Os boletins técnicos (TSB) são instruções de reparação que os fabricantes enviam aos concessionários sobre problemas conhecidos. Não são recalls de segurança, mas muitas vezes confirmam um defeito.
TSB: The purpose of this bulletin is to provide information regarding transmission and/or park neutral position switch installation. If the manual shift lever is rotated prior to installing the park neutral position switch, the detent spring may become detached from the manual shift lever. Use the information in this bulletin when installing an automatic transmission and/or park neutral position switch assembly.
NHTSA · boletim do fabricante10109446Anos-modelo 2006Exibido no inglês original · tradução pendenteVer detalhes →
Special service campaign (ssc) - 6lb (supplemental restraint system (srs) airbag replacement). Due to improper assembly of the airbag inflator, which is incorporated into the srs airbag assembly (side airbag, curtain side airbag or driver knee airbag), some inflators were produced with an insufficient amount of the heating agents necessary for proper airbag deployment. *tt
NHTSA · boletim do fabricante10019700Anos-modelo 2006Exibido no inglês original · tradução pendenteVer detalhes →
TSB: This Service Bulletin includes procedures to replace damaged or loose front carpet floor retainer(s) without replacing the carpet assembly. Follow the Repair Procedure in this bulletin to replace the loose or damaged carpet floor retainer(s).
NHTSA · boletim do fabricante10210374Anos-modelo 2005Exibido no inglês original · tradução pendenteVer detalhes →
Warranty Enhancement Program - ZLD Phase 2,3 & 4 Part Replacement Available for all Models - Extention of Warranty Coverage for Cracked and/or Sticky/Melting Dashboards ( Inst krukment Panels) as a Result of Heat or Humidity.
NHTSA · boletim do fabricante10205136Anos-modelo 2008Exibido no inglês original · tradução pendenteVer detalhes →
Warranty Enhancement Program - ZLD Phase 2,3 & 4 Part Replacement Available for all Models - Extention of Warranty Coverage for Cracked and/or Sticky/Melting Dashboards ( Inst krukment Panels) as a Result of Heat or Humidity.
NHTSA · boletim do fabricante10205392Anos-modelo 2008Exibido no inglês original · tradução pendenteVer detalhes →
TSB: For proper calibration of the millimeter wave radar sensor, the vehicle and radar target must be on a level surface with a consistent plane. If a level surface with a consistent plane is not available, use the Floor Slope Compensation Procedure in this service bulletin in conjunction with the appropriate model and model year Repair Manual instructions when adjusting the millimeter wave radar sensor.
NHTSA · boletim do fabricante10204556Anos-modelo 2006Exibido no inglês original · tradução pendenteVer detalhes →
TT: For proper calibration of the millimeter wave radar sensor, the vehicle must be on a level surface. If a level surface is not available, this tech tip should be used in conjunction with the repair manual to set the angle of the front millimeter wave radar sensor and reflector height before performing beam axis adjustment.
NHTSA · boletim do fabricante10173987Anos-modelo 2006Exibido no inglês original · tradução pendenteVer detalhes →
TSB: Some 2006 ? 2020 model year Lexus vehicles may exhibit odors that naturally occur from the HVAC system and/or related environmental factors. Although there is no way to eliminate these odors, follow the General Procedure in this bulletin to minimize the odors experienced.
NHTSA · boletim do fabricante10172825Anos-modelo 2006Exibido no inglês original · tradução pendenteVer detalhes →
TT: Some IS250 and GS300 vehicles may exhibit one or more of the following conditions: ? MIL ?ON? DTC P0300, P0301, P0302, P0303, P0304, P0305, and/or P0306. ? Intermittently runs rough after coming to a stop with the engine at operating temperature. ? Intermittently runs rough with engine misfires present after a cold soak startup. NOTE: The recommendations in this document apply to an intermittent misfire concern. If a vehicle exhibits a steady misfire, the root cause is not related to the referenced service bulletins and the repair manual should be referenced for diagnosis.
NHTSA · boletim do fabricante10152274Anos-modelo 2006Exibido no inglês original · tradução pendenteVer detalhes →
Warranty Policy Bulletin: Lexus has received reports where some vehicles may exhibit cracked and/or sticky/melting dashboards as a result of heat or humidity. NOTE: The same voluntary Warranty Enhancement Program coverage described herein is also applicable to certain 2006-2008 MY IS 250/350 and certain 2007 MY LS 460 vehicles for cracked and/or sticky/melting front and rear interior door panels as a result of heat or humidity.
NHTSA · boletim do fabricante10146513Anos-modelo 2008Exibido no inglês original · tradução pendenteVer detalhes →
WPB: Background: Lexus has received reports where some vehicles may exhibit cracked and/or sticky/melting dashboards as a result of heat or humidity. In Mid-December, 2014 Lexus announced the reimbursement phase of this warranty enhancement program. Since this announcement, Lexus has been diligently making parts preparations for the parts replacement phase of this program. Due to the age, volume, and breadth of the covered vehicles involved in the Program, and the size and complexity of dashboard manufacturing, Lexus will be launching the part replacement portion of this Program in several phases; please refer to the table below for part replacement model phasing.
NHTSA · boletim do fabricante10134373Anos-modelo 2008Exibido no inglês original · tradução pendenteVer detalhes →
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).