نشرة
Tire pressure monitoring system (TPMS) warning Light IlluminationMisure prevention logic
🔔 أنشئ حسابًا مجانيًا لتلقي تنبيهات البريد عن Mazda Mazda2 (كل الأجيال)
النشرات الفنية (TSB) تعليمات إصلاح يرسلها المصنعون إلى وكلائهم بشأن مشكلات معروفة. ليست استدعاءات سلامة، لكنها كثيرًا ما تؤكد وجود عطل.
Tire pressure monitoring system (TPMS) warning Light IlluminationMisure prevention logic
Some customers may experience a SBS/SCBS, LAS/LDWS and/or HBC warning light on. A system error message may also be found in the center display. DTC U3000:04-0A (Forward sensing camera (FSC) internal malfunction). DTC U3000:04-0A (Forward sensing camera (FSC) internal malfunction) is stored in the FSC module and cannot be erased. This concern may be caused by a hardware failure of an internal device of the FSC, which results in a malfunction detection. To eliminate this concern, the production process of the FSC has been modified.
قد تُظهر بعض المركبات صوت صرير صادرًا من المكابح الأمامية عند الكبح بعد توقفها لفترة في طقس بارد ورطب. وبسبب زيادة مقاومة الفرامل في الظروف الباردة، تهتز الفرامل بسهولة، مما يسبب صوت الصرير.
A/C blows warm air. Some customers may complain about warm air from the climate cointrol vents. This may be caused by improper brazing (A) of the evaporator (B) causing a refrigerant leak fr om the joint between the tubes and the header (D)
If you experience issues with the current version of ID's such as missing tools or modules not showing after completing a network test, be advised that we are aware of these issues and are working to resolve them. As a counter measure, it is advised that you un-install ids and re-install version 103.00 and "do not update" until further notice.
Some vehicles may exhibit an unusual noise from around the drivers foot area when repeatedly turning the steering wheel to the left or right. A vibration is felt at the steering wheel when the noise occurs. This concern may be caused by a lack of grease application to the splines of the intermediate shaft at the production line. The grease application process has been improved.
قد يشتكي بعض العملاء من أي مما يلي: 1. لا تعرض شاشة مركز الترفيه في السيارة رمز التفويض (OTP) أثناء تسجيل المركبة المتصلة بتطبيق MyMazda. 2. تعطل وظيفة (وظائف) التحكم عن بُعد.
قد تظهر على بعض المركبات إضاءة مؤشر عطل المحرك (Check Engine) مع تخزين رمز العطل DTC P0300:00 (تم اكتشاف إخفاق عشوائي). قد يكون السبب سوء اكتشاف حالة إخفاق بسبب خلل في منطق التحكم في وحدة التحكم بالمحرك (PCM). وللقضاء على هذه المشكلة، تم تعديل منطق التحكم في وحدة PCM.
قد يلاحظ بعض العملاء أن مصباح الشحن يضيء أثناء القيادة. وعند الفحص، يتم تخزين رمز العطل DTC P2502:00 PCM (عطل في الجهد المتولد من المولد) في الذاكرة. وقد يكون السبب وجود مقاومة بين لوحة الدوائر والأرضي. عندما يمر تيار كهربائي عالي الشدة، قد لا يكون موضع طرف الأرضي كافيًا. وللقضاء على هذه المشكلة، تم تعديل برنامج التحكم في محول DC-DC. كما تمت مراجعة إجراء التصنيع. وتمت زيادة عزم شد طرف الأرضي ولوحة الدوائر.
Some customers may experience a check engine light illumination at idle while stopped with DTC P0300:00 stored, resulting in rough idle conditions. P0300:00: Random misfire detected This concern is caused by improper engine control in the idle range. To eliminate the concern, the PCM control software has been modified.
Front/Rear stabilizer noise prevention
**تدهور لون MultiModel (المزود بنظام skyactivdrive)** يكون لون زيت ناقل الحركة الأوتوماتيكي (ATF) في السيارة الجديدة أزرق. ومع زيادة مسافة قطع السيارة، يتغير لون الزيت. ولا يؤثر تغير اللون على أداء السيارة.
BSM Radar aiming cannot be performed after rightside BSM control module rekkplacement
Mazda Technical Service Bulletins March 2016 Some vehicles may exhibit the inner cloth (A) falling down at the rear end causing a poor appearance and obstructing the view of the back window.
Maintenance.
ماздا للخدمات المتصلة - الأسئلة الشائعة (FAQ): الفهرس: الأسئلة العامة، الإعداد والبدء، التسجيل / الاشتراك، معلومات عامة عن الواي فاي، كيفية استخدام الواي فاي، فترة التجربة المجانية للواي فاي، التفاعل مع التطبيق، مشكلات الخدمة، استكشاف الأخطاء وإصلاحها، فحص مستوى الاستقبال، عمليات الوكيل، شروط عدم عمل التشغيل عن بُعد للمحرك، شروط إيقاف تشغيل المحرك عند وظيفة التشغيل عن بُعد، مقاطع الفيديو التعليمية، الموارد
## Mazda Connected Services - الأسئلة الشائعة (FAQ) الفهرس: الأسئلة العامة، الإعداد والبدء، التسجيل / الاشتراك، معلومات عامة عن الواي فاي، كيفية استخدام الواي فاي، الفترة التجريبية للواي فاي، التفاعل مع التطبيق، مشكلات الخدمة، استكشاف الأخطاء وإصلاحها، فحص مستوى الاستقبال، إجراءات الوكيل، شروط عدم عمل بدء تشغيل المحرك عن بُعد، شروط إيقاف تشغيل المحرك بواسطة وظيفة بدء التشغيل عن بُعد، فيديوهات تعليمية، المصادر
Some customers may experience the CHECK ENGINE light ON with DTC P0089:00 (Spill valve control solenoid valve control circuit range/performance problem) stored. This is caused by improper control software of the PCM detecting a false error, even with normal fuel pressure operation. To correct this issue, the control software of the PCM has been modified.
Some vehicles may experience a fuzzy appearance (tiny cracks) around the edge of the Active Driving Display. Replace the Active Driving Display.
Beginning with the CX-5 and Mazda6 models, grip type front and rear stabilizer bushings have been incorpo-rated for noise prevention purposes. If any type of grease or lubrication is applied to the bushings, it may create noise due to bushing slippage.
Some vehicles may experience the check engine light on with DTCs P2096:00, P2097:00 and/or P0524:00 that cannot be cleared by itself, and the check engine light stays on even if the detection condition has gone. P2096:00 - Air fuel too lean P2097:00 - Air fuel too rich P0524:00 - Engine oil pressure too low. This concern may be caused by improper PCM control logic. The PCM software has been modified to eliminate this concern.
Some vehicles may experience a fuzzy appearance (tiny cracks) around the edge of the Active Driving Display.
New IDs software version 102.00 and Update 102.01 is now available on MS3 IDs update 102.00 and 102.01 is now available on MS3 under the "IDs/Infotainment" tab.
Recall 0516j updated repair procedure
Windshield washer fluid change - Factory filled windshield washer fluid has been changed to an ethanol type (yellow color) instead of athe conventional methanol type (blue color). This change is for European compliance Mazda has decided to make the change for all markets.
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).