471 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2000–2006), typically at around 70,000 miles. Most often named: instrument cluster/panel (46%). Reported consequences: 7 crashes, 25 fires, 5 injuries.
148 owners in the United States reported problems with the engine and cooling of this car to NHTSA (model years 2000–2006), typically at around 74,000 miles. Most often named: engine (30%). Reported consequences: 2 crashes, 7 fires, 2 injuries.
NHTSA, the US road safety agency, received a defect petition (DP05009) about this problem on 20 December 2005 for 2000–2003 models; it was closed on 31 May 2006 without a recall.
On certain vehicles, the interface between the electrical terminals of the Heating, Ventilation, and Air Conditioning (HVAC) blower relay resistor module and the wiring connector (which powers the module) may be incapable of conducting higher current levels for sustained periods of operation. In addition, moisture and other contaminants (such as road de-icing materials) may enter the fresh air intake plenum and contact the internal circuit of the module or corrode the terminals. These conditions may cause the relay resistor module or wiring connector to overheat, causing various symptoms such as: the HVAC blower may not function on certain or all blower speed settings; a burning-plastic smell or smoke may be present in the vehicle, or; the HVAC blower may run continually with the ignition in the OFF position. These warning signs could, in certain instances, be leading indicators of an impending vehicle fire, which could result in property damage and/or personal injury. Correction: Owners will be provided with additional warranty coverage for the blower motor resistor module/wiring connector overheating condition. Under this "special warranty coverage", should this condition occur within 10 years or 240,000 km from first vehicle registration, dealers will install a replacement blower motor resistor and resistor module connector.
On certain pickup trucks equipped with an 8.1l v8 engine, the crankshaft position can operate intermittently or fail completely. If the sensor operates intermittently, the ses light may illuminate and the vehicle may run rough. The engine may stall, and if so, may re-start immediately or after a cool down period.
On certain trucks equipped with an 8.1l v8 (rpo l8-vin g) engine have a condition in which the engine fuel rail pulse damper retainer clip may fracture resulting in inadequate retention of the damper.
One of the following concerns when programming the mileage or the hours into an exchange instrument panel cluster that is received from an electronic service center (esc). *nj