Airbags: Frontal: Sensor/módulo de controlo - inativo
Em certos veículos de passageiros, o monitor integrado do airbag (IABM) pode estar contaminado com água ou outros líquidos e pode sofrer curtos-circuitos internos elétricos.
🔔 Crie uma conta gratuita para receber alertas por e-mail sobre Mercury Tracer (todas as gerações)
Em certos veículos de passageiros, o monitor integrado do airbag (IABM) pode estar contaminado com água ou outros líquidos e pode sofrer curtos-circuitos internos elétricos.
Descrição do veículo: Veículos de passeio equipados com motores de 1,9 L, fabricados na planta de montagem de Hermosillo e originalmente vendidos ou atualmente registrados no Arizona. Podem surgir trincas no tanque de combustível próximo à fixação do protetor térmico, resultando em vazamento de combustível caso as trincas atravessem a parede do tanque.
Veículos de passageiros equipados com motores de 1,9 l, fabricados nas plantas de montagem de Hermosillo ou Wayne e originalmente vendidos ou atualmente registrados em Nevada, Flórida, Havaí, Texas, Califórnia, Louisiana, Geórgia, Carolina do Sul, Mississippi, Oklahoma, Alabama e Arkansas. Podem surgir trincas no tanque de combustível próximo à fixação do protetor térmico, o que pode resultar em vazamento de combustível caso as trincas atravessem a parede do tanque.
DEFECT: THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.
O módulo do airbag do lado do motorista pode ter um cilindro inflador com solda inadequada.
On vehicles with manual transmission, the roll pins securing the ignition lock cylinder in the steering column housing may not remain in place. This could cause the ignition lock cylinder to disengage from the steering column housing which could result in steering column lock-up and loss of steering control. Correction: Vehicles will be inspected and if roll pins are present and fully inserted, a plastic snap-on sleeve will be installed to prevent the pins from coming out. If one or both or the roll pins are missing or not fully inserted, the ignition lock housing assembly will be replaced (along with the door locks and the liftgate/deck-lid locks so that key compatibility is maintained).
Fatigue cracks may develop in the solder joint between the fuel return tube and the fuel pump sending unit located on the top of the fuel tank. This would allow fuel vapours to escape from the tank and when the tank is 7/8 or more full, a small amount of liquid fuel may leak from the crack presenting a potential fire hazard. Note: For escort models only gt and lxe lines involved. Correction: Vehicles will be inspected and fuel pump sending unit assembly will be replaced with one of improved strength.
Fatigue cracks can develop in the solder joint between the fuel return tube and the fuel pump sending unit located at the top of the fuel tank.
The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.
Nota: Veículos localizados em Ontário, Quebec e nas províncias do Atlântico. O conjunto de fiação da bomba de combustível pode sofrer corrosão devido ao sal das estradas, podendo resultar na formação de uma ponte elétrica entre o circuito elétrico da bomba de combustível e os terminais do emissor do medidor de combustível. Isso poderia fazer com que o circuito de aterramento do emissor de combustível superaqueça a fiação e derreta seu isolamento antes da abertura do fusível no circuito de alimentação da bomba de combustível. Isso causaria fumaça e odor e poderia resultar na perda de fornecimento de combustível ao motor e na parada do motor. Correção: Um chicote de cabos de interligação com fusível será instalado no circuito elétrico da bomba/emissor de combustível.
The roll pins securing the ignition lock in the steering column housing can separate or move out of position.
Vehicles may be equipped with stop lamp switches that potentially could intermittently malfunction and result in the stop lamps not illuminating when the brakes are applied. This could result in following motorists not being signaled that the vehicle is braking, which could result in an accident. Correction: Vehicles will be inspected and stop lamp switches replaced if necessary.
The stop lamp switches could intermittently malfunction resulting in the stop lamps not illuminating when the brakes are applied.
The front seat lap-shoulder belt retractors may lock repeatedly at low belt pull-out rates thereby discouraging people from using the seat belt. Correction: Lap-shoulder belt assemblies will be inspected and replaced if necessary.
Some lap shoulder belt retractors were built with certain out of tolerance components.
The front passenger seats may be equipped with incorrect inboard or outboard seat tracks. In this event the seat would not be latched when in the rearmost position, permitting unrestricted forward movement. In the event of a frontal collision, risk of injury to the front seat occupants would be increased. Correction: Seat tracks will be inspected and replaced if necessary.
Incorrect fuel filler neck attachment screws were used to attach the neck to the rear quarter panels.
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).