燃油系统,汽油:输送:燃油泵
Mazda North American Operations(Mazda)正在召回部分2010至2011年款Tribute车型,生产日期为2009年3月3日至2011年5月26日。搭载3.0L发动机的车辆,其燃油输送模块(FDM)可能出现开裂,从而导致燃油泄漏。
🔔 注册免费账户,接收 Mazda Tribute (所有代) 的邮件提醒
Mazda North American Operations(Mazda)正在召回部分2010至2011年款Tribute车型,生产日期为2009年3月3日至2011年5月26日。搭载3.0L发动机的车辆,其燃油输送模块(FDM)可能出现开裂,从而导致燃油泄漏。
Mazda North American Operations(Mazda)正在召回部分2001至2004年款Tribute车辆,这些车辆的生产日期为2000年5月22日至2003年12月19日,且最初销售或目前登记在以下地区:康涅狄格州、特拉华州、伊利诺伊州、印第安纳州、艾奥瓦州、缅因州、马里兰州、马萨诸塞州、密歇根州、明尼苏达州、密苏里州、新罕布什尔州、新泽西州、纽约州、俄亥俄州、宾夕法尼亚州、罗德岛州、佛蒙特州、西弗吉尼亚州、威斯康星州以及哥伦比亚特区。这些车辆的下控制臂前部连接处可能出现过度腐蚀。
Mazda is recalling certain model year 2001 through 2006, and 2008, Tribute vehicles equipped with 3.0L V6 engines and speed control. Inadequate clearance between the engine cover and the speed control cable connector could result in a stuck throttle when the accelerator pedal is fully or almost-fully depressed. This risk exists regardless of whether or not speed control (cruise control) is used.
Certain vehicles may have been originally equipped with a brake master cylinder reservoir cap that could leak. If brake fluid leaks from the cap, it could come in contact with the ABS module wiring harness connector. The same vehicles were previously involved in campaign 2007119 to address potentially missing or misplaced seals in the wiring harness connector to the ABS module electronic control unit. If this repair wasn’t done correctly, brake fluid leaking from the reservoir cap could corrode the ABS module electrical connector. This could result in vehicle fire causing property damage and/or personal injury. Correction: Dealers will replace the brake master cylinder reservoir cap and modify the ABS electrical system. Note: Owners are advised to park the vehicle outdoors until the remedy is applied.
Mazda is recalling certain model year 2001-2002 mazda tribute vehicles manufactured from april 20, 2000, through july 19, 2002. The brake master cylinder reservoir cap can leak brake fluid. If brake fluid leaks, it could come in contact with the antilock brake system (abs) module wiring harness connector.
On certain sport utility vehicles equipped with antilock brakes (abs), the abs module connector may have missing or dislodged wire seals. This condition could allow contamination to enter the module connector, creating a potential for an electrical short.
制動装置において、倍力装置の製造工程が不適切なため、ダイヤフラムが倍力装置の本 体容器に噛み込まれた状態のものがあり、そのままの状態で使用を続けると、ブレーキ操 作の繰り返しによりダイヤフラムが破損することがあり、負圧が漏れ、制動力が低下する おそれがある。
On certain vehicles, the o-ring seals in the fuel line connector at the fuel filter outlet may have been damaged during assembly. This damage can result in fuel odor or possible fuel leakage. Fuel leakage, in the presence of an ignition source, could result in a fire. Correction: Vehicles will be inspected and fuel line replaced if necessary.
Vehicle description: Sport utility vehicles. The o-ring seals in the fuel line connector at the outlet end of the fuel filter were damaged when the line was connected to the filter during vehicle assembly. In some cases, this damage could result in a fuel odor, or possibly in fuel dripping from the connection.
Vehicle description: Some 4x2 sport utility vehicles not equipped with an antilock braking system may have inadvertently been built with 4x4 rear hubs instead of 4x2 hubs. If the incorrect hubs are installed on a 4x2 vehicle, the rear wheels can loosen, or in some cases, separate from the vehicle.
Vehicle description: Sport utility vehicles. These vehicles may have a mis-assembled or incorrectly manufactured nut that attaches the steering wheel assembly to the steering column. The nut could be upside down in the steering wheel assembly, which could overstress the steering column shaft when the nut is tightened. In addition, some of the nuts may have been cracked during manufacture resulting in the nut fracturing when it is tightened during vehicle assembly.
可能存在安全缺陷的车辆:安装了再制造自动变速箱作为售后更换零件的车辆。换挡杆螺栓的拧紧力矩可能未达到规定的技术要求。如果拧紧不当的换挡杆螺栓松动并退出,换挡杆可能在没有任何预警的情况下与变速箱脱离,变速箱也可能无法响应驾驶员的挡位操作。这可能导致失去变速箱挡位选择功能,并可能造成车辆意外移动,从而增加发生碰撞并导致人员受伤和/或财产损失的风险。 纠正措施:经销商将进行检查,如有必要,将更换换挡杆总成和/或按规定力矩重新拧紧换挡杆螺栓。
Mazda North American Operations(Mazda)正在召回部分2008年款Tribute车型,生产日期为2007年2月9日至2008年4月22日。这些受影响车辆的CD4E变速箱已被更换为翻新变速箱,该翻新变速箱于2015年6月11日至2015年7月15日期间重新组装。这些维修用备件变速箱的换挡杆螺栓可能未被正确拧紧。因此,换挡控制杆可能会在没有任何预警的情况下从变速箱上脱开。
Mazda North American Operations (Mazda) is recalling certain model year 2008 Mazda Tribute Hybrid vehicles manufactured October 10, 2006, to May 23, 2008. The coolant pump for the hybrid system may fail, resulting in the hybrid electronics overheating.
Mazda North American Operations (Mazda) is recalling certain model year 2008-2011 Tribute vehicles manufactured October 5, 2006, through September 11, 2010. The affected vehicles have a steering torque sensor that may not be able to properly detect driver steering input. As a result, the system could remove the Electric Power Steering (EPS) assist.
可能存在发动机罩与定速巡航拉线之间间隙不足的情况,这可能导致在加速踏板被完全或接近完全踩下时,节气门卡滞在全开位置。如果出现这种情况,将难以停车或减速,从而可能导致事故。无论是否使用定速巡航,都存在这一风险。
节气门在加速踏板完全或几乎完全踩下时可能卡滞,从而可能导致发动机转速意外升高。这是由于定速巡航控制线缆接头与发动机罩发生干涉所致。
かじ取り装置のパワーステアリング用油圧ポンプのプーリー取り付けナットの締付け力及びプーリーの強度が不足しているため、当該プーリーの取り付けナットが緩む又はプーリーに亀裂が入るものがある。そのため、そのままの状態で使用を続けると、異音が発生し、最悪の場合、当該プーリーが破損又は外れてハンドル操作力が増大するおそれがある。
On certain trucks and sport utility vehicles, the windshield wiper motor may have been produced without grease applied to the output shaft gear.
Certain 2004-2005 sport utility vehicles and certain 2001-2003 sport utility vehicle having rear liftgate components serviced with 2004 equivalent components fail to comply with the requirements of federal motor vehicle safety standard no. 206, 'door locks and door retention components.' the rear liftgate latching system does not meet the inertia load requirement in one direction.
On certain sport utility vehicles, the accelerator cable may prevent the throttle from returning to the idle position.
It is possible that the driver and/or front seat passenger seat belt buckle cannot be latched or will not remain latched.
On certain sport utility vehicles equipped with 3.0l v6 duratec engines , during deceleration, the engine can stall.
On certain sport utility vehicles, a post within the safety belt buckle covers could fracture, which could affect latch function, resulting in either a "no latch" or "partial latch" condition. In the "partial latch" condition, the buckle tongue can be inserted into the buckle and appear to be engaged, but will release from the buckle without the push button being depressed when a relatively low load is applied, such as when an occupant moves slightly in the seat.
Oil has remained on the stop lamp switch bracket during assembly. The oil deposit can cause the switch contacts to to carbonise. Due to this the stop lamp may not turn on even if the brake pedal is depressed.
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。