33 owners in the United States reported problems with the body and structure of this car to NHTSA (model years 2008–2021), typically at around 90,000 miles. Most often named: body (91%). Reported consequences: 1 crash, 1 fire, 1 injury.
20 owners in the United States reported problems with the fuel system of this car to NHTSA (model years 2008–2021), typically at around 40,000 miles. Reported consequences: 1 crash, 2 injuries.
16 owners in the United States reported problems with the engine and cooling of this car to NHTSA (model years 2008–2011), typically at around 10,000 miles. Most often named: exhaust system (38%). Reported consequences: 1 fire.
Issue: On certain vehicles, a defect in the steering gear assembly could cause it to leak power steering fluid. If this happens, there could be a loss of power steering assist. Note: For 2007-2020 models, this recall only affects 41 vehicles that had a replacement steering gear installed in 2021. Safety Risk: A loss of power steering assist may result in a sudden increase in steering effort, especially at low speeds. This could increase the risk of a crash. Corrective Actions: Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to inspect, and if necessary, replace power steering gear assembly.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2008-2022 Sequoia and 2007-2021 Tundra vehicles. The power steering gear assembly may have been manufactured incorrectly, which can result in an oil leak.
In our continuing efforts to ensure the best in customer satisfaction, Toyota is launching a Limited Service Campaign (LSC) on certain 2012-2013 MY Tundra and Sequoia vehicles. This LSC will cover approximately 19,000 Sequoia and 103,000 Tundra vehicles equipped with a 5.7L engine.
This Customer Support Program provides coverage as it applies to the engine turbocharger assemblies on certain 2022 2025 Model Year Tundra, 2022 2025 Model Year Tundra HV, and 2023 2025 Model Year Sequoia models. The specific condition covered by this program is for corrosion of the turbocharger assemblys wastegate bushing and pin due to defects in materials or workmanship. If this occurs, the engine warning light will illuminate after engine start up and there could be a reduction in acceleration performance. When the engine warning light illuminates Diagnostic Trouble Code (DTCs) P25B372, P25B473, P25B572, and/or P25B673 are set in the engine Electronic Control Unit (ECU). If the condition is verified, the vehicle will be repaired with improved turbos under the terms of this Customer Support Program
TSB: The Immobilizer and Smart Key Reset is a feature that allows the registration of new keys when all master keys are lost. Once the system is reset, all previously registered keys will be erased and can never be reused. Another feature, Add/Remove Key, is also available. Once a key is removed, it can never be reused.