电气系统:起动机总成
车辆描述:乘用车。起动机总成采用了存在问题的塑料接线端子座制造,安装到起动机本体上之后,这些端子座可能出现应力裂纹。端子座与起动机本体分离后,未经熔断器保护的正极端子可能与邻近表面接触,从而形成搭铁通路。
🔔 注册免费账户,接收 Dodge Neon (所有代) 的邮件提醒
车辆描述:乘用车。起动机总成采用了存在问题的塑料接线端子座制造,安装到起动机本体上之后,这些端子座可能出现应力裂纹。端子座与起动机本体分离后,未经熔断器保护的正极端子可能与邻近表面接触,从而形成搭铁通路。
转向柱联轴器在车辆底盘受到严重撞击时可能会脱开。这将导致转向控制丧失。纠正措施:将更换为在撞击时会发生压溃的转向柱联轴器。
Vehicle description: Passenger vehicles. The steering column coupler can become disconnected when the vehicle experiences an underbody impact.
The fuel and rear brake tubes may experience accelerated corrosion between the tubes and a rubber isolator. Failure of these tubes could result in fuel leakage and/or diminished braking capacity. Correction: Brake, fuel supply and fuel vapour tubes will be inspected for the presence of red corrosion. Any tubes showing evidence of red corrosion will be replaced. In addition vehicles will have the rubber isolator replaced with a plastic clip.
The fuel and rear brake tubes can experience accelerated corrosion between the tubes and a rubber isolator.
The abs brake master cylinder rear seal allows air to enter the brake system, causing spongy brakes or partial brake system loss.
Vehicle description: 乘用车。在有机油和高温存在的情况下,制动助力器真空软管可能会膨胀并从进气歧管上松脱。
Vehicle description: Passenger cars. Vapors from the positive crankcase ventilation (pcv) system can condense and freeze inside of the throttle body when the vehicle is operated in extremely cold ambient temperatures.
Vehicle description: Passenger vehicles. The front suspension lower control arms may have been inadequately welded between the pivot tube and the arm.
Vehicle description: Passenger vehicles. Some frontal (passenger side) air bags may not inflate properly.
Vehicle description: 乘用车。后悬架横梁可能缺少点焊。
这些车辆不符合 C.M.V.S.S. 1103 尾气排放标准。固态风扇继电器可能因热相关的电气过应力而失效,导致风扇停转,车辆过热。如果车辆过热,排放和驾驶性能都可能受到影响。纠正措施:更换固态继电器,并在风扇线路中加装一根二极管跨接线。
The circuit design in the air bag electronic control module may allow the potential for inadvertent air bag deployment upon vehicle ignition shut down. Correction: The air bag electronic control module will be replaced with a module that incorporates the latest production redesigned circuit to prevent this condition.
The electrical circuit design allows the potential for an inadvertent air bag deployment upon vehicle ignition shut down.
On certain vehicles, the brake master cylinder may leak brake fluid due to a damaged double lip rear piston seal. Brake fluid leakage may result in diminished effectiveness of one portion of the split brake system. Correction: Rear brake master cylinder piston assemblies will be replaced.
The brake master cylinder can leak brake fluid due to a damaged double lip rear piston seal.
An engine wiring harness may short due to contact with the exhaust gas recirculation (egr) tube. Shorting of the harness may cause various electrical malfunctions, including engine die out. Correction: Wiring harness will be properly routed and any damaged wiring will be replaced.
An engine wiring harness can short circuit due to contact with the exhaust gas recirculation tube..
Moisture can get into the powertrain control module (pcm) causing driveability malfunctions, including stalling.
The rear brake hose mounting bracket screws can fail allowing the brake hoses to move out of position. The unrestrained hoses are then susceptible to damage which could result in brake fluid leakage.
Vehicles may experience an engine die out due to moisture in the powertrain control module (pcm) caused by inadequate potting material sealing. Also, the rear brake lines may be out of position due to failure of the mounting bracket screws. Correction: Powertrain control module and rear brake line bracket screws will be replaced on affected vehicles.
Vehicles may have been built with a rear abs brake master cylinder seal that may allow air ingestion into the cylinder and cause spongy brake feel or partial brake system loss. Correction: Vehicles will be inspected and suspect master cylinders will be replaced.
Vehicle description: Passenger vehicles built with 15" wheels, equipped with an r/t package. Certain vehicles were equipped with an incorrect tire placard. The vehicles were equipped with p195/50r16 tires but the tire placard indicated that the recommended tire sizes were p185/65r14 and p185/65r15. This does not comply with the requirements of fmvss no. 110, "tire selection and rims." Translation: 车辆描述:配备15英寸车轮并带有r/t套件的乘用车。部分车辆装配了错误的轮胎铭牌。这些车辆装配的是p195/50r16轮胎,但轮胎铭牌标明的推荐轮胎规格为p185/65r14和p185/65r15。这不符合fmvss no. 110“轮胎选择和轮辋”的要求。
Vehicle description: Passenger vehicles equipped with the sport appearance package fail to comply with the requirements of fmvss 110, "tire selection and rims." certain vehicles built with 16" wheels and tires were equipped with the incorrect tire placard.
车辆描述:部分乘用车、皮卡和运动型多功能车(SUV)不符合FMVSS No. 225《儿童约束系统固定装置》的要求。部分此类车辆的车主手册缺少分步操作说明(包括示意图),无法指导用户将儿童约束系统的上拉带正确连接到上拉带固定点。
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。