燃油系统
燃油供应管路系统中安装的燃油压力调节器可能是导致燃油泄漏的原因,进而可能引发发动机舱火灾。更正:燃油供应系统的压力调节器及相关管路将更换为另一种结构形式的部件。
🔔 注册免费账户,接收 Dodge Omni (所有代) 的邮件提醒
燃油供应管路系统中安装的燃油压力调节器可能是导致燃油泄漏的原因,进而可能引发发动机舱火灾。更正:燃油供应系统的压力调节器及相关管路将更换为另一种结构形式的部件。
Pressure regulator installed in the fuel supply plumbing system leaks fuel into the engine compartment.
发动机气门盖垫片可能会脱位,导致发动机油泄漏。
搭载2.2升或2.5升EFI(非涡轮增压)发动机的车辆,气门室垫片可能漏油,可能导致发动机舱火灾。更正:气门室盖垫片将更换为改良版盖板,并以RTV密封剂替代垫片。
Fuel leakage may occur in low ambient temperature operation at connections of an engine compartment fuel supply hose to the pressure regulator and to the fuel rail.
On certain vehicles equipped with a 2.2 Litre turbo engine, an inadequately tightened fuel hose clamp at the fuel system pressure regulator could result in fuel leakage and provide the potential for an engine compartment fire.
An engine compartment fuel hose routed to the fuel system pressure regulator may have an inadequately tightened hose clamp. Consequence of defect: The fuel hose could leak and result in an engine compartment fire.
The potential for fuel leakage exists in the engine compartment at the fuel reservoir seam and its hose connections. The fuel reservoir is a silver colored can mounted to the air cleaner.
Rear suspension trailing arm-to-hanger bracket pivot bolts may fail from stress corrosion cracking possibly caused by processing deviations in the construction of the pivot bolt.
These vehicles may experience a rear suspension trailing arm to hangar bracket pivot bolt failure, which could result in partial separation of the rear suspension from the vehicle. This could result in loss of vehicle control and a vehicle crash without prior warning. Correction: Involved vehicles will have both trailing arm pivot bolts replaced with properly processed bolts.
These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions. Plugged choke vacuum delay valve. Note: Vehicles equipped with 2.2 litre carbureted engines.
Battery cap vents may be partially or completely blocked with plastic flashing. Consequence of defect: A build up of internal gas pressure could occur which could result in case rupture, particularly during post charging. Should a person be in the vicinity of the battery when the case ruptures, they may be injured by the released gases and/or acid.
An emissions system valve may allow an overly rich mixture (excessive fuel) in the engine during deceleration. The mixture of air and excessive fuel can cause the engine to stall while stopping, coasting, or turning.
These vehicles may not comply with cmvss 1103 - exhaust emissions.
涉事车辆可能使用了锻造或热处理不良的螺栓,用于将前悬挂球节连接到转向节。部分螺栓可能最终失效,导致球头分离,影响车辆方向控制。
Clamp bolts installed on certain vehicles may contain cracks. Eventually these bolts may break through, causing separation of the ball joint from the steering knuckle.
On the involved vehicles, the bolts used to attach the front suspension ball joints to the control arms may fail due to a bolt section crack condition. The ball joint may separate from the arm possibly affecting vehicle directional control.
自动速度控制开关可能会卡在“恢复”位置,限制返回的移动。这样正常刹车踏板操作就无法关闭系统。
The engine compartment fuel line hoses installed on certain vehicles were fabricated from a defective rubber compound. When subjected to continuous high underhood temperatures, these hoses may become brittle and crack.
The hood secondary latch on the involved vehicles may be subject to binding due to variations in the latch and its mounting base assembly. A problem could occur if the primary latch became inoperative or was not properly engaged.
Steering wheel horn pads do not contain the horn symbol display as required by fmvss 101.
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。