This bulletin supersedes the previously issued bulletin(s) listed below. The changes are noted below in Red. 01-007/24 06/20/24 ENGINE OIL LEVEL WARNING LIGHT ON WITH DTC P250F:00 DUE TO LOW ENGINE OIL LEVEL (UPDATED WITH SSPD5 INFORMATION). All Mazda Dealers: Follow the Special Service Program SSPD5 Valve Stem Seal Class Action for determination if valve stem seals should be replaced. 1. Verify the customer concern following the Special Service Program SSPD5 Repair Procedure. As the repair procedure states in SSPD5, confirm the engine oil is not leaking from the engine. If the customer reports engine oil is low upon arrival at a dealer, replace the valve stem seals following the flow chart for SSPD5. If engine oil is low upon arrival with no customer complaint, check for SSPD5 and if the valve stem seals have not been replaced under prior Warranty, replace the seals. If the valve stem seals have been replaced under a prior Warranty claim, contact Hotline for further instructions. If valve stem seals need to be replaced, replace the valve seals of the exhaust side with improved ones using the special tools called out in the repair procedures below. 2. Top off the engine oil (if needed). NOTE: Engine oil should not be topped off without replacement of the valve stem seals. 3. Verify the repair. NOTE: If unsure what steps to take during a customer visit for oil consumption related to SSPD5, fill out Dealer Recall Help on OneMazda.
Some vehicles may have a "LOW ENGINE OIL LEVEL" warning message and an engine oil level warning light on in the instrument cluster with DTC P250F:00 stored in memory, and the oil level has actually decreased to near low. - DTC P250F:00 - Engine oil level signal: engine oil level low This is caused by an oil consumption increase due to damage of the valve seals on the exhaust side. To eliminate this concern, the design of these valve seals has been modified.
The Blind Spot Monitoring (BSM) system can malfunction with the following symptoms if the rear side radar sensors are installed facing the wrong direction. - BSM system indicates vehicle on the opposite side. - i-ACTIVSENSE indicator ring will not turn green - Rear Cross Traffic Alert (RCTA) does not work - Rear side radar sensor
Some vehicles may exhibit a warning message displayed in the center display a few seconds after the brake system warning light in the instrument cluster has flashed for a moment at the time of departure or stop of the vehicle. This is caused by improper control logic of the gateway unit (GWU). To eliminate this concern, the logic of the GWU has been changed so that a failure determination is not made unless a signal of the brake fluid level sensor lowering has been continued for more than 5 seconds.
Engine Coolant Leak from lower radiator hose Some vehicles may exhibit an engine coolant leak (A) between the lower radiator hose (B) and the thermostat housing
Some customer may experience the wireless charger does not start charging or stops charging immediately although the mobile device is in the chargeable area. This is caused by the logic for detecting foreign matter being too sensitive.
Connected vehicle remote functions inoperative and/or engine no start due to low battery voltage. Some customers may experience the following symptoms: Connected Vehicle Remote Functions inoperative after SSPC6 repair. Connected Vehicle Remote Functions inoperative on vehicles built March 20, 2021 and later.
Connected vehicle remote functions inoperative and/or engine no start due to low battery voltage. Some customers may experience the following symptoms: Connected Vehicle Remote Functions inoperative after SSPC6 repair. Connected Vehicle Remote Functions inoperative on vehicles built July 1, 2021 and later.
Connected vehicle remote functions inoperative and/or engine no start due to low battery voltage. Some customers may experience the following symptoms: Connected Vehicle Remote Functions inoperative after SSPC6 repair. Connected Vehicle Remote Functions inoperative on vehicles built July 1, 2021 and later.
IMPORTANT NOTE: Some 2020 Mazda3 vehicles may have incorrect infotainment software version 10042 installed. The incorrect software will cause MyMazda App Connected Vehicle enrollment errors. Go to SSPC1. Some customers may complain about any of the following: Infotainment Center Display does not provide the Authorization Code during the MyMazda App Connected Vehicle enrollment (and Software Update Error message on 2020 Mazda3 only). Remote function(s) inoperative. Engine Start / Stop, Door Lock / Unlock, Lights ON / OFF
IMPORTANT NOTE: Some 2020 Mazda3 vehicles may have incorrect infotainment software version 10042 installed. The incorrect software will cause MyMazda App Connected Vehicle enrollment errors. Go to SSPC1. Some customers may complain about any of the following: Infotainment Center Display does not provide the Authorization Code during the MyMazda App, Connected Vehicle enrollment (and Software Update Error message on 2020 Mazda3 only). Remote function(s) inoperative. Engine Start / Stop, Door Lock / Unlock, Lights ON / OFF
IMPORTANT NOTE: Some 2020 Mazda3 vehicles may have incorrect infotainment software version 10042 installed. The incorrect software will cause MyMazda App Connected Vehicle enrollment errors. Go to SSPC1. Some customers may complain about any of the following: Infotainment Center Display does not provide the Authorization Code during the MyMazda App, Connected Vehicle enrollment (and Software Update Error message on 2020 Mazda3 only). Remote function(s) inoperative. Engine Start / Stop, Door Lock / Unlock, Lights ON / OFF
IMPORTANT NOTE: Some 2020 Mazda3 vehicles may have incorrect infotainment software version 10042 installed. The incorrect software will cause MyMazda App Connected Vehicle enrollment errors. Go to SSPC1. Some customers may complain about any of the following: Infotainment Center Display does not provide the Authorization Code during the MyMazda App, Connected Vehicle enrollment (and Software Update Error message on 2020 Mazda3 only). Remote function(s) inoperative. Engine Start / Stop, Door Lock / Unlock, Lights ON / OFF
Some customers may complain about not being able to answer an iPhone incoming call via Bluetooth using the steering wheel controls or the commander switch. The infotainment center display answer button may be grayed out. This may be caused by an iPhone phone setting with iOS 14.2 and iOS 14.3. No vehicle repair is needed.
CONNECTED VEHICLE SYMPTOM TROUBLESHOOTING: IMPORTANT NOTE: Some 2020 Mazda3 vehicles may have incorrect infotainment software version 10042 installed. The incorrect software will cause MyMazda App Connected Vehicle enrollment errors. Go to SSPC1. Some customers may complain about any of the following: Infotainment Center Display does not provide the Authorization Code during the MyMazda App Connected Vehicle enrollment (and Software Update Error message on 2020 Mazda3 only). Remote function(s) inoperative. Engine Start / Stop Door Lock / Unlock Lights ON / OFF
IMPORTANT NOTE: Some 2020 Mazda3 vehicles may have incorrect infotainment software version 10042 installed. The incorrect software will cause MyMazda App Connected Vehicle enrollment errors. Go to SSPC1. Some customers may complain about any of the following: Infotainment Center Display does not provide the Authorization Code during the MyMazda App Connected Vehicle enrollment (and Software Update Error message on 2020 Mazda3 only). Remote function(s) inoperative. Engine Start / Stop, Door Lock / Unlock, Lights ON / OFF
IMPORTANT NOTE: Some 2020 Mazda3 vehicles may have incorrect infotainment software version 10042 installed. The incorrect software will cause MyMazda App Connected Vehicle enrollment errors. Go to SSPC1. Some customers may complain about any of the following: Infotainment Center Display does not provide the Authorization Code during the MyMazda App Connected Vehicle enrollment (and Software Update Error message on 2020 Mazda3 only). Remote function(s) inoperative. Engine Start / Stop, Door Lock / Unlock, Lights ON / OFF
IMPORTANT NOTE: Some 2020 Mazda3 vehicles may have incorrect infotainment software version 10042 installed. The incorrect software will cause MyMazda App Connected Vehicle enrollment errors. Go to SSPC1. Some customers may complain about any of the following: Infotainment Center Display does not provide the Authorization Code during the MyMazda App Connected Vehicle enrollment (and Software Update Error message on 2020 Mazda3 only). Remote function(s) inoperative. Engine Start / Stop, Door Lock / Unlock, Lights ON / OFF