Vehicle description: Certain van, wagon, pickup trucks, passenger and sport utility vehicles, fail to comply with requirements of fmvss no. 209, "seat belt assemblies." the front seat belt retractor may not comply with the requirements of the standard.
On certain vehicles, the passenger side air bag inflator assembly contains an incorrect inflator charge. This condition could increase the risk of a passenger occupant injury in the event of a crash. Correction: Passenger air bag modules will be replaced.
Vehicle description: Passenger vehicles built with 3.5l engines. The fuel injection delivery system can leak fuel from some of the sealing o-rings or from hair line cracks in the thermoset fuel injection rail.
The "nitrile" rubber compound "o-rings" used to seal the interface of the fuel injector rail supply, return and cross over tubes may degrade and allow fuel to leak into the engine compartment. This could result in an engine compartment fire. Correction: The engine fuel rail will be replaced with a rail that contains the 1994 style fluorocarbon ""o-rings" at the fuel supply, return and cross over tubes.
Vehicle description: Passenger vehicles built with 3.3l engines. The 'o-rings' used to seal the interface of the fuel injector rail supply, return and cross over tubes are not as robust as those used in later model years. Deterioration of the 'o-rings' can cause fuel leakage.
Vehicle description: Certain passenger vehicles (non-sunroof only) fail to comply with the requirements of federal motor vehicle safety standard no. 201, "occupant protection in interior impact."
Vehicle description: Passenger vehicles. The molding flash on the primary lever may prevent the operation of the g-lock and tilt lock functions on some of the driver's side retractors.
The right side steering tie rod may rub against the automatic transmission wiring harness insulation resulting in a short circuit. This could cause electrical system malfunctions, including engine die out and an inoperative park/starter interlock system. Correction: A revised wiring harness bracket and plastic convolute sleeve will be installed to protect the transmission wiring harness.
The right steering tie rod can rub through the automatic transmission wiring harness causing a short circuit which results in electrical system malfunctions including engine stalling and an inoperative park/starter interlock system.