安全气囊:正面:副驾驶侧:充气模块
Mitsubishi Motors North America, Inc. (MMNA) 正在召回部分2001至2002年款的Chrysler Sebring和Dodge Stratus车辆,这些车辆配备米色内饰。受影响的车辆此前曾因召回问题使用了错误的零件进行维修。如果乘客侧前排安全气囊弹出,而乘客侧遮阳板处于特定折下位置,该错误零件可能无法防止乘客侧遮阳板脱落。
🔔 注册免费账户,接收 Dodge Stratus (所有代) 的邮件提醒
Mitsubishi Motors North America, Inc. (MMNA) 正在召回部分2001至2002年款的Chrysler Sebring和Dodge Stratus车辆,这些车辆配备米色内饰。受影响的车辆此前曾因召回问题使用了错误的零件进行维修。如果乘客侧前排安全气囊弹出,而乘客侧遮阳板处于特定折下位置,该错误零件可能无法防止乘客侧遮阳板脱落。
Mitsubishi Motors North America, Inc.(MMNA)正在召回部分2000至2005年款Eclipse车辆,这些车辆的生产日期为1999年4月5日至2004年12月17日;2001至2005年款Eclipse Spyder车辆,生产日期为2000年1月19日至2005年3月18日;2001至2005年款Chrysler Sebring车辆,生产日期为2000年4月17日至2005年2月21日;以及2001至2005年款Dodge Stratus车辆,生产日期为2000年4月17日至2005年2月22日。在受影响的车辆中,乘客侧遮阳板可能处于折下的位置,如果乘客正面安全气囊展开,乘客侧遮阳板可能会脱落。
在部分配备2.4升发动机的乘用车上,高压助力转向软管可能会过早热老化并出现泄漏。
On certain 2-door passenger vehicles, the fuel return line hose fitting on the electric fuel pump may be improperly molded.
On certain passenger vehicles, the fuel return line hose fitting on the electric fuel pump may be restricted, causing excessive fuel pressure to build up in the fuel injection system. Excessive fuel pressure may result in a leak in the fuel return hose.
Vehicle description: Passenger vehicles. A nut in the steering gear assembly was not properly tightened, resulting in symptoms ranging from steering wheel vibration to stiff steering, and in the worst case, no ability to turn left.
Vehicle description: Passenger vehicles. Some of these vehicles may have been built with an inadequate weld between the right front brake hose block and the stand-off bracket.
Vehicle description: Passenger vehicles. The rear seat belt anchor does not achieve the loading required by fmvss no. 210, "seat belt assembly anchorages."
Vehicle description: Passenger vehicles. The lower control arm ball joint can separate due to loss of lubrication.
In certain vehicles, the engine cylinder head oil galley plug does not seal properly and engine cylinder head oil is not adequately retained.
An engine cylinder head oil galley plug may not be adequately retained. Inadequate retention of the plug may result in oil leakage which could potentially cause a fire in the engine compartment. Correction: An expansion plug and retaining bracket will be installed over the suspect cylinder head oil galley plug.
在某些轿车和敞篷车型上,右转向节可能在零部件制造过程中受到损伤。
On certain sedans, the left and right rear outboard retractor and turning loop bolts on the seat belts may not have been properly tightened.
在某些乘用车上,地板式换挡杆的点火-驻车联锁可能失效,导致在拔出钥匙的情况下仍可将换挡杆从驻车(P)位置推出。联锁失效时,也可能在换挡杆未置于驻车位置时允许拔出钥匙。
Vehicle description: Passenger vehicles equipped with automatic transmissions. A hose manufacturing process allowed the reinforcement yard to breach the inner layer of some automatic transmission hoses weakening the inner wall which could result in leakage of the automatic transmission fluid.
Vehicle description: Passenger vehicles. A number of incorrect driver side seat mounting bolts were installed into vehicles.
Vehicle description: Passenger vehicles. The outer layer only of this 3-layer fuel return hose does not contain the desired ozone protection due to a processing error.
Vehicle description: Passenger vehicles. Passenger air bags were built with suspect aluminum extrusion sections which may not retain the air bag door during an air bag deployment event.
Vehicle description: Passenger vehicles. The harness for the crankshaft position sensor could come in contact with a new protective shield causing a grounded circuit.
Vehicle description: Passenger vehicles. The right rear brake tube can contact the exhaust system clamp and wear a hole in it.
On certain vehicles, incorrect weld wire, in combination with the stainless steel shell of the catalytic converter, will cause rusting at the weld joints and premature failure to the converter assembly. Correction: Dealers will replace the catalytic converter.
Certain vehicles may not comply with CMVSS 1103 - exhaust emissions. During calibration, the purge flow monitor may have been inadvertently disabled in the area of purge flow detection. Correction: Powertrain Control Module will be reflashed with proper calibrations.
Note: Vehicles equipped with a floor mounted automatic transmission shift lever. A combination of applying a mis-adjusted shifter release button with a low force attempt to shift out of park with the key in the locked position may break the connecting pin in the shifter. If this happens, the "ignition-park" interlock system will not function. Correction: The console shift interlock mechanism will be inspected for proper function. Any vehicles that are not functional after the inspection will have the shift mechanism and cable replaced with a current production "self adjusting" design.
Vehicle description: Passenger vehicles equipped with automatic transmissions. The adjustment of the cable connecting the console shifter mechanism to the ignition key can cause a trapped key condition which can result in a low force required to depress the shift button. A combination of applying a mis-adjusted release button with a low force attempt to shift out of park with the key in the locked position, can break the connecting pin in the shifter.
These vehicles may not comply with c.M.V.S.S. 210 - seat belt assembly anchorages. The rear seat belt anchor may not achieve the loading required by the standard during testing. Correction: The rear outboard seat belt anchor floor attachments will be inspected for orientation and repositioned if required.
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。