On certain 318I, 318IS, 325I, 325IS, 525I, 525IT, 535I, 735I, 735IL, 750IL, 850I and M5, the locking tab for the airbag contact ring in the steering wheel assembly could break without warning. If this happens it is possible that the contact ring wiring could break. This would cause the readiness indicator lamp ("SRS" or "AIRBAG") to illuminate and in such a case the airbag would not be available for deployment in a frontal impact. Correction: Locking tab will be replaced with one of a different design.
Transport Canada7. Okt. 19961996159Modelljahre 1991–1992Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Bei bestimmten Fahrzeugen kann der Ausfall einer Kühlsystemkomponente, etwa des Thermostats, der Wasserpumpe oder des Keilriemens, zu einem deutlichen Anstieg der Kühlmitteltemperatur und des Systemdrucks führen. Der erhöhte Systemdruck könnte die Bildung eines Risses oder das Auftrennen einer Naht im Endstück des Heizungskühlers verursachen, wodurch heißes Kühlmittel aus dem Heizungskühler austreten könnte. Diese heiße Flüssigkeit könnte mit den Fahrzeuginsassen in Berührung kommen, was möglicherweise zu Verletzungen führen und/oder die Innenseiten der Fensterflächen beschlagen lassen kann. Abhilfe: Der Kühlerdeckel wird durch einen Deckel neuer Bauart ersetzt, um einen übermäßigen Druckaufbau im Kühlsystem zu vermeiden.
On certain 525I, 535I, 735I, 735IL and 750IL vehicles, the front seat center fold-down armrest may contact and damage the seatbelt buckle if the seat back is moved forward to an upright position while the armrest is locked in the down position (horizontal). If this occurs, the release button may be held in the down position, preventing the seatbelt from being latched during the buckle-up operation. Non-latching of the seatbelts will increase the risk of personal injury in the event of a crash. Correction: Front seat safety belt buckles will be replaced with shorter ones that are not susceptible to damage by contact with the armrest.
Transport Canada27. Feb. 19901990037Modelljahre 1988–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Under certain conditions, front seat center, fold-down arm rest may contact the safety belt buckle, causing damage to the release button and preventing the belt tongue from latching when buckling up.
On certain 725I, 735IA and 750IL vehicles, on the front seats, the seatbacks may not have been fully seated on the recliner arms. This could result in looseness of, or noise in the seat. In extreme cases, during a severe rear impact, the seatback may not support the occupant and increase the risk of injury. Correction: Seatbacks will be inspected and properly seated if required.
Transport Canada25. Aug. 19881988124Modelljahre 1988Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The driver and/or passenger seatbacks may not have been fully attached to the seat base reclining arms (attaching brackets).
NHTSA · USA11. Aug. 198888V135000Modelljahre 1988Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).