免费阅读 · 免费账户即可贡献Anticars(2000)的继任者

Hyundai Excel

1985–1994 · 2 各代车型 · 已记录28项缺陷 · 3个市场
各代车型
车型年份
市场全部NA
Excel I · 1985–1990
Excel I · 1985–1990Excel II · 1989–1994
召回严重发动机NA

燃油系统,汽油

The vehicles failed the lateral moving barrier impact test requirements of FMVSS 301, "Fuel System Integrity." The fuel leakage from the gas tank exceeded the maximum allowable amount of spillage. Note: This is a translation task, so the content should be rendered in Chinese. Here is the translation: 车辆未能通过FMVSS 301"燃油系统完整性"标准规定的侧向移动壁障碰撞试验要求。油箱的燃油泄漏量超过了允许的最大溢出量。

NHTSA · 美国1993年11月23日93V192000车型年份 1990–1994自动翻译 · 原文:英语查看详情 →
Excel I · 1985–1990
召回严重发动机NA

Engine

Note: All 1988-89 excel vehicles sold in canada. The reed valve subassembly contained within the air control valve could fail due to corrosion allowing the hot exhaust gases to flow backward into the plastic secondary air filter case when the vehicle is being driven. These hot gases may melt the secondary air filter case and could result in an engine compartment fire. Correction: Reed valve subassembly will be replaced.

加拿大交通部1991年12月30日1991176车型年份 1988–1989以原文(英语)显示 · 翻译待完成查看详情 →
Excel I · 1985–1990
Excel I · 1985–1990
召回严重发动机NA

Fuel System

The fuel return tube clip may have been incorrectly installed allowing the fuel return hose to contact either the distributor high tension cable or the e.G.R. Valve. This could, over time, result in wear and eventual leakage at the fuel hose. The fuel leakage could result in an underhood fire. V.I.N. Range s.O.P. To kmhla31j1gu040086

加拿大交通部1986年4月18日1986044车型年份 1986以原文(英语)显示 · 翻译待完成查看详情 →
Excel II · 1989–1994
召回中等电气NA

电气系统:发电机/发电机/调节器 Wait, I should be careful: "Alternator/generator/regulator" translates to 交流发电机/发电机/调节器 in automotive context. "Alternator" is 交流发电机; "generator" is 发电机 (older DC generator term); "regulator" is 调节器. Correcting the translation: 电气系统:交流发电机/发电机/调节器

在部分车辆中,电子曲轴转角传感器的制造商保护性内部涂层不符合规格要求,这可能导致在高工作温度下出现断路。这可能会导致车辆熄火。

NHTSA · 美国1994年5月11日94V090000车型年份 1994自动翻译 · 原文:英语查看详情 →
Excel I · 1985–1990
召回中等变速箱NA

Power train:Manual transmission

The manual transmissions may lock up from insufficient lubrication of the gears in the transmission case. This can cause the drive wheels to seize and the vehicle to come to a sudden stop.

NHTSA · 美国1993年10月4日93V167000车型年份 1986–1989以原文(英语)显示 · 翻译待完成查看详情 →
Excel I · 1985–1990
召回中等发动机NA

Engine and engine cooling:Exhaust system

Deterioration of the reed valve subassembly may lead to a malfunction within the secondary air supply portion of the emission control system. The screws which attach the reeds to the reed valve subassembly may rust, and if the rusting becomes severe, the screw heads will erode and allow the reeds to separate from the reed valve subassembly. Corrosion may also occur on the reed valve subassembly, deforming the reed seats and preventing the reeds from closing properly. Separation of the reeds from the reed valve subassembly or improper closing of the reeds allow hot exhaust gases to flow backward into the plastic secondary air filter case when the vehicle is being driven. These hot exhaust gases may melt the secondary plastic air filter case.

NHTSA · 美国1991年12月31日91V225000车型年份 1986–1989以原文(英语)显示 · 翻译待完成查看详情 →
Excel I · 1985–1990
召回中等悬架NA

Suspension

The lock washer located under the nut that secures the front hub to the driveshaft may crack due to improper heat treatment. This could result in wheel bearing freeplay and bearing damage with possible wheel lock-up or brake caliper knockback. Correction: Washer will be replaced note: All units have been corrected.

加拿大交通部1990年5月18日1990072车型年份 1990以原文(英语)显示 · 翻译待完成查看详情 →
Excel I · 1985–1990
召回中等悬架NA

Wheels:Hubcap/cover

Lock washer located under the nut that secures the front hub to the drive shaft may have had improper heat treatment and could crack.

NHTSA · 美国1990年3月15日90V053000车型年份 1990以原文(英语)显示 · 翻译待完成查看详情 →
Excel I · 1985–1990
召回中等制动NA

Brakes

The possibility exists that under certain braking conditions, front brake fade may occur,thus reducing braking effectiveness. Correction: Improved semi-metallic brake pads will be installed.

加拿大交通部1987年11月27日1987127车型年份 1986–1987以原文(英语)显示 · 翻译待完成查看详情 →
Excel I · 1985–1990
召回中等制动NA

召回

The cotter pin that retains the brake clevis pin may have been omitted or incorrectly installed. If the cotter pin was omitted or if it were to fall out of the clevis pin,the vehicles' brakes would be subject to failure without warning.

加拿大交通部1986年3月29日1986033车型年份 1986以原文(英语)显示 · 翻译待完成查看详情 →
Excel I · 1985–1990
召回中等制动NA

Service brakes, hydraulic:Pedals and linkages

A cotter pin in the brake pedal to brake master cylinder linkage assembly may be missing. This pin acts as a retainer for the brake master cylinder pushrod clevis pin. Consequence of defect: The clevis pin may slide out causing the master cylinder/brake pedal linkage to become disengaged. If this linkage becomes disengaged the service brakes cannot be applied, creating the risk of a crash without prior warning.

NHTSA · 美国1986年3月17日86V043000车型年份 1986以原文(英语)显示 · 翻译待完成查看详情 →
Excel I · 1985–1990
召回轻微电气NA

Vehicle speed control

If cruise control main switch is in the on position when engine is started, system can be affected by a short duration voltage drop caused by optional hi-power (h340) radio.

NHTSA · 美国1989年6月19日89V100000车型年份 1986–1989以原文(英语)显示 · 翻译待完成查看详情 →

来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。