Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

Nissan Juke

2010– · 3 gerações · 21 defeitos documentados · 5 mercados
Gerações
Ano do modelo
Juke I · 2010–2019
RecallCríticoElétricaNA

Electrical

On certain vehicles, due to a manufacturing defect the start/stop button could stick inside of its housing. If this occurs, vibration could cause the electrical components inside the button to contact repeatedly in quick succession and initiate the emergency engine shut off procedure while the vehicle is in motion. This could result in increased steering and braking effort, a loss of motive power and would disable the supplemental restraint systems (SRS), increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and repair defective start/stop switch as necessary.

Transport Canada25 de jun. de 20152015282Anos-modelo 2013–2014Exibido no inglês original · tradução pendenteVer detalhes →
Juke I · 2010–2019
RecallCríticoElétricaEU

null The fuel rail pressure sensor of some vehicles may be tightened insufficiently to the fuel rail of…

null The fuel rail pressure sensor of some vehicles may be tightened insufficiently to the fuel rail of the engine and it may loosen gradually due to heat and vibration of the engine. If left undetected and the vehicle continues to be driven in this condition, in an extreme case, fuel leakage may occur between the fuel rail pressure sensor and the fuel rail.

Safety Gate · UE5 de dez. de 2014A12/1975/14Anos-modelo 2012–2014Exibido no inglês original · tradução pendenteVer detalhes →
Juke I · 2010–2019
RecallCríticoElétricaJP

コモンレール

エンジンの燃料供給レールに取り付けている燃料圧力センサの締付けが不充分なため、エンジンの振動等により締付けが緩むものがある。そのため、燃料圧力センサの取付け部のねじを伝って燃料が漏れるおそれがある。

MLIT · Japão23 de fev. de 20121128970Anos-modelo 2010–2011Exibido no japonês original · tradução pendenteVer detalhes →
Juke I · 2010–2019
RecallModeradoElétricaUK

Rear oxygen sensor may fail

If an electrical short occurs in the supply to the rear oxygen sensor the senor will fail but the driver will not see an immediate warning. A MIL warning may display after continued driving depending on driving/vehicle characteristics.

DVSA · Reino Unido25 de jul. de 2016R/2016/157Anos-modelo 2014–2016Exibido no inglês original · tradução pendenteVer detalhes →
Juke I · 2010–2019
RecallModeradoElétricaEU

null The sensor of the rear oxygen sensor might fail and does not set a Diagnostic Trouble Code (DTC) in…

null The sensor of the rear oxygen sensor might fail and does not set a Diagnostic Trouble Code (DTC) in case of inappropriate content of the exhaust gases. In such cases, the user is not warned through the Malfunction Indicator Light (MIL) on the dashboard.

Safety Gate · UE13 de jul. de 2016A12/0879/16Anos-modelo 2014–2016Exibido no inglês original · tradução pendenteVer detalhes →
Juke I · 2010–2019
RecallModeradoElétricaEU

null An incorrect calibration setting in the Engine Control Module (ECM) software may cause miscalculation…

null An incorrect calibration setting in the Engine Control Module (ECM) software may cause miscalculation of sulfur oxide (SOx) levels captured within the Lean NOx Trap (LNT) component of the exhaust’s Diesel Particulate Filter (DPF). This miscalculation could, with extended operation under certain driving conditions, affect the purge process applied to remove SOx particles from the DPF-LNT. In this condition, the capacity of the DPF-LNT may become saturated and, as a result, the nitrogen oxide (NOx) emissions from the vehicle could exceed the permitted level.

Safety Gate · UE26 de fev. de 2016A12/0267/16Anos-modelo 2015Exibido no inglês original · tradução pendenteVer detalhes →
Juke I · 2010–2019
RecallModeradoElétricaNA

Electrical system:Ignition:Switch

Nissan North America, Inc. (Nissan) is recalling certain model year 2014 Versa Sedan vehicles manufactured July 16, 2013, to January 29, 2014, 2013-2014 Cube vehicles manufactured July 3, 2013, to October 21, 2013, and 2013-2014 Juke vehicles manufactured July 3, 2013, to October 22, 2013. When exposed to hot temperatures, the affected vehicles have an engine start/stop button that may stick inside the button housing.

NHTSA · Estados Unidos1 de jul. de 201515V418000Anos-modelo 2013–2014Exibido no inglês original · tradução pendenteVer detalhes →
Juke I · 2010–2019
RecallModeradoElétricaJP

過給機

(1)過給気導入ダクトにおいて、過給圧センサブラケット溶着部の加工が不適切なため、当該ブラケットの溶着強度が不足したものがある。そのため、そのままの状態で使用を続けると、過給圧センサブラケットが剥離して過給圧が正しく測定されず、警告灯が点灯するおそれがあり、最悪の場合、走行中にエンストし再始動できなくなるおそれがある。

MLIT · Japão8 de dez. de 20111128621Anos-modelo 2010–2011Exibido no japonês original · tradução pendenteVer detalhes →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).