Steering:Hydraulic power assist:Hose, piping, and connections
在部分配备2.4升发动机的乘用车上,高压助力转向软管可能会过早热老化并出现泄漏。
🔔 注册免费账户,接收 Chrysler Cirrus (所有代) 的邮件提醒
在部分配备2.4升发动机的乘用车上,高压助力转向软管可能会过早热老化并出现泄漏。
Vehicle description: Passenger vehicles. Some of these vehicles may have been built with an inadequate weld between the right front brake hose block and the stand-off bracket.
Vehicle description: Passenger vehicles. The rear seat belt anchor does not achieve the loading required by fmvss no. 210, "seat belt assembly anchorages."
Vehicle description: Passenger vehicles. The lower control arm ball joint can separate due to loss of lubrication.
In certain vehicles, the engine cylinder head oil galley plug does not seal properly and engine cylinder head oil is not adequately retained.
An engine cylinder head oil galley plug may not be adequately retained. Inadequate retention of the plug may result in oil leakage which could potentially cause a fire in the engine compartment. Correction: An expansion plug and retaining bracket will be installed over the suspect cylinder head oil galley plug.
在某些乘用车上,地板式换挡杆的点火-驻车联锁可能失效,导致在拔出钥匙的情况下仍可将换挡杆从驻车(P)位置推出。联锁失效时,也可能在换挡杆未置于驻车位置时允许拔出钥匙。
Vehicle description: Passenger vehicles. The right rear brake tube can contact the exhaust system clamp and wear a hole in it.
On certain vehicles, incorrect weld wire, in combination with the stainless steel shell of the catalytic converter, will cause rusting at the weld joints and premature failure to the converter assembly. Correction: Dealers will replace the catalytic converter.
Note: Vehicles equipped with a floor mounted automatic transmission shift lever. A combination of applying a mis-adjusted shifter release button with a low force attempt to shift out of park with the key in the locked position may break the connecting pin in the shifter. If this happens, the "ignition-park" interlock system will not function. Correction: The console shift interlock mechanism will be inspected for proper function. Any vehicles that are not functional after the inspection will have the shift mechanism and cable replaced with a current production "self adjusting" design.
Vehicle description: Passenger vehicles equipped with automatic transmissions. The adjustment of the cable connecting the console shifter mechanism to the ignition key can cause a trapped key condition which can result in a low force required to depress the shift button. A combination of applying a mis-adjusted release button with a low force attempt to shift out of park with the key in the locked position, can break the connecting pin in the shifter.
These vehicles may not comply with c.M.V.S.S. 210 - seat belt assembly anchorages. The rear seat belt anchor may not achieve the loading required by the standard during testing. Correction: The rear outboard seat belt anchor floor attachments will be inspected for orientation and repositioned if required.
Certain vehicles do not comply with CMVSS 1103 - exhaust emissions. The calibration of the Powertrain Control Module (PCM) may fail to adequately control CO emissions. Correction: PCM will be reflashed with a new calibration.
On certain vehicles, the lower control arm ball joint may separate due to loss of lubrication. This separation could result in loss of vehicle control and a crash without prior warning. Correction: Ball joint end housing cover seal will be inspected for leakage and the rubber boot will be inspected for damage. If the cover seal leaks or the boot is damaged, the lower control arm will be replaced.
The primary/secondary hood latch spring may not remain in position during hood closing, which can result in loss of both the primary and secondary latch function. Loss of hood function can result in a hood fly-up condition. Correction: The secondary hood latch spring will be replaced with one having a longer end hook.
Vehicle description: Passenger vehicles. The secondary hood latch spring can disengage from its retention hole if the hood is slammed shut.
On certain vehicles, the brake master cylinder may leak brake fluid due to a damaged double lip rear piston seal. Brake fluid leakage may result in diminished effectiveness of one portion of the split brake system. Correction: Rear brake master cylinder piston assemblies will be replaced.
Corrosion of the abs hydraulic control unit may cause the solenoid valves to stick in the open position. If either front wheel valve sticks, the vehicle may tend to deviate from a straight stop when the brakes are applied. Correction: A plate will be installed on the abs hydraulic control unit and silicone grease injected into the solenoid cavity to eliminate the potential for this condition.
The brake master cylinder can leak brake fluid due to a damaged double lip rear piston seal.
Corrosion of the abs hydraulic control unit can cause the solenoid valves to stick in the open position.
车辆描述:部分乘用车、皮卡和运动型多功能车(SUV)不符合FMVSS No. 225《儿童约束系统固定装置》的要求。部分此类车辆的车主手册缺少分步操作说明(包括示意图),无法指导用户将儿童约束系统的上拉带正确连接到上拉带固定点。
Vehicle description: Passenger vehicles. The affected vehicles were built with unpainted fuel tank straps.
Vehicle description: Passenger vehicles. The affected vehicles were built with incorrect child lock instruction labels.
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。