null 随着时间推移,点火开关内部的触点可能会碳化,并变得……
随着时间推移,点火开关内部的触点可能会碳化,并变得导电。这可能导致点火开关过热,从而存在引发火灾的风险。
🔔 注册免费账户,接收 Mazda MX-6 (所有代) 的邮件提醒
随着时间推移,点火开关内部的触点可能会碳化,并变得导电。这可能导致点火开关过热,从而存在引发火灾的风险。
点火开关触点之间可能会积聚碳化的润滑脂,从而降低开关内部的绝缘性能。在这种情况下,开关可能会产生热量,进而导致冒烟,最坏的情况下甚至引发火灾。
点火开关因电触点上多余油脂碳化而关闭。
Mazda North American Operations (Mazda) is recalling certain model year 1989-1998 MPV, 1990-1995 323, 1990-1998 Protege, 1992-1993 MX-3, 1993-1995 929, 1993-1997 MX-6, and 1993-1998 626 vehicles. In the affected vehicles, grease applied to the contact points inside the ignition switch may become conductive and overheat.
点火开关中,若开关内部触点上涂抹了过量的润滑脂,操作开关时产生的电弧放电热量会使润滑脂碳化,并堆积在动触点与静触点之间,从而可能导致开关内部绝缘性能下降。因此,若继续使用,触点之间可能导通,使开关发热、冒烟,最坏的情况下可能引发火灾。
燃料タンクの上部に取り付けられている樹脂製のロールオーバーバルブ取付用部品に成 形不良のものがあり、このままの状態で使用を続けると、当該部品と燃料タンクの間に隙 間が発生し、燃料が漏れるおそれがある。
据此翻译如下: (Takata)这些车辆上的ABS塑料前排安全带释放按钮可能会断裂,导致塑料碎片掉入搭扣总成内。如果发生这种情况,可能出现无法扣合、误扣合或无法解开的状况,从而在碰撞或急刹车时造成人身伤害的风险。更正:前排安全带搭扣将根据需要进行维修或更换。
The lower arm ball joints on both sides of the front suspension may not have been torqued to specification.
The fuel tank straps may not be properly tightened and may rub against the fuel tank. This could cause the tank's protective coating to wear through resulting in surface damage and eventual tank perforation and fuel leakage. Correction: Rubber insulator will be placed between the tank straps and the tank and the tank straps will be properly tightened. Also, a new protective coating will be applied where required. V.I.N. Range: Jm1gd3120j1500014 to jm1gd2210j1537936
Fuel tank fixing band retention is not sufficient, allowing the band to rub against the fuel tank by vehicle vibrations.
Vehicle description: Passenger vehicles. The headlight wire that runs through the turn signal lever can fail at the point where it is soldered to the headlight switch.
Certain vehicles do not comply with the requirements of CMVSS. 1103 - Exhaust Emissions. The average CO of the subject vehicles may exceed the standard due to insufficient robustness of emission control logic, and calibration of emission parts with extended usage. Correction: Dealers will install an engine intake kit, which will allow additional air to enter the engine, improving combustion efficiency and lowering the levels of carbon monoxide.
Certain vehicles do not comply with the requirements of CMVSS 1105 - Evaporative Emissions. Fuel vapour may leak from between the fuel cap and the fuel filler pipe. The gap could be generated by improper dimensions between the top ends of the inner and outer pipe of the fuel filler pipe. In some cases, raw fuel would be released into the atmosphere. Correction: Dealers will install a modified fuel cap o-ring.
On certain vehicles, minor undercarriage impacts can result in unnecessary air bag deployment. This could result in personal injury and/or loss of vehicle control. Correction: Dealers will reprogram the sas unit to reduce the possibility of unnecessary deployments in low speed undercarriage impacts.
Vehicle description: Passenger vehicles equipped with the sas sensor unit. These vehicles can experience air bag deployments in minor undercarriage impacts.
On certain vehicles, an external spring in the timing belt auto tensioner may break. The broken spring may get caught in the timing belt, resulting in possible engine stalling. Correction: Vehicles will be inspected and affected tensioners will be replaced.
Vehicle description: Passenger vehicles. An external spring in the timing belt tensioner can break and get caught in the timing belt.
前排安全带锁扣的释放按钮可能会断裂。这些红色塑料释放按钮上标有"press"字样。如果按钮断裂,碎片可能会掉入锁扣总成内,导致锁扣无法正常工作。
At ambient temperatures below 0 degree f, frost may accumulate within the throttle body under extended constant speed operation.
At ambient temperatures below -18 degrees celsius, frost may accumulate within the throttle body under conditions of extended constant speed operation. This could result in a heavy accelerator pedal and cause uneven throttle valve return. Correction: The single stage engine coolant thermostat will be replaced with a dual stage thermostat equipped with a subvalve to increase the temperature within the throttle body. V.I.N. Range: Jm1gd3120j1500014 to jm1gd2226j1573252.
Vehicles equipped with rear brake drums transported by train may experience separation of the brake shoe from the wheel brake cylinder piston.
Transportation by rail could cause the rear brake shoe web to come off the wheel cylinder piston groove. This condition will cause damage to the wheel cylinder dust boot and may cause dust and water intrusion into the wheel cylinder resulting in piston corrosion. This would inhibit rear brake effectiveness. Correction: Vehicles will be inspected and wheel cylinder dust boot will be replaced where required. All involved vehicles will have lubricant applied to the wheel cylinder piston groove. V.I.N. Range: Jm1gd3120j1500014 to jm1gd2218j1541323
Floor mat could interfere with release of accelerator pedal due to improper shape of mat.
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。