null Cracks may develop over time in the right-hand drive shaft. In the worst case, the drive shaft may break, leading to a sudden loss of drive. This may lead to an unsafe traffic situation.
Volvo quality follow-up procedures have identified an issue on a number of model year 2007 C30 S40 and V50s relating to the engine cooling fan control module. Under certain operating conditions water intrusion could occur into the control module causing a short circuit which in very rare instances could result in a fire in the engine compartment.
On certain five cylinder engines it is possible that the high pressure fuel pipes may not have been correctly installed and may leak. This should be identified by a smell of fuel from the engine bay. However it is possible that in extreme cases an engine bay fire could occur.
Volvo is recalling certain vehicles equipped with garmin 760 portable global positioning system (gps) units because the batteries on those units may overheat.
It has been identified that on subject vehicles the engine cooling fan module could under certain operating conditions develop a short circuit caused by water intrusion. This in rare circumstances could result in an engine bay fire.
On certain vehicles, rubber seals inside the brake master cylinder assembly may suffer premature wear, causing internal fluid leakage. This could result in reduced braking performance, that may gradually deteriorate over time. Eventually, this could cause a complete loss of brake functionality, increasing the risk of a crash with property damage, and/or personal injury or death. Correction: Dealers will inspect and, if necessary, replace the brake master cylinder and fluid reservoir.
It has been identified that the fuel line is sensitive to the extreme temperatures that occur in the area where the turbo and exhaust manifold are located. This can result in a fuel leak a non-start and in extreme cases a fire.
On certain passenger vehicles equipped with t5 turbo engines, the polyamide tube in the fuel line is sensitive to the extreme temperatures that may occur in the area where the turbo/exhaust manifold is located.
It has been established that the securing process for the exhaust tail pipe sleeve may not be to specification and result in the tail pipe sleeve detaching. This could cause an issue for other road users.
The cover on the top of the engine cover could chafe against the brake vacuum hose. If this occurs it may lead to a vacuum leak in the brake booster system and a gradual reduction of brake booster assistance. The will lead to the brake pedal becoming harder to push than normal and increased force would be required to stop the car.
It is possible that stress cracks may occur in the offside main support member within the engine bay which could affect the vehicle structural performance if it is involved in an accident.
It is possible that the driver's and passenger's front powered seats may not be fitted with the front stop lug. The lug restricts the movement of the seats and if not fitted it is possible to position the seats too far forward or backwards. This could increase the chances of injury should the vehicle be involved in an accident.
Volvo is recalling certain passenger vehicles equipped with power front passenger seats. The front seat rail's detection system was manufactured incorrectly and may permit the passenger to forward the seat beyond the intended maximum.
It is possible that the hose connection between the coolant expansion tank and the bleed hose can work loose. If this should occur then coolant will leak and air will enter the system. Under these conditions the low coolant level warning light will not function. If the vehicle is driven in this condition it will cause engine damage and in the extreme possible failure.
A section of the gear shift mechanism may over time become loose and cause the mechanism to become jammed. If this was to occur it might not be possible to change gear or select neutral.
Volvo is recalling certain model year 2010-2011 c30, model year 2010 s40 and v50 vehicles equipped with 6 speed manual transmissions. The gearshift lever stud assembly may not have been tightened to the correct specification during assembly. If the gearshift lever cable or stud assembly becomes loose, it may not be possible to engage, disengage or shift gears.