Electrical system: problems reported by owners
42 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2015–2019), typically at around 18,000 miles. Reported consequences: 3 fires, 1 injury.
🔔 注册免费账户,接收 Mercedes-Benz GLA (所有代) 的邮件提醒
Mercedes-Benz GLA 所有代的全部信息:缺陷、召回、技术通报和讨论。选择某一代以缩小范围。
42 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2015–2019), typically at around 18,000 miles. Reported consequences: 3 fires, 1 injury.
36 owners in the United States reported problems with the airbags of this car to NHTSA (model years 2014–2019), typically at around 60,000 miles. Reported consequences: 5 crashes, 8 injuries.
19 owners in the United States reported problems with the body and structure of this car to NHTSA (model years 2015–2019), typically at around 21,000 miles. Most often named: body (84%). Reported consequences: 3 crashes, 2 injuries.
15 owners in the United States reported problems with the brakes of this car to NHTSA (model years 2015–2019), typically at around 26,000 miles. Reported consequences: 2 crashes, 5 injuries.
11 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2020–2025), typically at around 2,000 miles. Reported consequences: 1 crash, 1 injury.
Il manque un joint entre le collecteur d'échappement et le turbocompresseur de gaz d'échappement. cela peut conduire à des gaz d'échappement chauds et non purifiés s'infiltrant entre le turbocompresseur et le collecteur. cela peut endommager le couvercle de la culasse et provoquer une fuite d'huile. si l'huile entre en contact avec des pièces chaudes du moteur, le véhicule peut prendre feu.
Les rivets des sièges arrière réglables longitudinalement ne peuvent pas être installés sur les rails réglables. cela pourrait déplacer la position du siège au-delà de son point d'extrémité défini lorsqu'il est réglé manuellement. en cas d'accident ou de forte décélération, le siège arrière pourrait sortir de sa position définie, entraînant un risque accru de blessure pour les occupants.
トランスミッション・コントロールユニットにおいて、制御プログラムが不適切なため、4速で走行中にギアがニュートラルになり固定されることがある。そのため、駆動力を失い走行不能になるおそれがある。
Complaint Clanking noise from the area of the speakers in the doors. Cause Under analysis. Remedy To narrow down the cause, first of all remove the door trim. If the noise continues to occur even with the door trim removed, then continue the diagnosis working towards the speaker and if necessary, create a TIPS case with an informative video as an attachment. Note: Please refer to this document in the warranty claim and, once diagnosis is completed, select the damage code depending on the component part that is causing the issue. If the noise stops when the door trim is removed, please proceed in accordance with LI72.10P067691. Information: In this case, do not use a damage code for the speakers in the warranty claim!
Complaint Repeat workshop visit for vehicle vibration while braking from 60MPH. NOTE: Although the symptom is similar to a tire or wheel vibration, it is usually readily noticeable that it is distinctly different if it happens at all times or only while braking. Cause Although the cause of the vibration is most likely due to excessive lateral runout on the rotor or hub/wheel bearing, the system as a whole needs to be checked for other possible contributors. 1. Prior collision damage. 2. Excessive vehicle sitting times without rotating components. 3. Wheel bearing/hub lateral runout. 4. Wheel mating interface has been overtightened (did not follow WIS torque procedures). 5. Mating interfaces have been excessively modified (painted, gouged, bent, etc...). Remedy Read through the entire attached worksheet prior to performing. After performing, please review the final page and perform work accordingly. NOTE: This document is not preauthorization or otherwise dealing with warranty. This is intended for diagnostic purposes only. If there are any questions on how to proceed OR The work sheet has been performed and the vehicle has returned with the same concern. Please perform the measurements as seen in the worksheet again and open a TIPS case to the Body, Chassis, and Entertainment team.
Complaint Noises in the steering column area when steering. See example file in the attachments area: "MRSMSchleifgerusch_SCCMGrindingNoises. MOV". Cause Under analysis. Remedy Check which area of the steering column the noises occur in. Do the noises tend to occur at the bottom in the driver footwell or do they tend to occur in the area of the steering column switch module (MRSM/SCCM)? If the noises occur in the area of the MRSM/SCCM, work through the following points: Loosen screws of the MRSM/SCCM and steering wheel, realign the MRSM/SCCM, and refasten the screws (see WIS). Sometimes there is stress at the MRSM/SCCM and noises occur. If noises continue to occur, swap the MRSM/SCCM into a vehicle without any (noise) complaints. If the noises occur with the MRSM/SCCM complained about when it is in the vehicle without a complaint (donor vehicle), the MRSM/SCCM can be replaced. If noises also occur in the customer vehicle with the MRSM/SCCM from the reference vehicle, the MRSM/SCCM is not the cause and must not be replaced. Notes: When installing the MRSM/SCCM, make sure that no damage occurs! If the noise is due to the steering wheel (see attachment "LenkradSchleifgerusch_SteeringWheelGrindingNoises.mp4"), please use LI46.10P077313. Only disassemble and mount all component parts in the "straightahead position" (see also WIS). Please refer to this LI in the "Notes" section of the warranty claim!
缺陷和讨论按代归档:请先在上方选择一代再发布。
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。