Wheels
Cracks develop in the wheel mounting surface. If these cracks become severe enough, the wheel will completely separate from the vehicle.
Cracks develop in the wheel mounting surface. If these cracks become severe enough, the wheel will completely separate from the vehicle.
Cracks develop in the wheel mounting surface. If these cracks become severe enough, the wheel will completely separate from the vehicle.
Left handed driver's side shoulder belt anchor plate may be upside down in lock pillar so that the unthreaded slot of the plate aligned with the hole in the lock pillar. This resulted in the anchor bolt being driven into the slot instead of the threaded hole of the anchor plate. Consequence of defect: In a vehicle crash, belt anchor bolt may pull loose from anchor plate, thus failing to comply with fmvss 210, seat belt assembly anchorages, and increases likelihood of injury to occupant.
On certain vehicles, excessive enlargement of a pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate, possibly leading to loss of brake fluid in the rear brakes and loss of rear braking capability. This would result in increased stopping distances and possible crash. Note: vehicles in Ontario and Quebec only.
Excessive enlargement of the wheel cylinder pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate and cause loss of brake fluid. Consequence of defect: A loss of brake fluid leads to loss of rear brake action, creating the potential for an accident. Front brakes would remain operational.
The axle retaining "c" clip in the differential may dislodge and allow the axle, wheel and brake drum to separate from the vehicle when subjected to side forces. Axle separation could result in loss of vehicle control and possible crash.
The tie rods are part of the steering linkage and transmit turning movements to the wheels. The bolts that fasten the tie rods to their adjusters may not be tight enough. This could allow the tie rod to loosen and detach itself from the adjuster.
The rear brake system brake pipe from the master cylinder to the proportioner valve on these vehicles may be contacting the air cleaner resonator bracket. Over an extended period of operation, the brake pipe could wear through sufficiently to cause a loss of brake fluid and a partial loss of braking action. If a vehicle happens to be in motion at a time when minimum stopping distance is required, this condition could result in a vehicle crash without prior warning. Models equipped with 5.7 l. V-8 diesel engines.
Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. The fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. Leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full.
"tx" heavy duty wheels may have been manufactured with laminated steel. The wheel disc may fracture and the wheel and tire could partially or completely separate from the vehicle.
Vehicle description: Passenger vehicles and mini vans originally sold or currently registered in the following states: Connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont and wisconsin. The rear cradle bolts pull through the retainers due to corrosion of the retainer. If both bolts pull through, the rear cradle would not longer be supported at these mounting locations and the steering intermediate shaft can separate from the steering gear.
Brake stoplamps may not illuminate or, in some cases, stoplamps will not stay illuminated all the time when brakes are applied due to a faulty stoplamp switch. Also in vehicles equipped with cruise control, a faulty stoplamp switch can result in resumption of the cruise control function upon release of the brake pedal.
Front shoulder belt guide loop attachment fastener may pull through door mounted anchor plate.
The electronic air conditioning control may not function when starting car that has been parked for a few hours with ignition off.
Uma pequena bucha de náilon no pino (bail) do servo do controle de cruzeiro pode sair da posição, causando aumentos intermitentes e inesperados na rotação do motor, ou dieselização (funcionamento do motor após a chave ser desligada).
Estes veículos não estão em conformidade com a norma c.M.V.S.S. 1105 (emissões evaporativas). Os veículos podem apresentar defeito no interruptor termovácuo de purga do canister, deixando-o inoperante.
These vehicles do not comply with c.M.V.S.S. 1105 - evaporative emissions. Vehicles may experience an inoperative canister purge thermo vacuum switch. Correction: Canister purge thermo vacuum switch will be replaced.
The parking brake cable may be disconnected from the left rear brake caliper.
Manual valve link in the transmission may have been improperly formed.
An incorrectly indexed wiring harness may cause the center high mounted stop lamp to remain illuminated when the headlights or parking lamps are on. Fmvss 108 lamps, reflective devices and associated equipment requires that this stop lamp be lighted only when the brakes are applied. Also, the opera lamps may come on when the brakes are applied. Consequence of defect: The center high mounted stop lamp provides additional warning that the vehicle is slowing or stopping. If this lamp malfunctions, it may contribute to a rear end accident.
Em determinados veículos, o alargamento excessivo do furo-guia na placa de apoio traseira pode permitir que o cilindro de roda gire, o que pode levar à perda da ação de freio traseiro.
On certain vehicles, the heads of the rear seatbelt anchor bolts may break off during normal vehicle use and in the event of an accident in which the rear seatbelts are in use, the probability of injury to the wearer will be increased.
On certain vehicles, the rear brake backing plates may develop a corrosion condition which could result in loss of rear brake fluid and loss of rear braking capabilities. This recall affects vehicles sold in the Maritime provinces only.
The vehicles were assembled with front seat belt retractors which may not perform adequately during a collision.
Rear axle assembly may have axles that were improperly manufactured. This condition may result in separation of the axle shaft and wheel assembly from the vehicle.
Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).