Chaîne de distribution
Elle casse fréquemment (tous les 30.000 km) sur les 2.0 l. et 2.3 l. entre 1985-89 et entraîne la détérioration du moteur.
🔔 注册免费账户,接收 Mercedes-Benz C级 (所有代) 的邮件提醒
Mercedes-Benz C级 所有代的全部信息:缺陷、召回、技术通报和讨论。选择某一代以缩小范围。
Elle casse fréquemment (tous les 30.000 km) sur les 2.0 l. et 2.3 l. entre 1985-89 et entraîne la détérioration du moteur.
194 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 1994–2000), typically at around 112,000 miles. Most often named: wiring:front underhood (19%), wiring (17%). Reported consequences: 2 crashes, 17 fires, 7 injuries.
44 owners in the United States reported problems with the fuel system of this car to NHTSA (model years 1994–2000), typically at around 110,000 miles. Most often named: storage:tank assembly (18%). Reported consequences: 3 crashes, 5 fires, 2 injuries.
37 owners in the United States reported problems with the engine and cooling of this car to NHTSA (model years 1994–2000), typically at around 92,000 miles. Most often named: engine:gasoline:belts and associated pulleys (16%). Reported consequences: 4 fires.
27 owners in the United States reported problems with the accelerator and cruise control of this car to NHTSA (model years 1994–2000), typically at around 142,000 miles. Reported consequences: 8 crashes, 3 fires, 7 injuries, 1 death.
문서화 작업 오류로 인하여 자기 인증 시 제원 통보된 차량 너비 수치가 잘못 제출되어 실제 차량 제원과 차이가 있을 수 있으며, 이런 경우 차량 검사 시 부적합을 받을 수 있음이 확인됨에 따른 리콜 (이는 자동차 및 자동차부품의 성능과 기준에 관한 규칙 제115조(제원의 허용차)에서 정하는 기준에 부적합할 수 있음)
De drie aluminium schroeven waarmee de power-pack aan de stuurinrichting is bevestigd, kunnen door blootstelling aan water en strooizout roesten.
Des boulons de raccordement au sol spécifiques de 12v et 48v peuvent avoir été fixés avec un couple incorrect, ce qui peut conduire à ce que les faisceaux de câblage ne soient pas correctement fixés. en conséquence, la résistance électrique aux points de connexion pourrait augmenter. la température peut donc augmenter dans cette zone, entraînant un incendie.
Complaint Wheezing noises/squeaking noises from the front shock absorbers when passing over surface undulations and rough road. Noise MUST match those heard in the attached videos. Cause Wheezing noises: Flow noises of the damper oil Squeaking noises: From the mechanical rubber valve in the dividing piston Remedy In case of complaints, the front shock absorbers must be replaced. If shocks have been replaced and noise persists, please open a TIPS case to the Body, Chassis, Entertainment inbox.
Complaint Diverse functional limitations in the vehicle in combination with various warning and fault messages in the instrument cluster display. Cause Communication timeouts mean that communication errors may occur in the onboard electrical system, which can result in various fault messages being displayed in the instrument cluster. This could be down to delayed feedback from the drivetrain control unit (N127) (CPC) to other control units networked to the CAN bus. Information: Only valid for vehicles through production period 10/2025. Not valid for vehicles with control unit CDCC (N125, central controller charging and driving) It may not be possible to attribute any communication errors stored in the control units on the CAN bus to a specific cause In rare instances, there may be a brief activation of the yellow warning lamp for engine diagnosis or there may be a sporadic delay with the start enable. There may not be any specific fault codes present that indicate a specific component. Example image: Fault messages in instrument cluster: The reason for this could be down to delayed feedback from the control unit CPC3 to other control units networked on the CAN bus. Remedy Do not replace any components!!! ******************************************************************************************************* 1. Connect charger (see AR54.10P1127WT). Note: An adequate voltage from the onboard electrical system battery must be guaranteed for the entire duration of the work procedure. Otherwise, the control units could be damaged if an undervoltage occurs. Information: Observe the operating instructions of the charger. Information: Use the charger to ensure an adequate voltage (at least 12.5 V) from the onboard electrical system battery. 2. Connect diagnostic system (see AD00.00P200006FR). Note: Always use the latest XENTRY Diagnostics software release. Information: Strict compliance with the operation steps in XENTRY Diagnostics is absolutely essential. 3. Select control unit N127 (CPC) via the direct link using XENTRY Diagnosis. Information: To do so, select the following menu items: Control units view Drive systems N127 "Drivetrain" control unit (CPC) 4. Update software for control unit N127 (CPC) (see AR54.21P001401Y). Info: To do so, select the following menu items: Adaptations Control unit update Update control unit software. Information: You are then automatically guided through the steps "Update of control unit software" and "SCN coding". Always observe the following operation steps at all times 5. Disconnect diagnostic device from vehicle (see AD00.00P200006FR). 6. Disconnect charger from vehicle (see AR54.10P1127WT).
Issue A software update will be performed that provides enhancements to the robustness and system stability of the communication module. The update is free of charge and runs in the background, which takes about 8 minutes to install. During this time, the vehicle can be driven without any restrictions, and the new software will be active with the next ignition cycle. Remedy MBUSA will conduct an OTA service campaign. Remote software updates are automatically downloaded and installed in the customers vehicle free of charge and do not require a dealer visit.
缺陷和讨论按代归档:请先在上方选择一代再发布。
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。