These vehicles are originally sold or currently registered in the following states: Alaska, iowa, minnesota, nebraska, north dakota, and south dakota. The vehicles involved are 1992-1994 tempo/topaz vehicles with 3.0l engines; 1994 tempo/topaz with 2.3l engines; 1992-1995 taurus/sable with 3.8l engines; 1994-1995 taurus/sable with 3.0l engines and 1992-1994 lincoln continental vehicles with 3.8l engines. During high winds, heavy, blowing and drifting snow, and low temperatures, the engine cooling fan can become blocked or frozen with snow. The fan motor may not rotate and could overheat.
NHTSA · Estados Unidos25 de fev. de 199797V019000Anos-modelo 1992–1994Exibido no inglês original · tradução pendenteVer detalhes →
Note: This recall supersedes recall 95-202 for 1994 tempo/topaz 2.3 litre vehicles. The engine cooling fan may become frozen in place by snow, ice or slush. If this occurs and the cooling fan is activated, either automatically to reduce coolant temperature or when the defroster is turned on, the cooling fan will not rotate and the fan motor and wiring can overheat. This could result in a fire. Correction: Engine cooling fan motor circuit protection will be revised by installing a fused jumper harness within the engine compartment.
Transport Canada12 de set. de 19961996134Anos-modelo 1994Exibido no inglês original · tradução pendenteVer detalhes →
Um curto-circuito pode se desenvolver no interruptor de ignição, o que pode levar a superaquecimento, fumaça e, possivelmente, incêndio na coluna de direção do veículo. Essa condição pode ocorrer com o veículo em uso ou estacionado sem supervisão. Correção: o interruptor de ignição será substituído por um interruptor de design revisado.
Transport Canada29 de nov. de 19951995212Anos-modelo 1988–1993Traduzido automaticamente · original: inglêsVer detalhes →
Note: 1992-94 tempo/topaz with 3.0 litre engines; 1994-95 taurus/sable (except sho) with 3.0 litre engines; 1992-93 taurus/sable with 3.8 litre engines; 1992-94 lincoln continental. The engine cooling fan may become frozen in place by snow, ice or slush. If this occurs and the cooling fan is activated, either automatically to reduce coolant temperature or when the defroster is turned on, the cooling fan will not rotate and can overheat. This can damage the fan motor, fan, fan wiring and shroud with the potential for smoke or a fire to result. Correction: In some cases, the fuse for the cooling fan circuit will be replaced with a smaller fuse. In other cases, a jumper harness with dedicated circuit protection for the cooling fan will be installed.
Transport Canada15 de nov. de 19951995202Anos-modelo 1992–1994Exibido no inglês original · tradução pendenteVer detalhes →
Extended highway operation during very low ambient temperatures (-20 degrees centigrade or below) may result in ice forming in the positive crankcase ventilation (pcv) system. If this occurs, the crankcase may become pressurized, which could force oil out of the engine. If the oil is forced past the rocker cover gasket, it could contact the exhaust manifold, which potentially could result in a fire. Correction: Dealers will install revised, coolant heated pcv systems.
Transport Canada2 de nov. de 19951995197Anos-modelo 1989–1994Exibido no inglês original · tradução pendenteVer detalhes →
On vehicles equipped with a driver side supplemental air bag, the centre post threads of the air bag module may have been damaged during assembly. In a deployment level collision, the centre post housing may separate from the air bag adapter causing the air bag not to inflate properly. In addition, hot combustion gases would flow directly through the air bag rather than through the normal filtering and cooling devices, presenting the possibility of burn injury to vehicle occupants. Correction: Air bag modules will be inspected and replaced if necessary.
Transport Canada21 de nov. de 19901990182Anos-modelo 1990Exibido no inglês original · tradução pendenteVer detalhes →
The front sleeve bushings of the cooling fan motors are susceptible to excessive corrosion in areas of high road salt use. This may increase the rotational friction of the fan motor or result in seizure of the armature shaft to the bushing. Either condition may draw current in excess of that of a normally operating motor but less than required to operate the fuse link. This could overheat the motor wiring circuitry and possibly result in an underhood or instrument panel fire. Vehicles affected: Cars not equipped with factory air conditioning. Quebec and atlantic provinces only.
Transport Canada28 de jun. de 19841984081Anos-modelo 1984Exibido no inglês original · tradução pendenteVer detalhes →
Note: Vehicles equipped with 2.3l and 3.0l engines. These vehicles may not comply with c.M.V.S.S. 1105-evaporative emissions. One or both of the evaporative emissions vapour canister hoses may not be connected. Correction: Vehicles will be inspected and vapour canister hoses will be connected if required.
Transport Canada14 de mai. de 19951995079Anos-modelo 1994Exibido no inglês original · tradução pendenteVer detalhes →
These vehicles do not comply with c.M.V.S.S. 1105 - evaporative emissions. Fuel vapour return line hoses in engine compartment may not be connected. Correction: Vehicles will be inspected and hoses connected where necessary. Note: All vehicles were completed prior to sale.
Transport Canada21 de jul. de 19931993103Anos-modelo 1993Exibido no inglês original · tradução pendenteVer detalhes →
Observação: Também inclui alguns caminhões médios e pesados. Esses veículos podem não estar em conformidade com a norma C.M.V.S.S. 108 – iluminação. O módulo das luzes de circulação diurna pode apresentar mau funcionamento, o que pode fazer com que as luzes de circulação diurna diminuam de intensidade, pisquem ou se apaguem, ou, em alguns casos, permaneçam acesas após a chave de ignição ser desligada. Correção: O módulo das luzes de circulação diurna será substituído nos veículos afetados.
Transport Canada30 de jun. de 19921992077Anos-modelo 1990–1991Traduzido automaticamente · original: inglêsVer detalhes →
Note: Tempo/topaz with 2.3 litre engine and aerostar with 3.0 litre engine. These vehicles so not comply with c.M.V.S.S. 1103 - exhaust emissions. Defective throttle position sensors can wear out prematurely causing an interruption of the sensor signal and illumination of the malfunction indicator light. Correction: Throttle position sensor will be inspected and replaced if necessary.
Transport Canada5 de fev. de 19921992011Anos-modelo 1990–1991Exibido no inglês original · tradução pendenteVer detalhes →
Estes veículos podem não estar em conformidade com a C.M.V.S.S. 1103 - emissões de gases de escapamento. O injetor central de combustível (CFI) pode operar com mistura rica em determinadas condições de funcionamento.
Correção: Serão instalados injetores de combustível CFI aprimorados e a rotação em marcha lenta será ajustada.
Transport Canada13 de jul. de 19891989099Anos-modelo 1985–1987Traduzido automaticamente · original: inglêsVer detalhes →
The attachment screws for the throttle position sensor could loosen and back out allowing the throttle sensor to move away from the throttle shaft. A loose sensor could prevent the throttle from returning to the idle position which in turn could adversely affect vehicle control. Correction: Attachment screws will be replaced using screws with pre-applied adhesive that will be tightened to a higher torque specification.
Transport Canada9 de mar. de 19881988027Anos-modelo 1988Exibido no inglês original · tradução pendenteVer detalhes →
Nota: Veículos com motores 2.3 litros e.F.I. Esses veículos não estão em conformidade com o C.M.V.S.S.115 - número de identificação do veículo. - os caracteres do código do tipo de motor (8ª posição) e do dígito verificador (9ª posição) estão incorretos.
Transport Canada28 de jan. de 19871987009Anos-modelo 1987Traduzido automaticamente · original: inglêsVer detalhes →
Em veículos produzidos na fábrica de montagem de Oakville, o parafuso dianteiro que proporciona parte da fixação entre o conjunto do encosto do banco do motorista e a estrutura do assento pode estar suscetível a fratura por fadiga. A fratura desse parafuso permitiria que o encosto do banco do motorista girasse para trás e poderia resultar em perda de controle do veículo. Correção: Novos parafusos serão instalados na estrutura do assento do motorista.
Transport Canada26 de jun. de 19861986070Anos-modelo 1984Traduzido automaticamente · original: inglêsVer detalhes →
The forward bolt that provides part of the attachment between the driver's seat back assembly and the seat cushion frame may be subject to fatigue fracture. Consequence of defect: If this bolt breaks, the driver and seat back will fall back, which could result in the driver losing control of the car and possibly lead to an accident.
NHTSA · Estados Unidos24 de jun. de 198686V082000Anos-modelo 1984Exibido no inglês original · tradução pendenteVer detalhes →
Rear supension control arm-to-spindle attachment bolts may be subject to fracture causing the rear spindle to separate during use of car. Consequence of defect: If bolts fracture and rear spindle disengages from control arm, loss of control will be experience which may result in an accident.
NHTSA · Estados Unidos5 de nov. de 198585V145000Anos-modelo 1984–1985Exibido no inglês original · tradução pendenteVer detalhes →
The unexpected open throttle causes an increase in engine speed which could result in loss of control of the car and a potential crash. Consequence of defect: The electronic engine control processor may experience an intermittent timing problem. This problem causes improper execution engine performance which may maintain or cause a partially open throttle.
NHTSA · Estados Unidos22 de out. de 198585V134000Anos-modelo 1985Exibido no inglês original · tradução pendenteVer detalhes →
Rear suspension control arm-to-spindle attachment bolts may be subject to fracture during use of car. Consequence of defect: If bolts fracture, rear spindle could disengage from control arm and possibly result in loss of control.
NHTSA · Estados Unidos3 de jul. de 198585V086000Anos-modelo 1984–1985Exibido no inglês original · tradução pendenteVer detalhes →
Some of the affected vehicles were produced with rear suspension control arm - to - spindle attachment bolts that may be susceptible to fracture during vehicle use. If this were to occur, the adjacent rear spindle could disengage from the control arm, creating a potential for loss of vehicle control and possible crash.
Transport Canada28 de jun. de 19851985079Anos-modelo 1984–1985Exibido no inglês original · tradução pendenteVer detalhes →
When severely loaded by a frontal impact, the seat belt webbing may contact the leading edge of the front seat-back stell reinforcement plates. This may cause the seat belt webbing to be abraded, cut or completely severed, thereby significantly increasing the risk of serious personal injuries.
Transport Canada19 de jun. de 19841984078Anos-modelo 1984Exibido no inglês original · tradução pendenteVer detalhes →
The bolts that attach the d-shaped ring for the shoulder belt are inadequately supported by the material in which they are mounted. The attachment does not comply with the requirements of federal motor vehicle safety standard no. 210, "seat belt assembly anchorages".
NHTSA · Estados Unidos20 de dez. de 198383V134000Anos-modelo 1984Exibido no inglês original · tradução pendenteVer detalhes →
The upper torso restraint d-ring which attaches the shoulder belt to the b pillar, under certain test conditions, separated from its anchorage, and may not comply with cmvss 210 - belt anchorage.
Transport Canada17 de dez. de 19831983114Anos-modelo 1984Exibido no inglês original · tradução pendenteVer detalhes →
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).