On certain vehicles, the transmission fluid temperature could exceed the melting point of the connector which retains the fluid line to the transmission. Should this occur, the fluid line may become disconnected from the transmission and fluid may spray onto the exhaust manifold, possibly resulting in a fire. Correction: The connector fittings on the high temperature side of the transmission fluid cooler line will be replaced with connectors incorporating a stainless steel retainer.
On certain vehicles, the fasteners which secure the generator cartridge fuse to the Power Distribution Centre (PDC) may have an improper clamp load. Improper clamping may result in arcing at the connection which may potentially cause a fire in the engine compartment. Correction: Generator cartridge fuse fasteners will be properly tightened.
On certain vehicles equipped with anti-lock brakes, the hydraulic control unit may contain an undersized brake return check valve. This could result in high pedal effort ABS stops and the check valve locking in a continuous return mode, thereby defeating the front wheel ABS function. Correction: Vehicles will be inspected and the return check valve will be replaced on suspect units.
On certain vehicles, the automatic transmissions may contain a park sprag rod assembly that may stick in the tooth butt (unengaged) position. If this occurs the vehicle may roll from a parked position and cause a crash. Correction: Vehicles will be inspected and suspect park sprag rod assemblies will be replaced.
On certain vehicles, the rear axle shafts may contain brake drum/wheel studs that are not concentric with the drum pilot diameter. This could prevent full seating of the drum to the axle shaft flange which may cause wheel stud nut loosening. Loss of a wheel could result in a vehicle crash without prior warning. Correction: Axle shafts will be inspected and replaced if necessary.
Certain vehicles may have been assembled with a defective ignition switch which could provide the potential for starter actuation when the switch is in the accessory position. Engine start-up will not occur but limited vehicle movement may occur if the starter is unexpectedly actuated with the transmission in a drive gear and the parking brake not engaged.
Certain vehicles do not comply with CMVSS 1103 - exhaust emissions. Vehicle emission control information label specifies an incorrect spark plug for this application. Correction: Correct label and installation instructions will be mailed to owners.
Certain vehicles do not comply with CMVSS 120 - tire selection and rims for vehicles other than passenger cars. Certification Label specifies a minimum front tire/wheel which is larger than actually required. Correction: New labels will be sent to owners.