Airbags: problems reported by owners
158 owners in the United States reported problems with the airbags of this car to NHTSA (model years 2008–2014), typically at around 70,000 miles. Reported consequences: 23 crashes, 26 injuries, 1 death.
🔔 أنشئ حسابًا مجانيًا لتلقي تنبيهات البريد عن Nissan مورانو (كل الأجيال)
كل ما يخص Nissan مورانو بجميع أجياله: الأعطال وحملات الاستدعاء والنشرات الفنية والنقاشات. اختر جيلًا لتضييق النتائج.
158 owners in the United States reported problems with the airbags of this car to NHTSA (model years 2008–2014), typically at around 70,000 miles. Reported consequences: 23 crashes, 26 injuries, 1 death.
73 owners in the United States reported problems with the engine of this car to NHTSA (model years 2009–2014), typically at around 75,000 miles. Reported consequences: 1 crash, 3 fires, 1 death.
97 owners in the United States reported problems with the brakes of this car to NHTSA (model years 2015–2024), typically at around 22,000 miles. Reported consequences: 9 crashes, 6 fires, 8 injuries.
77 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2015–2023), typically at around 34,000 miles. Reported consequences: 2 crashes, 5 fires.
63 owners in the United States reported problems with the airbags of this car to NHTSA (model years 2015–2020), typically at around 14,000 miles. Reported consequences: 12 crashes, 17 injuries.
Issue: On certain vehicles, a software problem could cause infotainment system display to remain blank when the vehicle is started. As a result, when the transmission is shifted into reverse gear, the rearview camera image would not appear on the display. Note: This recall only affects certain trim levels. Safety Risk: A rearview camera image that doesn't display could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash. Corrective Actions: The company will notify owners by mail and advise you to take your vehicle to a dealership to update the infotainment system software.
Nissan North America, Inc. (Nissan) is recalling certain 2025 Murano, 2025-2026 Armada, and Infiniti QX80 vehicles. A software error may occur in the In-Vehicle Infotainment (IVI) system at vehicle startup, resulting in the rearview camera image not displaying when the vehicle is shifted into reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility."
المشكلة: في بعض السيارات، قد لا تكون مشابك الفرامل الأمامية مصنعة بشكل صحيح. نتيجة لذلك، قد يتشقق الكاليبر مما يؤدي إلى تقليل الفرملة. مخاطر السلامة: قد يؤدي تقليل الفرملة إلى زيادة مسافات التوقف وزيادة خطر الحادث. الإجراءات التصحيحية: ستبلغ نيسان المالكين عبر البريد وتنصحك بأخذ سيارتك إلى وكالة للفحص واستبدال كاليبر الفرامل الأمامية إذا لزم الأمر.
BSW WARNING WITH C1E00-47 AND/OR C1E80-47 STORED IN SIDE RADAR REAR LH AND/OR SIDE RADAR REAR RH This bulletin is no longer active. Please discard previous versions of NTB26-047.
BSW WARNING WITH C1E00-47 AND/OR C1E80-47 STORED IN SIDE RADAR REAR LH AND/OR SIDE RADAR REAR RH IF YOU CONFIRM The BSW warning was displayed, and one or more of the following DTCs are stored as Current: C1E00-47 for "Control Unit" stored in the Side radar "Rear Left" C1E80-47 for "Control Unit" stored in the Side radar "Rear Right" ACTION 1. Confirm the current part number of the Side Radar (Rear LH) and/or Side Radar (Rear RH) that corresponds to the stored DTC(s). 2. Based on the DTCs stored, individually reprogram each applicable Side Radar (Rear LH) and/or Side Radar (Rear RH).
ENGINE NO START WITH KEY SYSTEM ERROR AND DTC B2C20-24 STORED IN THE BCM IF YOU CONFIRM The customer states the engine will not start and Key System Error warning is displaying in the Information Display (Combination Meter) (Figure 1), AND DTC B2C20-24 for "STARTER CONTROL RELAY" is stored in the BCM. Figure 1 HINT: This DTC and warning message (Figure 1) may occur if the customer does not place the vehicle in Park Gear according to the Owners Manual for shifter operation. ACTION 1. Confirm the current ECM part number. 2. Confirm the current TCM part number. 3. Reprogram the ECM, and then the TCM, if applicable. 4. Erase the DTCs. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.
تُصنَّف الأعطال والنقاشات حسب الجيل: اختر جيلًا أعلاه لإضافة مشاركتك.
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0).