通报
Rough idle, rolling idle, stall, high idle, or back fire mainly after a cold start. Also hesitation or surge at steady cruise, or malfunction indicator lamp (mil) illuminated condition. *tt *jb
🔔 注册免费账户,接收 Ford 福克斯 (所有代) 的邮件提醒
技术服务通报(TSB)是制造商就已知问题发给经销商的维修说明。它们不是安全召回,但常常能证实某个缺陷。
Rough idle, rolling idle, stall, high idle, or back fire mainly after a cold start. Also hesitation or surge at steady cruise, or malfunction indicator lamp (mil) illuminated condition. *tt *jb
**部分 2014-2020 款多车型 3G 远程信息处理控制单元升级至 4G 升级套件** **本补充通告的原因** **项目条款与紧急程度 / 截止日期:** 项目延期至 2023 年 7 月 31 日。 **服务措施:** o 现需使用 IDS 128 或更高版本,以解决遇到的各种编程问题。 o C-MAX Energi 车辆现可使用新软件和硬件进行维修。 **工时定额:** C-MAX 工时已更新。 **零件需求 / 订购信息:** o C-MAX 4G 升级套件现已可订购,并采用新的零件号。 o MKX 后座椅靠背螺母的索赔数量已更新。 **技术信息更新:** o 确保使用 IDS 128 或更高版本。 o 不再需要切换代客模式(Valet Mode)。 o 现已提供 C-MAX Energi 的操作说明。 **车主通知:** 未维修车辆的车主将于 2023 年 4 月 17 日当周邮寄通知函。 **取送车服务:** 新增客户确认表。在订购套件前,请与客户共同审阅表格内容;在为 Focus BEV、C-MAX 和 Fusion Energi 车辆安装前,须取得客户签名。
2017 vehicles equipped with a 2.0L GTDI, 2.3L GTDI, or 2.5L PFI engine will either be equipped with a diamond washer on each side of a smooth-faced crankshaft timing sprocket (early build), or a crankshaft timing sprocket with laser etched faces and no diamond washers (late build). If equipped, diamond washers should be cleaned, inspected and reused, if undamaged. Diamond washers should never be installed along with a laser etched crankshaft timing sprocket. Related WSM procedure information is in the process of being updated.
Some 2016-2017 Ford/Lincoln vehicles SYNC 3 may exhibit an intermittent blank screen. Check for SYNC software update under the OASIS Tab SYNC selection. If update is available refer to WSM, Section 415-00 and update APIM software. During the update process the SYNC status bar shows Updating System Software for approximately 30 minutes. After Installation Complete pop-up appears, remove USB flash drive and install into IDS tool to update Ford database. Perform a complete ignition cycle by turning the key off for 5 minutes which is critical for a successful installation. If no updates are available or blank screen is present after an update refer to WSM, Section 415-00 for diagnosis or SYNC 3 intermittent blank screen GSB for tips. For claiming, use causal part 14G371 and applicable labor operations in section 10 of the SLTS manual.
Some Focus Vehicles built on or after 21-Jul-2016 thru 15-Sep-2016 equipped with the DPS6 Transmission exhibiting concerns of shift quality may have an incorrectly aligned clutch actuator spring retainer (7515). While performing transmission or clutch repair on vehicles within these date ranges please Refer to Works Shop Manual (WSM) 307-01A Removal and Installation, Clutch Actuator for proper installation and alignment of these Spring Retainers.
Some 2017 Focus vehicles equipped with 1.0L Gasoline Turbo Direct Injection (GTDI) engines built on 27-Feb-2017 and through 12-Apr-2017 may exhibit excessive engine idle vibrations. Inspect the engine torque restrictor installed part numbers. Automatic transmission equipped vehicles, should have BV61-6P082-CB installed. Manual transmission vehicles should have CV61-6P082-DC installed. Refer to Workshop Manual (WSM), Section 303-08 for remove instructions. For claiming, use causal part 6068 and applicable labor operations in section 06-Engine of the service labor time standards (SLTS) manual.
Some 2016 focus vehicles may not successfully complete reprogramming or programmable module installation (pmi) of the bcm. Make certain the integrated diagnostic system (ids) is at release 103.03 or higher before attempting bcm programming.
Ford: At low speed driving or parking lot maneuver, vehicle may experience low power steering assist and this condition can be reprogrammed to latest calibration software. Model 2013 focus. *pe
Ford: On some vehicles, stored in diagnostic trouble code (dtc) p260 (engine off timer performance), resulting in slow network communication with cluster or insurance monitoring devices installed in vehicle onboard diagnostic trouble code. Model 2014 focus, fiesta. *pe
Ford: On some vehicles, diagnostic trouble codes (dtcs) are stored in powertrain control module memory, and using remote start feature, would have crank no start or stall, shortly after vehicle has been driven. Models 2013 c-max, focus, escape. *pe
Ford: See document search button for owner letter. During testing, active grille shutter (ags) wire harness electrical terminals was damaged, and causes engine temperature to rise, if louvers are closed and open circuit occurs, whereby warning light illuminates, chime will sound and high engine temperature, stop safely message is displayed. Model 2012 focus. *pe
Ford: See document search button for owner letter. Vehicle experience roll back when transitioning to accelerator pedal from brake pedal while on incline. Transmission would be jerky or rough when shifting. Pe
Ford: Some vehicles may exhibit a steering wander at highway speeds over 72 km/h (45 mph). Customers may indicate they have to frequently adjust the steering wheel slightly to maintain the direction of travel. *js
Ford: See document search button for owner letter. Certain model year vehicles have an improperly balanced clutch assembly. This will cause a vibration felt through the seat and/or steering will while in park, first gear and neutral position. *pe
Ford: There may be steering assist warning lights as well as well as a stored trouble code. 2012 focus. *rm
Ford:喇叭失效。在诊断出现喇叭失效(基础零件号 13832)的车辆时,请确认驾驶员安全气囊/喇叭按压板安装到位、装配正确。如果喇叭按压板安装不当或装配不正确,可能导致喇叭持续鸣响,从而损坏喇叭。*pe
Ford: Some vehicles may exhibit a parts no crank/no start condition with diagnostic trouble codes 9dtc) p1260 in the powertrain control module (pcm) and u0100 in the instrument cluster (ic). *pe
Increased brake pedal efforts required on initial stopping after cold start at high altitude. *tt
Crank no start or hard start cold. *tt
Crank no start or other driveability concerns - service tip. *tt
Diagnostic trouble code (dtc) p0068, intermittent crank no start, and hesitation/surge at 120 km/h (75 mph). *tt
Rough, rolling, or high idle or stall - mainly after cold start, engine - intake separation at rubber boots - svt models only. *tt
Some vehicles may exhibit a crank / no start, poor idle, and / or lack of power, with camshafts out of time. *tt
关于因凸轮轴卡死导致无法启动的相关信息。 *yh
Subject regarding body-rear liftgate spoiler- removal and installation tips. *jg
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。