Flash: Powertrain Control Module (PCM) Updates Customers must experience a Malfunction Indicator Lamp (MIL) illumination and the vehicle must exhibit/set one or more of the following Diagnostic Trouble Codes (DTCs): **P0420 - Catalyst System Efficiency Below Threshold Bank 1. P0430 - Catalyst System Efficiency Below Threshold Bank 2.** P0456 - EVAP System Small Leak. **Customers may also comment on one or more of the following: Vehicle fails emissions inspection testing.* This bulletin involves reprogramming the PCM with the latest available software.
NHTSA · نشرة المصنع11034362سنوات الطراز 2019معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Part Description: Mirror, Side View Issue Description: New mirror now includes a grommet on the electrical wire. If the mirror being removed from the vehicle does not have a grommet and the new mirror does, this is not an issue. Install the new mirror and grommet.
NHTSA · نشرة المصنع10229874سنوات الطراز 2014معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
**وصف القطعة:** 5.7 لتر Long Block
**وصف المشكلة:** تركيب الـ 5.7 لتر Long Block Assembly متوافق مع تطبيقات EGR وغير EGR. يجب طلب لوحة الإغلاق لنظام EGR (EGR Block-Off Plate) رقم 53032739AA عند تركيب هذا الـ Long Block Assembly في تطبيق غير EGR، ما لم تكن لوحة الإغلاق لنظام EGR منقولة من المحرك القديم.
Customer Satisfaction Notification T12 VECI Label The Vehicle Emission Control Information (VECI) label on about 120,000 of the above vehicles may be missing emission control information. The VECI label is often used during in-use Inspection and Maintenance (I/M) testing to verify proper emissions related components. Incorrect VECI label information could result in denial of vehicle registration for the vehicle in the state of California. A new VECI label must be installed.
NHTSA · نشرة المصنع10224875سنوات الطراز 2015معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 Nm [21 ft. lbs.].
NHTSA · نشرة المصنع10223854سنوات الطراز 2007معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
**وصف القطعة:** كتلة المحرك الطويلة 5.7L
**وصف المشكلة:** تجميعة الكتلة الطويلة 5.7L هذه متوافقة مع تطبيقات EGR وتطبيقات Non-EGR. يجب طلب لوحة سد EGR (53032739AA) عند تركيب تجميعة الكتلة الطويلة هذه في تطبيق Non-EGR، إلا إذا كانت لوحة سد EGR منقولة من المحرك القديم.
Part Description: Mirror, Side View Issue Description: New mirror now includes a grommet on the electrical wire. If the mirror being removed from the vehicle does not have a grommet and the new mirror does, this is not an issue. Install the new mirror and grommet.
NHTSA · نشرة المصنع10221042سنوات الطراز 2014معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
SEAL, Input If looking to replace stubshaft due to ATX fluid leaking, do not replace PTU seals. None of the seals from the PTU side will need to be replaced whenever the ATX stubshaftis replaced, even though V-seal (68408748A$) is in direct contact with the stubshaft,it will not avoid grease/oil leakage from transmission side. PTU V-seals are intended to act as a dust cover for stubshaft-PTU input shaft spline interface. PTU Input shaft seal (68408749A$) is intended to hold PTU oil and debris ingress; it should be replaced only if the fluid leakage is confirmed to be PTU oil and not ATX trans. fluid.
NHTSA · نشرة المصنع10168388سنوات الطراز 2019معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Part Description: Mirror, Side View Issue Description: New mirror now includes a grommet on the electrical wire. If the mirror being removed from the vehicle does not have a grommet and the new mirror does, this is not an issue. Install the new mirror and grommet.
NHTSA · نشرة المصنع10139872سنوات الطراز 2014معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Radiator If vehicle comes in for transmission fluid leaking from trans-oil cooler fittings on the radiator, please check the following before replacing the radiator/cooler:~ 1. Remove both of the transmission lines from the cooler?s top/bottom flared fittings on the radiator. ~ 2. Loosen the hex nut on the top flared fitting on the radiator tank.~ 3. Torque the top flared fitting to 235 +/- 15 Lb-In.~ 4. Torque hex nut to 100 +/- 10 Lb-In.~ 5. Repeat for bottom flared fitting.~ 6. Reinstall transmission line per normal installation procedures and ensure correct fluid level.~ ~ If vehicle is in need of a new radiator for another reason, check the new radiator for correct torque on the trans-oil cooler fitting per steps 2-5 above.~ ~ If radiator has a yellow mark by the trans-oil cooler fittings the torque does not have to be checked.
NHTSA · نشرة المصنع10121923سنوات الطراز 2000معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Oem torque specifications for the steering shaft have been identified and are now being used in the installation of the vmi steering extension. This sb notifies the technicians to ensure the torque specifications for the steering extension have been complied with at the factory. This will bring the van into conformance with vmi updated processes
NHTSA · نشرة المصنع10096410سنوات الطراز 2016معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Oem torque specifications for the steering shaft have been identified and are now being used in the installation of the vmi steering extension. This sb notifies the technicians to ensure the torque specifications for the steering extension have been complied with at the factory. This will bring the van into conformance with vmi updated processes
NHTSA · نشرة المصنع10084322سنوات الطراز 2016معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
"flash: Powertrain diagnostic and system improvements this bulletin involves selectively erasing and reprogramming the powertrain control module (pcm) with new software. Symptom/condition: A small number of customers may experience a malfunction indicator lamp (mil) illumination. Upon further investigation the technician may find one or more of the following diagnostic trouble codes (dtcs) set in the pcm: Jc vehicles 3.6l: P0335 - crankshaft position sensor circuit. P2610 - pcm internal engine off timer performance. U0140 - lost communication with body control module (bcm). P0456 - evap system small leak. P0108 - manifold absolute pressure sensor circuit high (2012 my only). The following transmission enhancements are also included in this software update: Continuous cycling of fuel pump relay when using remote start. 1 - 2 upshift clunk or bump. 3 - 4 harsh upshift at closed throttle after a wot stab in 1st or 2nd gear. 4 - 5 upshift clunk or bump. 5 - 6 upshift clunk or bump. 5- 4 downshift clunk or bump. 6 - 5 downshift clunk or bump. Rpm fluctuating or jerking while operating in cruise control. Condition is more noticeable when the vehicle is going up and down grades. Improves the consistency of how shifts are controlled during upshifts torque management. Delayed downshifts. Jc vehicles 2.4l: **u0140 - lost communication with body control module (bcm).** p0456 - evap system small leak. The following transmission enhancements are also included in this software update: 1 - 2 upshift clunk or bump. 3 - 4 harsh upshift at closed throttle after a wot stab in 1st or 2nd gear. 4 - 5 upshift clunk or bump. Rpm fluctuating or jerking while operating in cruise control. Condition is more noticeable when the vehicle is going up and down grades. 1 - 2 harsh upshift going down a grade. 3 - 2 downshift clunk or bump. 4 - 3 downshift clunk or bump.
NHTSA · نشرة المصنع10076532سنوات الطراز 2013معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Chrysler/dodge: When braking, steering wheel would shake, brake pedal pulsates and/or floor pan vibrates and need to replace, both, front brake rotors, right and left front lower control arms, brake linings and resurfacing, and install new right and left front lower control arms. Model 2011-2012 caravan, town and country. *pe
NHTSA · نشرة المصنع10054185سنوات الطراز 2012معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Chrysler/dodge service campaign: See document search button for owner letter. The low pressure power steering hose on certain vehicles may leak under certain extreme cold climate operating conditions. This result in a loss of power steering assist upon vehicle start up. Csc letter was received. *pe
NHTSA · نشرة المصنع10028064سنوات الطراز 2008معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Chrysler\dodge\jeep service campaign: See document search button for owner letter. Emissions recall h06-spark plugs. Approximately 440 engines in the above vehicles may have had incorrect spark plugs inadvertently installed in three of the six cylinders. Csc was received. *pe
NHTSA · نشرة المصنع10025305سنوات الطراز 2008معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).