003–2006Exibido no inglês original · tradução pendenteVer detalhes →
Transmission Kit with Torque Converter 1. All Promaster (VF) 3.6L/62TE equipped vehicles. If the transmission bracket to the transmission case fasteners are removed during servicing, the fasteners (Part Number 06511385A$) are one-time usage. Vehicles built prior to 10/23/2015 requires Service Kit PN 68461214AA; includes Transmission Isolator PN 68264483AA, and Adaptation Bracket 68264479AA and Fastener Service Kit PN 68329056AA Vehicles built after on or after 10/23/2015 will require only the Fastener Service Kit PN 68329056AA. 2. All 3.6L/62TE equipped vehicles. If the vehicle you are repairing has a crack in the flex plate or failed pump bushing inspect and confirm that both (2) dowel pins are present in the engine block, which align the transmission center line to the crank shaft centerline and visually inspect the dowel alignment holes in the transmission case. If the holes are damaged or elongated the transmission should be replaced to prevent further damage to the transmission/flexplate or pump bushing due to the inability to properly align the engine to the transmission during the repair. 3. All 62TE equipped vehicles. If pump bushing is scored or damaged and the dowel pin alignment holes are ok, replace the pump assembly as opposed to complete transmission. 4. All 62TE equipped vehicles. If vehicle is jerking/slipping with MIL code(s) P0740 or P2764, check TCC Solenoid operation. If TCC Solenoid is ok, the codes are indicative of a torque converter failure. Replace the torque converter.
NHTSA · boletim do fabricante10220840Anos-modelo 2005Exibido no inglês original · tradução pendenteVer detalhes →
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0).