Engine and engine cooling
On certain vehicles, the air filter paper in these vehicles can smolder or burn.
🔔 Crie uma conta gratuita para receber alertas por e-mail sobre Mercury Sable (todas as gerações)
On certain vehicles, the air filter paper in these vehicles can smolder or burn.
Vehicle description: Taurus/sable vehicles equipped with 3.0l and 3.8l engines and mustang vehicles with 3.8l and 5.0l engines. It is possible for the engine cooling fan bearing to seize.
Vehicle description: Passenger cars. The seat belt buckle tongue may not fully eject from the buckle assembly when the release button is pushed slowly. This condition could also result in a partial latch of the tongue in the buckle.
Vehicle description: Passenger vehicles equipped with adjustable pedals. If the grease from the adjustable pedal assembly enters the stop lamp switch, it can contaminate the contacts leading to carbon build up, and potentially, a short circuit.
Vehicle description: Passenger vehicles equpped with the "california" emissions package. An incorrect transmission oil cooler line was installed. The line contacts the anti-lock braking system module support bracket and over time, can wear and develop a leak.
Vehicles that were serviced for a stall condition between august 1, 1997 and december 1, 1997 may have received and incorrect fuel tank. The incorrect tank contains an additional vent hole which provides the potential for a fuel leak. Correction: Vehicles will be inspected and fuel tank will be replaced with the correct tank if necessary.
Vehicle description: Passenger vehicles previously serviced under ford service bulletin 97-17-9 from august 1997 through december 1997. These vehicles were inadvertenly equipped with an 18-gallon fuel tank rather than the 16-gallon as specified. The 18-gallon tank has a second valve location where a shipping plug should be installed.
Vehicle description: Passenger vehicles equipped with ax4s automatic transaxles. The low/intermediate servo cover can separate from the transaxle while the vehicle is being driven. If this occurs, transmission fluid will leak contacting the catalytic converter.
These vehicles are originally sold or currently registered in the following states: Alaska, iowa, minnesota, nebraska, north dakota, and south dakota. The vehicles involved are 1992-1994 tempo/topaz vehicles with 3.0l engines; 1994 tempo/topaz with 2.3l engines; 1992-1995 taurus/sable with 3.8l engines; 1994-1995 taurus/sable with 3.0l engines and 1992-1994 lincoln continental vehicles with 3.8l engines. During high winds, heavy, blowing and drifting snow, and low temperatures, the engine cooling fan can become blocked or frozen with snow. The fan motor may not rotate and could overheat.
Note: 1992-94 tempo/topaz with 3.0 litre engines; 1994-95 taurus/sable (except sho) with 3.0 litre engines; 1992-93 taurus/sable with 3.8 litre engines; 1992-94 lincoln continental. The engine cooling fan may become frozen in place by snow, ice or slush. If this occurs and the cooling fan is activated, either automatically to reduce coolant temperature or when the defroster is turned on, the cooling fan will not rotate and can overheat. This can damage the fan motor, fan, fan wiring and shroud with the potential for smoke or a fire to result. Correction: In some cases, the fuse for the cooling fan circuit will be replaced with a smaller fuse. In other cases, a jumper harness with dedicated circuit protection for the cooling fan will be installed.
The retainer clip which holds the master cylinder push rod to the brake pedal arm is missing or not completely installed. The push rod can separate from the brake pedal arm.
Improper routing of the power seat switch wiring will allow the wiring to be contacted and potentially damaged by the seat cushion spring ends when the seat is occupied. This could abrade or puncture the wiring and cause an electrical short which could in turn result in a fire. Correction: Power seat switch wiring will be rerouted and damaged wiring will be replaced.
The composite construction front brake rotors on these vehicles may corrode, weaken and fracture, resulting in a reduction of braking performance. Such a fracture would result in loss of braking at the corresponding front wheel which could in turn result in increased stopping distance and a possible crash. Correction: Front brake rotors will be replaced.
On vehicles equipped with a driver side supplemental air bag, the centre post threads of the air bag module may have been damaged during assembly. In a deployment level collision, the centre post housing may separate from the air bag adapter causing the air bag not to inflate properly. In addition, hot combustion gases would flow directly through the air bag rather than through the normal filtering and cooling devices, presenting the possibility of burn injury to vehicle occupants. Correction: Air bag modules will be inspected and replaced if necessary.
On vehicles with EFI or CFI, the spring-lock fuel line coupling used to connect the fuel supply and return lines to the EFI fuel rails or to the CFI throttle bodies, as well as other fuel line connections near the dash panels on some vehicles, could disengage during vehicle use. Should this occur, loss of fuel will result, providing the potential for a vehicle fire. Correction: Coupling retainer clips will be installed on affected vehicles. Note: Escort vehicles are equipped with EFI and CFI. Lynx vehicles are equipped with CFI only. EFI - electronic fuel injection; CFI - central fuel injection
Spring lock fuel line coupling may not be properly engaged.
The steering column lower shaft may not be properly attached to the steering shaft insulator flange. If the shaft were to separate, total loss of steering control would occur without prior warning, resulting in a possible vehicle crash. Correction: Vehicles will be inspected and, if necessary, the steering shaft assembly will be replaced.
Steering shaft assemblies contain lower shafts of insufficient length for proper attachment to the shaft insulator flange. Consequence of defect: Shaft could separate, resulting in total loss of steering control and a possible accident.
Ford Motor Company (Ford) está convocando para recall determinados veículos Ford Flex do ano-modelo 2009 a 2012, Ford Taurus dos anos-modelo 2008 e 2010 a 2012, Ford Taurus X dos anos-modelo 2008 e 2009, Mercury Sable do ano-modelo 2008 e Lincoln MKS dos anos-modelo 2009 e 2011. O airbag frontal do motorista pode não inflar corretamente durante a segunda etapa de acionamento em caso de colisão em alta velocidade. Por isso, esses veículos não atendem aos requisitos do Padrão Federal de Segurança de Veículos Automotores (FMVSS) número 208, "Proteção de Ocupantes em Colisões".
On certain passenger vehicles originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia, the front coil springs could fracture due to corrosion associated with salt used on the roadways during the winter. A fractured spring could move past the spring seat and contact a front tire.
Certos veículos de passageiros equipados com bancos de ajuste elétrico podem ter sido soldados de forma inadequada.
Certain passenger vehicles are being recalled to correct a problem with a malfunctioning stop lamp switch and/or associated wiring. This malfunctioning could render the stop lamps inoperable or cause them to stay on all the time. This could cause confusion to a following driver, which could lead to a crash.
Certain passenger vehicles equipped with adjustable padels are being recalled in order to adjust the brake and accelerator pedals to a minimum of 50 mm of lateral separation. Simultaneous application of both the brake and accelerator pedals could result in an increase in engine rpm.
Descrição do veículo: Carros de passageiros, veículos utilitários esportivos e caminhonetes leves e médias. Um interruptor localizado na tampa plástica da caixa de engrenagens do motor do limpador de para-brisa pode apresentar defeito e superaquecer, podendo resultar em perda da função intermitente do limpador, perda da função de estacionamento do limpador, perda completa da função do limpador ou ignição do material da tampa plástica. A falha do interruptor é mais provável de ocorrer quando a configuração intermitente dos limpadores está sendo utilizada, ou quando neve ou gelo impede que as palhetas retornem à posição "estacionada" na parte inferior do para-brisa. Estes veículos foram fabricados nas seguintes fábricas de montagem: fábrica de Atlanta, de 11/2/00 a 31/7/00; fábrica de Chicago, de 14/2/00 a 4/8/00; fábrica de Kansas City, de 26/2/00 a 4/9/00; fábrica de caminhões de Kentucky, de 18/2/00 a 31/8/00; fábrica de caminhões de Michigan, de 23/2/00 a 3/8/00; fábrica de Norfolk, de 21/2/00 a 27/7/00; fábrica de estampagem e montagem de Wayne, de 25/2/00 a 15/8/00; e fábrica de Wixom, de 15/2/00 a 8/8/00.
Veículos de passageiros e utilitários esportivos. Devido ao uso de material incorreto por um fornecedor, o botão do interruptor dos faróis pode fraturar e se separar do interruptor dos faróis.
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).