Seat belts:Rear/other
Certain passenger vehicles fail to conform to federal motor vehicle safety standard no. 210, 'seat belt assembly anchorages.' the passenger-side rear safety belt may have been installed with an incorrect nut and bolt.
🔔 注册免费账户,接收 Pontiac Sunfire 的邮件提醒
Certain passenger vehicles fail to conform to federal motor vehicle safety standard no. 210, 'seat belt assembly anchorages.' the passenger-side rear safety belt may have been installed with an incorrect nut and bolt.
在某些乘用车上,如果发动机无法启动,且驾驶员将钥匙长时间保持在"启动"位置,大电流会流经点火开关,有时产生的热量足以熔化开关内部的零部件。
## 翻译 某些车辆在大量进水后,可能会在没有发生碰撞的情况下导致驾驶员或前排乘客的前安全气囊展开。这些车辆的车主手册并未提供关于此种情况的具体信息。在非事故(非碰撞)情况下意外展开驾驶员和/或前排乘客前安全气囊,可能会对周围的车辆部件(挡风玻璃/仪表板)造成损坏,并产生高昂的维修费用,包括更换安全气囊模块和传感与诊断模块(SDM)。在某些情况下,意外展开可能会导致车内乘员受到轻微伤害。更正:通用汽车公司将通知这些1996和1997年款车辆的车主,车内积水可能对安全气囊系统功能产生的潜在影响(该信息已包含在1998年及之后车型年款车辆的车主手册中)。
在某些乘用车上,如果发动机无法启动,而驾驶员将钥匙长时间保持在"启动"位置,大电流会流经点火开关,有时产生的热量足以熔化开关内部的部件。
Vehicle description: Passenger vehicles. The wheel lug nuts were not tightened securely resulting in a fracture of the wheel studs.
Vehicle description: Passenger vehicles. The compact spare tire assemblies were assembled with incorrect rims. If the spare tire is underinflated, the bead can separate from the rim causing a rapid loss of air. This does not comply with the requirements of fmvss no. 110, "tire selection and rims."
On certain passenger vehicles, the rear lamps that provide stop and turn signals and tail lamp functions stop working because of inadequate contact between the bulb and socket. In addition, if one bulbs were to become inoperative while the vehicle was operating in cruise control, the cruise control would disengage when the remaining bulb was activated. If both lamps were to become inoperative, the cruise control would not engage.
Certain passenger vehicles and mini vans have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These and some other retainers used in vehicles assembled between january 1, 1996 and october 31, 1997, could fail and permit the ball bearings to escape.
Certain vehicles do not comply with the requirements of CMVSS 101- Location and Identification of Controls and Displays. Vehicles exhibit a condition in which the "Generator Low Voltage" indicator light will not illuminate under low voltage conditions. Correction: Dealers will reflash the vehicle PCM with new calibration software.
Note: Certain 1997-99 vehicles in Ontario, Quebec and the Atlantic provinces and 1995-99 vehicles in all other provinces and territories. Moisture may enter the Powertrain Control Module (PCM) as a result of corrosion after extended exposure to road salt. This can lead to symptoms including illumination of the "Check Engine" light or the engine running rough. If these symptoms are ignored the engine may stall and may not be able to be restarted. Correction: Dealers will seal the Powertrain Control Module (PCM) in a protective shield/cover assembly.
Vehicle description: Passenger vehicles. These vehicles do not comply with requirements of fmvss no. 101, "control location, identification, and illumination." the instrument panel backlighting may not function after adjusting the interior light intensity.
On certain vehicles located in Ontario, Quebec, New Brunswick, Nova Scotia, Prince Edward Island and Newfoundland, Moisture entering the Powertrain Control Module (PCM) as a result of corrosion can cause illumination of the "Check Engine" light or cause the engine to run rough. If these symptoms are ignored, the engine may stall and may not be able to be restarted. Correction: Dealers will inspect, clean and/or replace the Powertrain Control Module (PCM), then seal the PCM in a protective shield/cover assembly.
Certain vehicles may have a condition which could result in one of the rear suspension trailing arm bolts breaking. If this were to occur while the vehicle was in motion, vehicle control would be affected and a crash could occur without prior warning. Correction: Dealers will replace the rear suspension trailing arm fasteners.
Vehicle description: Passenger vehicles. One of the rear suspension trailing arm bolts can fatigue and break.
Because of certain calibrations in the air bag's computer, there is an increased risk of an air bag deployment in a low speed crash or when an object strikes the floor pan. Correction: The sdm module will be recalibrated to reduce the sensitivity to short and mid-duration commanded deployments.
Vehicle description: Passenger vehicles. Because of certain calibrations in the air bag's sensing and diagnostic module, an inadvertent air bag deployment could occur in a low speed crash or when an object strikes the floor pan.
These vehicles may not comply with c.M.V.S.S. 214 - side door strength. There may be mis-located welds at the joint between the left rocker panel inner reinforcement and the body side ring. In the event of a vehicle crash, the sheet metal structure may not perform as designed. This could result in reduced levels of occupant protection. Correction: Vehicles will be inspected for mis-located welds and, if necessary, up to five welds will be placed between the involved panels.
Vehicle description: Passenger vehicles. These vehicles were built with mis-located welds at the joint between the left rocker panel inner reinforcement and the body side ring. This does not meet the requirements of fmvss no. 214, "side door strength."
Vehicle description: Passenger vehicles. These vehicles were built with the potential for the interior lamps to come on unexpectedly while the vehicles are being driven. This does not meet the requirements of fmvss no. 101, "controls and displays."
These vehicles do not comply with c.M.V.S.S. 101 - control location and identification. The interior lamps may turn on by themselves, five to thirty minutes after the vehicle is started and cannot be turned off by the switch. The lamp control module will turn them off after thirty minutes. If the interior lamps turn on while the vehicle is being driven at night, the increased glare could make it more difficult to see objects outside the vehicle. Correction: Lamp control module will be tested and replaced if necessary.
These vehicles do not comply with c.M.V.S.S. 110 - tire selection and rims. The compact spare tire assemblies in these vehicles may have been assembled with rims that do not conform to dimensional and profile standards. If the tire is underinflated it can separate from the rim. Correction: Rim on the compact spare tire assembly will be replaced.
These vehicles may not comply with c.M.V.S.S. 108 - lighting equipment. Vehicles may exhibit a condition in which the front and/or rear hazard warning lamps (four-way flashers) do not flash when the hazard switch is activated. Correction: Vehicles will be inspected and hazard lamp switch replaced if necessary.
The front and/or rear hazard warning lamps (four-way flashers) do not flash when the hazard switch is activated. This fails to comply with fmvss no. 108, "lamps, reflective devices, and associated equipment."
Certain vehicles may not comply with CMVSS 1105 - Evaporative Emissions. Fuel injectors may exhibit leakage of fuel vapour due to a stress of the plastic encapsulant. Correction: fuel injectors on affected vehicles will be inspected for involved date codes and replaced if necessary.
The accelerator control cable could have been kinked during assembly causing high accelerator pedal effort, sticking accelerator control cable, or a broken accelerator control cable.
来源:NHTSA(美国,公有领域)、加拿大交通部(加拿大开放政府许可)、DVSA(英国,开放政府许可 v3.0)、RappelConso 与欧盟 Safety Gate(法国,开放许可 2.0)、日本国土交通省(公共数据许可1.0)、韩国国土交通部(car.go.kr)。