Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

BMW E34 (E28)

1981–1987 · 4 dokumentierte Mängel · 4 Märkte
Modelljahr
RückrufKritischMotorUK

Fire may occur

Some engines are fitted with an additional water pump for the turbo charger. In some circumstances a crack may develop which then leads to melting of the plug connections and the housing. Further heat development may then lead to scorch damage. In exceptional cases such overheating can lead to smouldering of the water pump. If smouldering occurs an engine compartment fire and vehicle fire cannot be excluded.

DVSA · Vereinigtes Königreich27. Apr. 2012R/2012/049Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelFahrwerkUK

Rear shock absorber mounting may fail

It has been identified that the lower rubber mounting on the metal bush of the rear shock absorbers may fail to meet the quality requirement. Dependant on the mileage and operating conditions the rubber mounting may come completely free from the shock absorber. If this occurs the bodywork would no longer be supported above the wheels causing it to come into contact with the wheel concerned. Should this occur the possibility exists that a critical driving condition might occur or even the risk of an accident.

DVSA · Vereinigtes Königreich6. Juli 2006R/2006/119Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelElektrikNA

Electrical

On certain 325E, 325ES, 528E, 535I, 635CSI and 735I vehicles, the center high mounted brake light could add sufficient electrical load to cause the brake light switch to overheat, eventually leading to melting of the plastic internal switch parts. This could cause the switch plunger to jam in the ON or OFF position. This would render the brake light permanently ON or OFF regardless of brake pedal operation. Correction: A brake light switch with an increased current load capacity will be installed on affected vehicles.

Transport Canada27. Nov. 19861986134Modelljahre 1986–1987Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Exterior lighting:Brake lights:Switch

Brake light switch could overheat, eventually leading to melting of plastic internal parts in area of electrical contacts.

NHTSA · USA10. Nov. 198686V151000Modelljahre 1986–1987Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Brakes

On certain 533I, 633CSI and 733I, during assembly of the brake booster and master cylinder, stresses or possibly cracks in the master cylinder connecting flange may have occurred. It is possible that, during operation of the braking system, new cracks could develop and/or the existing cracks could be aggravated. This could reulst in misalignment of components and impaired brake function.

Transport Canada25. Jan. 19841984011Modelljahre 1984Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Service brakes, hydraulic:Power assist:Vacuum

The power brake booster may have been improperly machined causing stress and possibly cracks in the master cylinder where it is attached to the power brake booster.

NHTSA · USA19. Jan. 198484V006000Modelljahre 1984Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelFahrwerkNA

Steering: Steering wheel/handle bar

On the involved vehicles, the self locking nuts that connect the lower steering column shaft to the flexible coupling may not have been sufficiently tightened. These nuts can come loose.

NHTSA · USA9. Dez. 198282V122000Modelljahre 1983Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelGetriebeNA

Power train:Axle assembly

On some of the involved vehicles, the knurled nut, part of the rubber mount assembly which supports the differential, may have been cracked due to over-torquing of the final drive attaching bolt. This bolt may become loose, and continued operation may cause it to fall out.

NHTSA · USA2. Nov. 198282V108000Modelljahre 1982–1983Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelMotorNA

Engine

On certain 528E vehicles, at very cold temperatures, when the engine is warmed up, water vapour might condense and freeze in the throttle houseing after a period of steady driving, causing ice build-up around the throttle plate. The ice may prevent the throttle plate from closing when the driver releases the accelerator pedal. Note: This recall supersedes recall V82017.

Transport Canada27. Sept. 19821982079Modelljahre 1981–1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelMotorNA

Engine

On certain BMW 528E vehicles, at temperatures of -9 degrees celsius and colder and a warmed up engine, water vapour might condense and freeze in the throttle houseing after a period of steady driving, causing ice buildup around the throttle plate. The ice may prevent the throttle plate from fully closing when the driver releases the accelerator pedal.

Transport Canada2. Feb. 19821982017Modelljahre 1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelMotorNA

Vehicle speed control

On the involved vehicles, under a combination of low temperature conditions and a warmed up engine, water vapor in the warm air from the crankcase housing may condense and freeze after a period of steady state driving causing ice build up around the throttle plate. The ice might prevent the throttle plate from fully closing when the driver releases the accelerator pedal, causing a slower than normal deceleration rate and an increase of the idle speed.

NHTSA · USA28. Jan. 198282V010000Modelljahre 1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).