**Problema:** Este recall refere-se a determinados kits de aquecedor do bloco do motor instalados em determinados veículos ou vendidos como acessórios nas concessionárias Toyota ou Lexus. Em alguns veículos, o cabo do aquecedor do bloco do motor pode não ter proteção térmica suficiente e ser danificado por altas temperaturas. Se isso acontecer, o cabo pode sofrer um curto-circuito enquanto estiver conectado à tomada, fazendo com que a fiação superaqueça ou derreta.
**Nota:** Este recall afeta apenas os seguintes números de peça do aquecedor/cabo de alimentação: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903
**Risco à segurança:** A fiação do aquecedor do bloco do motor que superaquece ou derrete pode criar o risco de incêndio.
**Ações corretivas:** A Toyota recomenda que você pare de usar o aquecedor do bloco do motor imediatamente. A Toyota notificará os proprietários por correspondência e instruirá a levar o veículo a uma concessionária para desativar o aquecedor do bloco do motor. Para alguns veículos, as ações corretivas para este recall ainda estão em desenvolvimento. Para outros, não é possível instalar um novo aquecedor do bloco do motor, e o proprietário receberá o reembolso do preço de compra do aquecedor do bloco do motor.
Transport Canada24 de nov. de 20212021723Anos-modelo 2010Traduzido automaticamente · original: inglêsVer detalhes →
On certain vehicles, the holding plate of the hybrid transaxle assembly may have been crimped improperly during assembly. This could result in the plate to wear, potentially causing irregular movement around the motor shaft, which could allow the plate to contact the electric motor coil and lead to a short circuit. This would illuminate warning lights and warning messages in the instrument cluster, and cause the vehicle to enter a fail-safe mode resulting in reduced motive power. In some cases, the hybrid system could shut down, resulting in loss of motive power while the vehicle is in motion, which could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will replace the hybrid transaxle assembly with a new one.
Transport Canada4 de out. de 20172017478Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2010 Lexus HS 250h Hybrid vehicles. A component within the hybrid transaxle assembly may short circuit and result in a reduction or a complete loss of available power for moving the vehicle.
NHTSA · Estados Unidos4 de out. de 201717V619000Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
On certain vehicles, the rear wheel suspension link arms could separate. This could result in loss of vehicle control and cause a crash resulting in injury and/or damage to property. Correction: Dealers will replace both suspension link arms and encase them in epoxy to prevent future improper servicing. Note: This recall supersedes recall 2013327. As part of the previous recall, dealers were to inspect the suspension arms for corrosion, replace them depending on their condition, and encase them in epoxy. Only vehicles which did not receive replacement of both suspension arms through the previous recall will need to be repaired under this campaign.
Transport Canada11 de ago. de 20162016398Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
On some vehicles, if the rear wheel alignment toe adjustment locking nuts are improperly tightened when an alignment is performed in the field, backlash may develop in the threaded portion of the suspension arm (shaft and turnbuckle), followed by the formation of rust. If this occurs, threads may wear, causing the arm to separate which could result in loss of vehicle control. Correction: Dealers will inspect the suspension arm threads for corrosion. If corrosion is found, the arm(s) will be replaced. If no corrosion is found, an epoxy sealer will be applied to the suspension arm to inhibit corrosion. Note: This recall supersedes recall 2012253. Vehicles that were repaired under the previous campaign will also need to be repaired under this campaign.
Transport Canada25 de set. de 20132013327Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
This recall was replaced by Transport Canada recall no. 2013-327. On some vehicles, if the rear wheel alignment toe adjustment locking nuts are improperly tightened when an alignment is performed in the field, backlash may develop in the threaded portion of the suspension arm (shaft and turnbuckle), followed by the formation of rust. If this occurs, threads may wear, causing the arm to separate which could result in loss of vehicle control. Correction: Dealers will inspect the arms and verify the tightening torque of the lock nuts, or replace the arms, as necessary.
Transport Canada1 de ago. de 20122012253Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
TOYOTA IS RECALLING CERTAIN MODEL YEAR 2010 HS250h LEXUS VEHICLES FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY." WHEN THE VEHICLE WAS ROTATED FOLLOWING A CRASH TEST AS REQUIRED, THE AMOUNT OF FUEL LEAKAGE EXCEEDED THE ALLOWABLE LIMITS.
NHTSA · Estados Unidos25 de jun. de 201010V285000Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2006-2011 Toyota RAV4 vehicles manufactured October 31, 2005, to September 7, 2010, and 2010 Lexus HS250h vehicles manufactured July 6, 2009, to August 26, 2010. The affected vehicles have rear suspension arms (rear tie rods) with adjusting lock nuts that may have been improperly tightened after servicing. As a result of being loose, the arm may have thread damage and may rust, possibly leading to the failure of the arm and an abrupt change in the vehicle's alignment.
NHTSA · Estados Unidos12 de ago. de 201616V596000Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
Toyota is recalling certain model year 2006 through 2011 RAV4 and 2010 Lexus HS250h passenger vehicles manufactured from October 2005 through September 2010. If the nuts for adjusting the rear wheel alignment are improperly tightened during service, the rear suspension arm (rear tie rod) may develop unwanted movement and rust leading to thread damage and eventual failure. Failure of the rear tie rod will cause an abrupt change in the vehicle's alignment.
NHTSA · Estados Unidos28 de ago. de 201313V383000Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
On certain vehicles, a fatigue crack could develop in the brake pressure accumulator. If this occurs, nitrogen gas could leak into the brake fluid and gradually cause the brake pedal stroke to become longer, resulting in decreased hydraulic pressure. This condition could result in longer stopping distances, increasing the risk of a crash causing property damage and/or injury. Correction: dealers will inspect the brake booster pump and, if necessary, replace it with an improved unit.
Transport Canada5 de jun. de 20132013193Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
Toyota is recalling certain model year 2010 Prius vehicles manufactured March 31, 2009, through October 9, 2009; and model year 2010 Lexus HS250h vehicles manufactured June 19, 2009, through October 9, 2009. Nitrogen gas from a component of the brake booster pump assembly could leak into the brake fluid.
NHTSA · Estados Unidos5 de jun. de 201313V235000Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
Toyota is recalling certain model year 2006 through 2011 RAV4 and 2010 Lexus HS250h passenger vehicles manufactured from October 2005 through September 2010. If the nuts for adjusting the rear wheel alignment are improperly tightened during service, the rear suspension arm (rear tie rod) may develop unwanted movement and rust, leading to thread damage and eventual failure. Failure of the rear tie rod will cause an abrupt change in the vehicle's alignment.
NHTSA · Estados Unidos2 de ago. de 201212V373000Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
On certain vehicles, an inconsistent brake feeling may be perceived after ABS actuation during slow and steady application of the brakes on rough or slick road surfaces and stopping distances may be increased compared to expectation for a given pedal force. Increased brake distance in a case of emergency may result in a crash causing property damage or personal injury. Dealers will rewrite the programming of the ABS control Unit.
Transport Canada9 de fev. de 20102010037Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
Toyota is recalling certain model year 2010 toyota prius and lexus hs250h passenger vehicles. Customers have experienced inconsistent brake feel after abs actuation during slow and steady application of the brakes on rough or slick road surfaces. Stopping distances may be increased compared with a customer's expectation for a given pedal force.
NHTSA · Estados Unidos9 de fev. de 201010V039000Anos-modelo 2010Exibido no inglês original · tradução pendenteVer detalhes →
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0).