Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

Audi A4 B8

2007–2015 · 14 dokumentierte Mängel · 2 Märkte

Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.

SchweregradAlleMittelGering
Modelljahr
MarktAlleNA
BulletinMittelMotorNA

Bulletin

A small amount of dry or crusted coolant is seen on the coolant pump housing. The coolant level warning is not on. A minor coolant leak is possible during the break-in phase of the coolant seal on the coolant pump. The dry coolant marks are normal.

NHTSA · Herstellerbulletin10124868Modelljahre 2010Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

MIL on. DTCs for the cam actuators are stored in ECM memory. After the activation of the cam actuator to change to the other cam profile, the pin of the actuator is pushed back in by the cam. This is confirmed by a voltage impulse, which is registered by the engine control unit and confirms the operation. If this does not happen, or not at the right time, a DTC "implausible signal" is saved in ECM memory. Check the distance of the pin tip of the cam actuator for valve lift system to the camshaft when it is not operated with a gauge. The measurement of the tip to the basic camshaft circle outside of the groove must be taken. If this measurement is 0.9mm, the actuator 06E103697J must be installed. The actuator 06E103697J must only be used, if the measurement is 0.9mm or bigger.

NHTSA · Herstellerbulletin10122800Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

Audi: On the turbocharger engine, the coolant supply line may leak, within a specific period and needs to be replaced. *pe

NHTSA · Herstellerbulletin10043507Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

Audi service campaign: See document search button for owner letter. Under certain conditions the coolant pump may leak. *rm

NHTSA · Herstellerbulletin10038584Modelljahre 2011Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

Audi: It is possible that the coolant supply line at the turbocharger may leak on audi vehicles with 2.0l tfsi engines built within a specific period. *pe

NHTSA · Herstellerbulletin10033027Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

Audi: It is possible that the coolant supply line at the turbocharger may leak on vehicles with 2.0l tfsi engines built within a specific period. *pe

NHTSA · Herstellerbulletin10033026Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

Audi: Engine oil may be leaking from upper engine area. Due to the porosity of the cam carrier casting, oil can drain into the thread of the cam bolt and cause an external engine leak. All bolts are installed with loctite. *pe

NHTSA · Herstellerbulletin10030609Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

This bulletin provides informatin when the engine does not run smoothly at idling speeds.

NHTSA · Herstellerbulletin11016532Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

This bulletin provides information when the MIL is on; DTCs for misfire, air/fuel ratio imbalance, or lean fuel system stored in the ECM P030000.

NHTSA · Herstellerbulletin11012476Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

This bulletin provides informatin when the engine does not run smoothly at idling speeds.

NHTSA · Herstellerbulletin11009928Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.

NHTSA · Herstellerbulletin10228289Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.

NHTSA · Herstellerbulletin10224968Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay.

NHTSA · Herstellerbulletin10221941Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

The ignition key cannot be removed even though the gear shifter is in Park (P). The vehicle is mechanically in the Park position, but this is not recognized electronically. The gear shifter cannot be moved from the Park position. On vehicles with Audi advanced key, the vehicle cannot be locked by remote control after the engine has been switched off.The Park position of the gear shifter is sporadically not recognized, which causes the ignition key to not be cleared and prevents the vehicle from being locked.

NHTSA · Herstellerbulletin10210672Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

This document contains the important email to all Audi dealership personnel in regards to the immediate madatory stop-sale order that is in effect to all vehicles from 20110-2015 that have a 2.0L TDI engine.

NHTSA · Herstellerbulletin10123792Modelljahre 2010Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Supersedes Technical Service Bulletin Group 17 number 15-60 dated April 24, 2015. In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine and may change significantly over the life of the engine. Typically, engines with specified break-in periods consume more oil during the break-in period, and the oil consumption will stabilize after the break-in period. Refer to the Owner?s Manual for specific break-in procedures. Under normal conditions, the rate of oil consumption depends on the quality and viscosity of the oil, the RPM at which the engine is operated, the ambient temperature and road conditions. Additional factors are the amount of oil dilution from water condensation or fuel residue and the oxidation level of the oil. Under certain driving conditions, internal engine pressure conditions in the 2.0 TFSI engine can negatively influence the rate of oil consumption. This condition can occur while the vehicle is operated in metro driving conditions; for example: stop-and-go traffic with extended idle periods.

NHTSA · Herstellerbulletin10123603Modelljahre 2011Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

When a phonebook with a large number of contacts is being downloaded, the MMI screen freezes Briefly after the initial Bluetooth connection (shortly after the phone is bonded to the vehicle), after the ignition is switched on (shortly after the phone automatically reconnects with the vehicle), and after the phonebook has downloaded. When the voice recognition system is used, a message appears in the MMI screen stating that the phone book is too large and that the voice recognition system cannot be used. When music is streamed to the MMI system with the Bluetooth A2DP connection, the music intermittently pauses or seems to skip. The condition goes away once the phonebook transfer is completed. The MMI uses a limited portion of the total memory to convert the name and phone number fields of downloaded contacts into a voice command (text to speech). Extensive processing takes place if too many letters are used in the first and last name fields or if numbers or special characters are entered. The remaining memory is dynamically assigned to different applications which can also affect the capacity of the voice command processing. The MMI does not respond until the process is completed or it may freeze if phonebook fields are too large or do not follow typical formatting. In addition, the text-to-speech capacity is exceeded and the voice recognition system is rendered inactive.

NHTSA · Herstellerbulletin10120048Modelljahre 2010Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

This document contains general information on the upcoming warranty extension on the high pressure fuel pump.

NHTSA · Herstellerbulletin10120015Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Supersedes Technical Service Bulletin Group 17 number 15-54 dated January 29, 2015. In order to provide effective lubrication and cooling of internal engine components, all internal combustion engines consume a certain amount of engine oil. Oil consumption varies from engine to engine and may change significantly over the life of the engine. Typically, engines with specified break-in periods consume more oil during the break-in period, and the oil consumption will stabilize after the break-in period. Refer to the Owner's Manual for specific break-in procedures. Under normal conditions, the rate of oil consumption depends on the quality and viscosity of the oil, the RPM at which the engine is operated, the ambient temperature and road conditions. Additional factors are the amount of oil dilution from water condensation or fuel residue and the oxidation level of the oil. Under certain driving conditions, internal engine pressure conditions in the 2.0 TFSI engine can negatively influence the rate of oil consumption. This condition can occur while the vehicle is operated in metro driving conditions.

NHTSA · Herstellerbulletin10119986Modelljahre 2011Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

This document contains the claim form for the Audi oil consumption class action settlement.

NHTSA · Herstellerbulletin10119886Modelljahre 2011Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Audi is extending the New Vehicle Limited Warranty for certain 2009-2011 A4, A5, and Q5 Vehicles with the CAEB 2.0T engine to 8 years/80,000 miles (whichever occurs first) from the vehicle's in-service date or 12 months/12,000 miles (whichever occurs first) from the date of a settlement Service Adjustment, whichever date occurs later. The limited warranty extension is fully transferable to subsequent owners. Eligible vehicles are identified in Elsa with the Warranty Extension Key U24 OC Ext-Info AWO Resource Ctr. Some customers have complained of excessive engine oil consumption. Conditions unrelated to engine oil consumption are not covered under this extension.

NHTSA · Herstellerbulletin10119879Modelljahre 2011Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Engine oil consumption is too high. Under certain driving conditions, internal engine pressure conditions in the 2.0 TFSI engine can negatively influence the rate of oil consumption. Crankcase pressure reduction starting with model year 2012

NHTSA · Herstellerbulletin10119856Modelljahre 2011Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Audi: Some audi vehicles with 2.0 tfsi engines will have the warranty extended for the intake solenoid. 7/23/15 *ta

NHTSA · Herstellerbulletin10058018Modelljahre 2011Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level shows that the oil level is not okay. When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.

NHTSA · Herstellerbulletin10124941Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Supersedes Technical Service Bulletin Group 87 number 13-46 dated October 21, 2013. The A/C Compressor has been diagnosed as faulty and will be replaced under warranty. When performing replacement of an A/C Compressor under warranty, the amount of refrigerant and oil recovered must be documented.

NHTSA · Herstellerbulletin10124760Modelljahre 2009Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Ältere →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).