Leitura livre · conta gratuita para contribuirSucessor do Anticars (2000)

PontiacPontiac Phoenix

1979–1984 · 1 gerações · 2 defeitos documentados · 1 mercados
Gerações
Todas as geraçõesII1979–1984229
Ano do modelo
MercadoTodosNA
RecallCríticoCarroceriaNA

Recall

Em veículos com motores de 2,5l. O sistema de combustível pode ter fugas na ligação do corpo de borboleta e do tubo de alimentação de combustível, apresentando a possibilidade de um incêndio sob o capot.

Transport Canada29 de mar. de 19851985032Anos-modelo 1984Traduzido automaticamente · original: inglêsVer detalhes →
RecallCríticoMotorNA

Sistema de combustível, gasolina: Entrega: Mangueiras, tubagens/tubos e conexões

O sistema de combustível pode ter fugas na ligação do corpo de borboleta e do tubo de alimentação do combustível. Consequência do defeito: Esta fuga pode resultar num incêndio sob o capô, que pode espalhar-se para o compartimento dos passageiros e causar queimaduras aos ocupantes.

NHTSA · Estados Unidos29 de mar. de 198585V034000Anos-modelo 1984Traduzido automaticamente · original: inglêsVer detalhes →
RecallCríticoFreiosNA

Recall

The brake proportioner valves may break and separate from the master cylinder during braking. This will result in a loss of brake fluid and a partial loss of braking action

Transport Canada7 de out. de 19841983084Anos-modelo 1983Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoFreiosNA

Recall

The rear brake hoses were not fully seated into their fittings when the fittings were crimped onto the hose at the time of manufacture. Hose failure would cause loss of brake fluid and partial loss of braking action thereby increasing stopping distance.

Transport Canada26 de jan. de 19831983009Anos-modelo 1982Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoMotorNA

Fuel system, gasoline:Storage:Tank assembly:Filler pipe and cap

Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. The fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. Leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full.

NHTSA · Estados Unidos8 de mar. de 198282V021000Anos-modelo 1982Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoElétricaNA

Recall

Under certain conditions the hose clamps on the fuel filler pipe and fuel tank filler vent pipe could fracture. This could cause seepage of fuel at any one of the four pipe to hose connections when the fuel tank is above 3/4 full creating the possibility of fire.

Transport Canada3 de mar. de 19821982026Anos-modelo 1982Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoCâmbioNA

Power train:Clutch assembly:Pedal/hand lever(motorcycle)

The clutch cable may rub against the master cylinder brake pipe when the clutch pedal is operated. Continued operation of the vehicle may result in wear through of the insulation on the clutch cable. The resulting metal on metal contact could lead to failure of the brake pipe, loss of brake fluid, and partial loss of brake action.

NHTSA · Estados Unidos2 de mar. de 198282V018000Anos-modelo 1982Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoFreiosNA

Recall

Vehicles equipped with 4 speed manual transmissions. The clutch cable may rub against the master cylinder brake pipe when the clutch pedal is operated. This could eventually result in the failure of the brake pipe causing loss of brake fluid and due to the dual braking system, a partial loss of braking action. Should a partial loss ob braking action occur while the vehicle is in motion at a time when minimum stopping distances are required, a vehicle crash could occur without prior warning.

Transport Canada25 de fev. de 19821982022Anos-modelo 1982Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoSuspensãoNA

Recall

Vehicles equipped with v6 engines and power steering may have the power steering hoses incorrectly routed. This condition may allow the hoses to contact the exhaust manifold possibly resulting in hose failure. It is possible that power steering fluid could leak onto the manifold resulting in smoke and under hood fire. Such a fire could spread to the passenger compartment.

Transport Canada16 de out. de 19801980132Anos-modelo 1981Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoCâmbioNA

Recall

Vehicles equipped with automatic transmissions. The automatic transmission cooler line hoses may fail during vehicle operation. Transmission fluid leakage in the engine compartment may result in a vehicle fire.

Transport Canada26 de set. de 19791979162Anos-modelo 1980Exibido no inglês original · tradução pendenteVer detalhes →
RecallCríticoFreiosNA

Service brakes, hydraulic:Foundation components:Hoses, lines/piping, and fittings

There is a potential for interference between the clutch control cable and brake pipe in the master cylinder. This can result in rubbing contact when the clutch pedal is operated. Also, the brake pipe clearance to the transmission case may be inadequate. If this condition exists, it could eventually result in a failure in the brake pipe, causing loss of brake fluid and partial loss of braking action.

NHTSA · Estados Unidos5 de abr. de 197979V090000Anos-modelo 1980Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoInteriorNA

Seats And Restraints

On certain vehicles, the front seat back locks may not lock under forward load conditions and are therefore not in compliance with CMVSS 207 - Seat Anchorages.

Transport Canada27 de fev. de 19841984027Anos-modelo 1984Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoInteriorNA

Seats:Front assembly:Recliner

Some vehicles have bucket seat back locks that do not conform to federal motor vehicle safety standard 207, anchorage of seats. In event of a crash, the seat back lock may not function.

NHTSA · Estados Unidos6 de fev. de 198484V011000Anos-modelo 1984Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoFreiosNA

Recall

These vehicles may experience premature rear wheel skid when the brake pedal is applied. The absence of any corrective steering or braking action on the part of the driver could cause the rear of the vehicle to skid out of its lane of travel.

Transport Canada28 de mar. de 19831983035Anos-modelo 1980Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoFreiosNA

Service brakes, hydraulic:Foundation components

Under certain conditions, vehicles may experience premature rear wheel skid during braking. Rear wheel skidding is most likely to occur on a wet or slick surface.

NHTSA · Estados Unidos24 de fev. de 198383V018000Anos-modelo 1980Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoFreiosNA

Service brakes, hydraulic:Foundation components:Hoses, lines/piping, and fittings

Rear brake hoses may have been manufactured incorrectly when the metal end fittings were installed. Some rear brake hoses may separate from the metal end fittings when subjected to the pulling force specified by federal motor vehicle safety standard 106, "brake hoses".

NHTSA · Estados Unidos1 de jan. de 198383V007000Anos-modelo 1982Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoCâmbioNA

Recall

Vehicles with manual transmissions. A low spring load on the pawl to engage quadrant teeth of the self adjusting clutch mechanism will result in slippage and prevent clutch release when the pedal is depressed to the floor.

Transport Canada25 de ago. de 19811981089Anos-modelo 1980–1981Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoFreiosNA

Recall

Vehicles with manual transmissions. Vehicles may be equipped with defective brake proportioner valves which could cause the rear brakes to lock up prematurely during high deceleration braking. This could result in loss of vehicle control and vehicle crash without prior warning.

Transport Canada17 de ago. de 19811981087Anos-modelo 1980Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoCarroceriaNA

Recall

The terminal that attaches the engine to body ground cable to the front lower tie bar may fracture resulting in reduced voltage to body grounded electrical components and cause erratic operation of the components.

Transport Canada26 de mar. de 19811981037Anos-modelo 1981Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoElétricaNA

Electrical system:12v/24v/48v battery:Cables

The engine-to-body ground cable on certain vehicles may have been damaged during manufacture. The cable could eventually break due to the relative motion between the engine and body during vehicle operation.

NHTSA · Estados Unidos24 de mar. de 198181V038000Anos-modelo 1981Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoSuspensãoNA

Steering:Hydraulic power assist:Hose, piping, and connections

The involved vehicles may have been assembled with the power steering hose incorrectly routed. The power steering hose may then contact the exhaust manifold, resulting in deterioration and eventual failure of the hose and leakage of power steering fluid onto the exhaust manifold.

NHTSA · Estados Unidos8 de out. de 198080V129000Anos-modelo 1981Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoSuspensãoNA

Steering:Rack and pinion

The steering gear mounting plate on the involved vehicles may develop fatigue cracks at high mileage which would allow the steering gear attachment to become loose. If this condition exists, the driver may notice considerable "free play" in the steering wheel.

NHTSA · Estados Unidos17 de out. de 197979V221000Anos-modelo 1980Exibido no inglês original · tradução pendenteVer detalhes →
RecallModeradoSuspensãoNA

Recall

The steering gear mounting plate may develop fatigue cracks which would allow the steering gear attachment to become loose. The driver may notice that the steering wheel can be turned several degrees before a change in vehicle direction occurs.

Transport Canada26 de set. de 19791979161Anos-modelo 1980Exibido no inglês original · tradução pendenteVer detalhes →
Mais antigos →

Fontes: NHTSA (Estados Unidos, domínio público), Transport Canada (Open Government Licence – Canada), DVSA (Reino Unido, Open Government Licence v3.0), RappelConso e Safety Gate da UE (França, Licence Ouverte 2.0), MLIT (Japão, Licença de Dados Públicos 1.0) e MOLIT (Coreia do Sul, car.go.kr).