On certain vehicles, the steering wheel armature may crack due to fatigue and separate from the centre hub attachment to the steering column. This could adversely affect steering control and result in a possible crash. Correction: Steering wheels exhibiting cracks will be replaced. All other involved vehicles will have a reinforcement plate installed to prevent steering wheel separation in the event cracking occurs.
On certain vehicles, the (takata) ABS plastic front seat belt release buttons may break allowing plastic pieces to fall into the buckle assembly. If this should happen, a no latch, false latch or failure to unlatch condition could occur creating the risk of personal injury in the event of a crash or sudden stop. Correction: Front seat belt buckles will be repaired or replaced as necessary.
On certain vehicles, a solder joint on the engine oil pressure sending unit could fail and leak engine oil. This could create the potential for an engine compartment fire.
On certain vehicles equipped with intercooled turbo-diesel engines, the fuel injector pump fulcrum lever pin may break causing loss of throttle control and resulting in a full fuel level (maximum speed) condition. This could result in loss of vehicle control and a crash without prior warning. Correction: Fuel injection pump will be replaced with a new pump using a revised fulcrum pin and pin insertion method.
The parking brake cable springs are too long, which can cause full compression of the return spring before full engagement of the brake pads to the drum when the parking brake is applied. The amount of force applied between the pads and the drum may also decrease with rear pad wear and such deterioration would not be evident to the vehicle operator during parking brake application.
On certain vehicles, the master cylinder may have been overstressed and cracked during cylinder manufacture. A cracked cylinder may fail during braking resulting in loss of vehicle braking capability. This could result in a vehicle crash without prior warning.
Certain vehicles may have been assembled with a defective ignition switch which could provide the potential for starter actuation when the switch is in the accessory position. Engine start-up will not occur but limited vehicle movement may occur if the starter is unexpectedly actuated with the transmission in a drive gear and the parking brake not engaged.