加热器端子可能烧毁
如果长时间满功率使用陶瓷加热器,加热器接线端子可能会烧毁。虽然迄今为止尚未发生火灾,但仍存在极小的可能性会引发燃烧。
🔔 注册免费账户,接收 Isuzu Trooper (所有代) 的邮件提醒
如果长时间满功率使用陶瓷加热器,加热器接线端子可能会烧毁。虽然迄今为止尚未发生火灾,但仍存在极小的可能性会引发燃烧。
車室暖房用ヒータにおいて、ハーネスコネクタの組合せが不適切なため、経年劣化してハ ーネスコネクタの端子部に酸化物が発生し、発熱するものがある。そのため、そのままの 状態で使用を続けると、コネクタが焼損し、最悪の場合、火災に至るおそれがある。
On certain vehicles equipped with 4WD and torque-on-demand automatic transmission, in certain high speed frontal crashes, relative movement and abrasion of internal components can cause the potential for fuel leakage due to separation of the fuel hose and fuel line or a severed fuel hose. Correction: Dealers will install a revised fuel hose.
Vehicle description: Sport utility vehicles equipped with 4-wheel drive and automatic transmissions built with tod (torque-on-demand). In certain high speed, frontal crashes, movement of engine compartment components can cause the potential for fuel leakage.
Vehicle description: Sport utility vehicles equipped with 4-wheel drive and automatic transmissions built with tod (torque-on-demand). In certain high speed frontal crashes, an interior fuel line and fuel hose can be separated, allowing fuel to leak.
Vehicle description: Sport utility vehicles. The transfer gearbox flange nuts were not properly installed, causing the nuts to loosen.
左前輪用ブレーキパイプの取付けが不適切なため、当該ブレーキパイプが緩衝装置と干 渉し、そのままの状態で使用を続けると、当該ブレーキパイプが損傷し、最悪の場合、ブ レーキ液が漏れて制動力が低下するおそれがある。
Vehicles with 3.2 litre engines may experience dislodging of the camshaft end plug(s) from the cylinder heads causing rapid oil loss. Oil spilling on the exhaust system could result in an engine compartment fire. Correction: A camshaft end plug retaining plate kit will be installed on affected vehicles.
ガソリンエンジンのシリンダーヘッド前後面にある、密封栓(シールプラグ)の組み付 けが不適切なものがあるため、このままの状態で使用を続けると当該密封栓が脱落し、エ ンジンオイルが漏れ、エンジンが焼き付き走行不能になる場合がある。また、漏れたエン ジンオイルが排気管に付着し、最悪の場合、火災に至るおそれがある。
Constant expansion and contraction of the cylinder head causes the camshaft seal end plug can become dislodged from the cylinder head. This allows oil to leak from the camshaft.
注意:配备V6发动机和自动变速器的车辆。检查自动变速器油液位后,必须正确重新安装自动变速器油尺。如果油尺未锁止,泄漏的自动变速器油可能接触排气歧管,从而导致发动机舱起火。更正:将在油尺盖上安装一个警告标签,提醒每次检查油液位后都要锁止油尺,并且不要向自动变速器内加注过多的自动变速器油。
Putting in more transmission oil than specified can cause oil to bleed through air groove on to the exhaust manifold if oil temperature rises.
Improperly installed hose on the oil cooler could come in contact with the exhaust manifold and could melt.
Due to insufficient clearance between a bolt that fixes the heater to the vehicle body and a fuel delivery pipe and between a rear heater hose clip, use under servere conditions could cause pipe rupture and fuel leakage.
Guide pin on rear disc brake caliper support could have loosened during transport and would no longer hold the caliper in correct position.
Two piece aluminum wheels may not have been welded at point where wheel is press fitted onto the rim.
可能由于发动机振动,节气门位置传感器(TPS)与发动机控制模块之间接地压接端子的内部接触电阻会增大。这可能导致TPS电压输出升高,进而在怠速时即使没有节气门输入,发动机转速也会升高。
アクセルコントロール用の制御配線において、接続が不適切なため、接続部(ジョイント)で接触抵抗が生じるものがある。そのため、アクセルセンサの出力電圧が高くなり、エンジン回転が上昇するおそれがある。
原動機の燃料噴射装置において、インジェクタ(燃料噴射弁)の設計寸法が不適切なため、プランジャとバレルの隙間が大きいものがあり、オーリングが変形、損傷して気密性が損われ、燃料の軽油がエンジンオイルに混入するものがある。そのため、そのままの状態で使用を続けると、オイルパンの油量が増大し、ブローバイホースを経由して吸気管に軽油の混入したオイルが吸入され、原動機の回転が上昇するおそれがある。
由于燃油喷射器内部间隙过大,燃油可能泄漏进入气缸孔,然后进入油底壳,从而导致发动机机油被稀释。如果忽视这种情况,可能会造成发动机损坏;此外,发动机转速可能会出现非预期的升高。
原動機の燃料噴射装置において、インジェクタの組立て工程が不適切なため、プランジャとバレルの隙間が大きいものがあり、オーリングが変形、損傷して機密性が損われ、燃料の軽油がエンジンオイルに混入するものがある。そのため、そのままの状態で使用を続けると、オイルパンの油量が増大し、ブローバイホースを経由して吸気管に軽油の混入したオイルが吸入され、原動機の回転が上昇するおそれがある。
On certain vehicles, after approximately nine or more years of use, the accelerator cable cover in the subject vehicles may deteriorate causing the cable rubber boot to adhere to the inner throttle cable. This can cause the accelerator cable to delay RPM and vehicle speed reduction for several seconds after the accelerator pedal is released, which, in turn, can lead to a crash. Correction: Dealer will replace the throttle cable rubber boot.
On certain sport utility vehicles, the accelerator cable can stick so that the engine speed will not immediately decrease upon release of the accelerator pedal.
アクセルケーブルエンド部の金具の形状及びカバーの材質が不適切なため、当該カバーが 経時劣化して、インナーケーブルに付着することがある。そのため、インナーケーブルが 当該部金具に引っ掛かり、最悪の場合、アクセルペダルを戻しても原動機の回転が下がら なくなるおそれがある。
車枠において、フレーム構成部品の溶接が不十分な為、当該溶接部に亀裂が生じ、更に 緩衝装置取付金具回りに亀裂が生じて、走行中に異音が発生し、最悪の場合、当該金具が 車枠から剥がれ、走行安定性がそこなわれるおそれがある。 (備考) 本届出は、平成15年6月13日「届出956」のリコール届出にあらたに対象車を追加するもの である。
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。