🔔 أنشئ حسابًا مجانيًا لتلقي تنبيهات البريد عن Lexus إي إس IV
يجمع هذا الملف الأعطال المعروفة لـLexus إي إس IV، التي كتبها المجتمع ووثّقها بالمصادر. القراءة مجانية، والحساب المجاني يتيح المساهمة. يحصل العطل على الختم عندما يعتمده عدد كافٍ من المساهمين الموثوقين.
256 owners in the United States reported problems with the accelerator and cruise control of this car to NHTSA (model years 2002–2006), typically at around 30,000 miles. Most often named: accelerator pedal (17%). Reported consequences: 137 crashes, 1 fire, 65 injuries, 1 death.
109 owners in the United States reported problems with the airbags of this car to NHTSA (model years 2002–2006), typically at around 74,000 miles. Reported consequences: 43 crashes, 40 injuries, 2 deaths.
59 owners in the United States reported problems with the brakes of this car to NHTSA (model years 2002–2006), typically at around 36,000 miles. Most often named: antilock/traction control/electronic limited slip (15%). Reported consequences: 29 crashes, 2 fires, 11 injuries.
On certain vehicles equipped with a 1MZ-FE or 3MZ-FE V6 engine, the crankshaft pulley may fail. The outer ring may become misaligned, or it may not properly rotate, causing noise and/or illumination of the discharge warning light. In addition, the power steering belt may become detached from the crankshaft pulley, which could result in a sudden increase in steering effort. A loss of steering power assist could result in a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the crankshaft pulley.
Toyota is recalling certain model year 2004 avalon vehicles; 2004 and 2005 camry, camry solara, highlander, and sienna vehicles, 2006 highlander hybrid; 2004 and 2005 lexus es330 and rx330; and 2006 lexus rx400h vehicles manufactured from june 1, 2004 through march 31, 2005, equipped with the 1mz-fe or 3mz-fe engine. The amount of adhesive agent applied between the outer ring and the torsional rubber damper (inner ring) in the crankshaft pulley may be inadequate. If the adhesive is insufficient, there is a possibility that the outer ring may become misaligned and it may not properly rotate with the inner ring, causing noise and/or illumination of the battery discharge indicator light.
On certain passenger vehicles equipped with a front passenger power seat, when installing certain rear-facing infant child seat bases onto the seat with an excessively high seatbelt tension, it may be possible to unseat a component called the buckle status switch from the seat belt buckle.
The condition known as acid rain is caused by airborne chemicals or particles in the atmosphere, which mix with rainwater, nighttime dew, or high humidity to form acidic compounds. If these contaminants settle and remain on a painted vehicle surface, especially the horizonal areas of the hood, roof, and decklid, significant damage can occur. This damage is the result of actual etching of the paint and appears as pitting or water spots. As acid rain droplets on the vehicle surface evaporate, the concentration strength of the acid increases, causing deeper and more rapid damage. This evaporation and corrosive action also occur more rapidly on dark colored cars as direct sun heat increases. While Lexus paint quality, durability, and resistance to environmental factors is continuously being improved, it remains the responsibility of the dealer to protect and maintain the vehicles paint finish from the time of arrival at the dealership until retail delivery to the customer. In areas known for high frequency and/or concentration of acid rain, frequent vehicle washing during high heat or humidity periods will minimize the potential for paint damage caused by acid rain. It is further recommended that either reverse osmosis or deionized water be used to prevent water spotting. SUPERSESSION NOTICE The information contained in this bulletin supersedes Service Bulletin No. BO029-91. The entire bulletin has been updated. Service Bulletin No. BO029-91 is obsolete
Acid rain results from rainwater or other airborne moisture that become acidic due to industrial chemical impurities in the atmosphere. If these acidic compounds settle on an exposed vehicle, especially the horizontal areas such as the hood, roof, and decklid, significant damage to the painted surfaces can occur. Acid rain damage can typically be identified on vehicles by the presence of stains on the paint surface that resemble hard water spots. Unlike water spots however, acid rain damage cannot be removed by regular washing procedures. Also, because acid rain can etch and soften the paint, normal buffing or polishing repair procedures should not be attempted. This can cause further damage and result in visible depressions in the paint surface. The following are the three major categories of acid rain damage: Minor damage: requires only buffing to repair. Moderate damage: usually requires neutralizing, color sanding, and buffing. Severe damage: extending beyond 1/2 mil of clearcoat on a pearl, metallic, or solid color, requires neutralization, sanding, and repainting. In cases where acid rain damage is minor, neutralization and buffing with a liquid-type paint finessing product may provide an adequate repair. Only specially formulated products outlined in this bulletin should be used for that purpose. Unfortunately, other than minor damage, there is no simple method of determining the actual extent (depth) of acid penetration other than color sanding a representative affected area until there is no visible etching or depressions, followed by measuring the amount of paint removed with either a magnetic or digital-type film thickness gauge. The procedures in this bulletin are intended for use by qualified body/paint technicians and should not be attempted by inexperienced personnel. While the quality and durability of paint on Lexus vehicles is continuously being improved, it remains the dealers responsibility to protect and maintain the quality of the vehicles paint finish after receipt at the dealership prior to the first sale. Perform frequent vehicle washing, as often as daily, during high heat and humidity periods to minimize the potential for paint damage due to acid rain exposure. This is especially important in geographical areas known for high frequency and concentration of acid rain and industrial fallout.
Lexus vehicles are currently protected with RapgardTM protective film designed to protect the horizontal painted surfaces. This material protects from acid rain, environmental fallout, and rail contamination. Follow the Removal Procedure in this bulletin to remove the RapgardTM protective film within 90 days from initial application. SUPERSESSION NOTICE The information contained in this bulletin supersedes Service Bulletin No. L-PG004-94. The entire bulletin has been updated.
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0).