通报
本技术服务公告提供了清洁和修整铝制轮辋胎圈座的操作程序,适用于出现以下症状的车辆:轮胎缓慢漏气、轮胎失压、低胎压警告灯点亮、铝制轮辋胎圈座腐蚀。
🔔 注册免费账户,接收 Buick Lucerne 的邮件提醒
技术服务通报(TSB)是制造商就已知问题发给经销商的维修说明。它们不是安全召回,但常常能证实某个缺陷。
本技术服务公告提供了清洁和修整铝制轮辋胎圈座的操作程序,适用于出现以下症状的车辆:轮胎缓慢漏气、轮胎失压、低胎压警告灯点亮、铝制轮辋胎圈座腐蚀。
No Crank/No Start, Dead Battery Due to Parasitic Drain/Discharge.
This Preliminary information is to inform the dealer of a possible coolant leak from an engine expansion plug. The dealer is advised to seal and replace the core plug to correct the leak.
This Preliminary Information communication provides information to the technician that after installing a re-manufactured High Feature V6 engine the vehicle may rough running, idle surge, Check Engine Lamp or Camshaft Position sensor actuator codes. Technician will need to record the actual engine oil pressure at idle and engine compression readings. Technician will need to perform all testing listed in PIP4345A, if oil pressure and compression readings are within specifications. Technician will need to contact General Motors Technical Assistance Center for further assistance if the concern is not isolated.
This Preliminary Information communication provides information to the technician that after installing a re-manufactured High Feature V6 engine the vehicle may rough running, idle surge, Check Engine Lamp or Camshaft Position sensor actuator codes. Technician will need to record the actual engine oil pressure at idle and engine compression readings. Technician will need to perform all testing listed in PIP4345A, if oil pressure and compression readings are within specifications. Technician will need to contact General Motors Technical Assistance Center for further assistance if the concern is not isolated.
This Preliminary Information communication provides information to the technician on how to diagnose and repair vehicles that may have the Antilock Braking System, Service Traction Control System, and/or Service Stabilitrak lights are on. The Electronic Brake Control Module may have one or more of the following Diagnostic Trouble Codes C0035-C0050 with specifically symptom 18, 5A, or 0F. Technician will gain access to the correct wheel bear per the Diagnostic Trouble Code that is set. If debris is found on the magnetic encoder ring it will needed to be cleaned.
This preliminary information communication provides information to the technician on how to diagnose and repair vehicles that may have the antilock braking system, service traction control system, and/or service stabilitrak lights are on. The electronic brake control module may have one or more of the following diagnostic trouble codes c0035-c0050 with specifically symptom 18, 5a, or 0f. Technician will gain access to the correct wheel bear per the diagnostic trouble code that is set. If debris is found on the magnetic encoder ring it will needed to be cleaned.
This preliminary information communication advises the technician that a noise or a vibration in the vehicle that seems to be abnormal may not have been there when the vehicle was purchased. Technician should look for non - general motors aftermarket accessories installed on the vehicle that can cause these issues.
General motors: Due to the parasitic drain/discharge on 2011 vehicles and trucks, a no crank/no start and dead battery would occur. Cadillac sts and chevrolet volt not included. *pe
General motors: In rare occurrences a technician may find dtc p0513, an intermittent no crank/no start. This dtc may be caused by a transient voltage spike within the ecm and usually occurs on start up. The ecm must be replaced with one that was not produced in the julian date range. *pe
General motors: Various electrical concerns (inspect engine harness near brake lines). One or more of following concerns may apply-malfunction indicator lamp/check engine light, antilock brake system indicator. *pe
Soft brake pedal. *nj
Excessive torque steer to the right. *tt
Coolant leak at rear of engine. *tt
Steering column damage when suspending cradle from intermediate shaft. *tt
Crank no start, license plate or aux tail lamps inoperative, service suspension message. *tt
Underhood noise, loose or out of position power steering outlet hose, or (p/s) fluid leak from power steering outlet hose. *tt
Diagnostic trouble code (dtc) c0710 steering wheel position sensor (swps) signal, service stability system message on driver information center (dic). *tt updated 2/15/08. *nj
The clip that holds the power steering return hose to the frame rail can move causing the hose to be loose or out of position. *tt
No start, prndl misadjusted, or other transmission concerns. *tt
Power steering leaks. *tt
该技术服务通告为经销商/技术人员提供有关 OnStar Module 2G 退役(Sunset)的信息。
该服务公告提供了有关诊断长时间静置和/或处于寒冷气候条件下的蓄电池,以及对这些蓄电池进行测试的信息。
该技术公告建议:如果在冷却系统中发现机油,技术人员应多次冲洗冷却系统,并更换可能因系统中存在机油而受到污染的部件。
This bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。