发动机及发动机冷却:发动机
发动机气门盖垫片可能会脱位,导致发动机油泄漏。
🔔 注册免费账户,接收 Dodge Aries (所有代) 的邮件提醒
发动机气门盖垫片可能会脱位,导致发动机油泄漏。
搭载2.2升或2.5升EFI(非涡轮增压)发动机的车辆,气门室垫片可能漏油,可能导致发动机舱火灾。更正:气门室盖垫片将更换为改良版盖板,并以RTV密封剂替代垫片。
配备2.2升丙烷发动机的车辆,加注阀处的加注和封水接头(80%加注位)可能会腐蚀。在存在点火源的情况下,可能导致火灾或爆炸。更正:疑似车辆将更换加注和止水软管,改进防护罩并对接头进行防锈处理。
Note: These vehicles were sold to bell, d.N.D., and r.C.M.P. These vehicles were built with a fuel hose which may have had its fittings aligned in a manner which could cause abrasion damage due to engine rocking and result in a fuel leak, thereby creating the risk of fire.
The potential for fuel leakage exists in the engine compartment at the fuel reservoir seam and its hose connections. The fuel reservoir is a silver colored can mounted to the air cleaner.
On certain vehicles, hydraulic brake tube may interfere with exhaust system hangar bolt and eventually result in brake fluid leakage. This could create a partial loss of braking capability. Should this occur the brake warning light on the instrument panel will warn driver.
Hydraulic brake tube routing to the rear wheels may alloow interference between the tube and the rear park brake cable. Resulting abrasion could cause tube failure and partial loss of braking capability. The instrument panel light will provide warning of the partial loss.
Brake fluid may contain an excessive amount of water. This can cause degradation of braking performance or brake failure under a variety of circumstances.
如果在使用盐分辅助除雪的操作中,前悬挂横梁在下控制臂后枢轴支架处可能会腐蚀并失效。
在某些车辆上,横梁在下控制臂连接处可能异常腐蚀。这可能导致下控制臂分离并失去车辆控制。更正:如果腐蚀严重,横梁将进行检查和更换。其余部分将安装横梁固定支架。
These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions. Plugged choke vacuum delay valve. Note: Vehicles equipped with 2.2 litre carbureted engines.
Battery cap vents may be partially or completely blocked with plastic flashing. Consequence of defect: A build up of internal gas pressure could occur which could result in case rupture, particularly during post charging. Should a person be in the vicinity of the battery when the case ruptures, they may be injured by the released gases and/or acid.
These vehicles may not comply with cmvss 1103 - exhaust emissions.
These vehicles may not comply with cmvss 1103 - exhaust emissions.
液压制动管位于两个后轮的位置会导致管子与后悬挂拖臂枢轴支架之间产生干涉和摩擦。
Hydraulic brake tubing routed to the left rear wheel brake system may have been bent out of shape during assembly and could chafe against the exhaust system hanger bolt.
On the involved vehicles, improper routing of the hydraulic brake tube could cause it to chafe against the park brake cables. Eventually, the brake tube may fail and brake fluid leakage may occur.
The brake hydraulic system bay be equipped with brake fluid containing an excess of water.
涉事车辆可能使用了锻造或热处理不良的螺栓,用于将前悬挂球节连接到转向节。部分螺栓可能最终失效,导致球头分离,影响车辆方向控制。
Clamp bolts installed on certain vehicles may contain cracks. Eventually these bolts may break through, causing separation of the ball joint from the steering knuckle.
自动速度控制开关可能会卡在“恢复”位置,限制返回的移动。这样正常刹车踏板操作就无法关闭系统。
The stop lamp switches installed on the subject vehicles may have inadequate internal switch contact pressure due to an incorrect formation of the switch contact terminals. This lack of switch contact continuity may render the (stop) brake warning lights inoperative.
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。