免费阅读 · 免费账户即可贡献Anticars(2000)的继任者

Nissan 方塊

2002–2019 · 2 各代车型 · 已记录8项缺陷 · 4个市场
各代车型

Nissan 方塊 所有代的全部信息:缺陷、召回、技术通报和讨论。选择某一代以缩小范围。

最严重的缺陷

查看全部 (8) →

最新官方召回

查看全部 (10) →
方塊 III (2008) · 2008–2019
召回严重内饰UK

Cube (Z12) Driver Airbag

For affected vehicles the Driver's Airbag module may have been incorrectly assembled during production. In this condition the driver’s airbag inflator module may detach from the steering wheel.

DVSA · 英国2026年9月25日R/2026/164车型年份 2008–2010以原文(英语)显示 · 翻译待完成查看详情 →
方塊 III (2008) · 2008–2019
方塊 II · 2002–2008方塊 III (2008) · 2008–2019
召回严重内饰EU

Le gonfleur de l'airbag du conducteur a un joint interne soudé au laser (côté gauche) qui peut ne pas…

Le gonfleur de l'airbag du conducteur a un joint interne soudé au laser (côté gauche) qui peut ne pas tenir de manière fiable pendant le déploiement. cela peut entraîner un risque que le module d'airbag soit séparé du volant lorsqu'il est activé. cela peut entraîner la projection de fragments métalliques à grande vitesse à travers l'airbag à l'intérieur du véhicule, ce qui peut entraîner des blessures graves et même mortelles pour les occupants.

Safety Gate · 欧盟 · RappelConso · 法国2026年5月1日sr/01308/26车型年份 2008–2010以原文(法语)显示 · 翻译待完成查看详情 →

最新技术服务通报

查看全部 (17) →
方塊 III (2008) · 2008–2019
通报轻微其他NA

通报

VOLUNTARY SERVICE CAMPAIGN 2009 CUBE OWNERS MANUAL UPDATE Campaign ID # P9223 is no longer active. Repair orders opened after this bulletins published date are no longer eligible for reimbursement under Campaign ID # P9223. Discard all previous versions of NTB09-065.

NHTSA · 制造商通报11036449车型年份 2009以原文(英语)显示 · 翻译待完成查看详情 →
方塊 III (2008) · 2008–2019
通报中等变速箱NA

通报

DRIVE SHAFT BOOT SERVICE INFORMATION SERVICE INFORMATION If a Drive Shaft (Axle Shaft) Boot on an APPLIED VEHICLE is found to be leaking grease, AND There is no abnormal noise or obvious CV Joint risk due to water intrusion and/or complete grease loss, check for REPAIR KIT-DUST BOOT (CV Joint Boot Kit) availability. If there is a REPAIR KIT-DUST BOOT (CV Joint Boot Kit) available for the vehicle being repaired, do NOT replace the axle. Install a new boot kit following the procedure in the ESM. o Refer to the ESM: TRANSMISSION & DRIVELINE > FRONT AXLE > REMOVAL AND INSTALLATION > FRONT DRIVE SHAFT BOOT o If the complete axle (drive shaft) is replaced when only a new boot is required, the over-repair may be charged back to the dealer. If there is NOT a REPAIR KIT-DUST BOOT (CV Joint Boot Kit) available for the vehicle being repaired, refer to the ESM for further diagnostic information. IMPORTANT: When servicing vehicles with staked axle nuts, refer to NTB21-013 to prevent Drive Shaft thread damage.

NHTSA · 制造商通报10227268车型年份 2016以原文(英语)显示 · 翻译待完成查看详情 →
方塊 III (2008) · 2008–2019
通报轻微悬架NA

通报

SERVICE INFORMATION FOR FUEL GAUGE INACCURATE WITH DTCS STORED IN ECM SERVICE INFORMATION If a fuel level sensor has been diagnosed as sending an incorrect level signal, and one or more of the following DTCs are stored in the ECM, do not replace the entire Fuel Level Sensor Unit, Fuel Filter and Fuel Pump Assembly (fuel pump assembly). The fuel level sensor can be replaced separately. P0460 (FUEL LEV SEN SLOSH) P0461 (FUEL LEVEL SENSOR) P0462 (FUEL LEVL SEN/CIRC) P0463 (FUEL LEVL SEN/CIRC) NOTE: Warranty claims referring to fuel level issues that result in the replacement of the entire fuel pump assembly will be charged back.

NHTSA · 制造商通报10213684车型年份 2016以原文(英语)显示 · 翻译待完成查看详情 →

最新论坛话题

暂无讨论。

缺陷和讨论按代归档:请先在上方选择一代再发布。

来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)。