Bulletin
When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises may be heard.
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu BMW 4 (alle generationen) erhalten
Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.
When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises may be heard.
There may be an internal leakage in the brake fluid expansion tank (aka brake fluid reservoir). In the rare case of a leak, the filling level sensor might malfunction over a relatively long period of time.
Brake groaning noises heard at the rear axle at slow speeds, i.e. close to standstill, stop and go driving;when parking or maneuvering.
At low outside temperatures (below 40 degrees F) and slow driving speeds (i.e. when parking, maneuvering)with a large steering angle, the front end can be slightly axially misaligned. This can be felt (jerking)/ heard via an acoustic acknowledgement (clunk) as seen at the 11 second mark of the video. See attached video V36 01 21.
Functional noises (squealing/honking) when braking shortly before the vehicle comes to a stop. CAUSE Material-
A vehicle arrives at your center to be diagnosed for a micro-leak in the fuel evaporative (EVAP) system (NVLD natural vacuum leak detection). For this condition, the following fault is stored in the DME: 190302 - fuel tank ventilation and scavenging air system, micro-leak: leakage more than 0.5 mm.
When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises may be heard.
Cracking noises heard from the area of the front axle when rotating the steering while stationary or at low speed.
Vehicle cannot be opened or closed using comfort access, engine start is not possible, and the vehicle may not start when placing the key against the steering column.
The SIM card installed in the telematics control unit (ATM2) connects to different mobile providers' networks. However, due to a missing parameter, this does not work and can cause disruption in BMW ConnectedDrive services in areas with insufficient network coverage.
BMW offers a new special ISTA Installation made available for Roadside Assistance / Mobile Service technicians.
It is possible that the EPP (expanded polypropylene) insert for the lithium-ion battery was not installed in approx. 0.3% of the G82 and G83 vehicles.
Vehicle cannot be opened or closed using comfort access, engine start is not possible, and the vehicle maynot start when placing the key against the steering column.
The yellow CCM, ID code 42, lights up when starting the vehicle. ID code 00042: Brake system. It is possible to continue driving. Additional notes: Avoid abrupt braking as far as possible. Drive at a moderate speed. Have it checked by your nearest Service Center.
When starting the vehicle vehicle at standstill, various yellow Check Control Messages CCMs appear. ID code 00042: Brake system. Additional notes: Avoid abrupt braking as far as possible. Drive at a moderate speed. Have it checked by your nearest Service Center. ID code 2046: Braking force assistance. Additional notes: Braking force assistance failure. Higher pedal force required for vehicle deceleration. Drive at a moderate speed. Have it checked by your nearest Service Center.
Groaning, scraping, or squeaking noise coming from the steering wheel area in the interior of the vehicle,when turning the steering wheel.
WHIRRING NOISES FROM THE STEERING WHEEL . When driving over rough road surfaces/cobblestones, there is a whirring/squeaking noise coming from the steering wheel-mounted air bag assembly.
REMOTE CONTROL IS NOT DETECTED: Vehicle cannot be opened or closed using comfort access, engine start is not possible, and the vehicle maynot start when placing the key against the steering column.
SERVICE ACTION: PROGRAM THE DYNAMIC STABILITY CONTROL (DSC) UNIT: Software in the DSC unit could cause a reduction of brake regeneration for the next 40 drive (key) cycles.
SERVICE ACTION: PROGRAM THE DYNAMIC STABILITY CONTROL (DSC) UNIT: Software in the DSC unit could cause a reduction of brake regeneration for the next 40 drive (key) cycles.
Diagnosis of Compound Brake System Complaints in M Vehicles: 1. Visible cracks are caused by high thermal stresses during rapid heating and cooling of the brake discs. Braking from high speed with cold brake components (less than 212 degrees F) increases the likelihood of cracks to form.
CHECKING THE JUMP START POINT COVER AND REWORKING IF NECESSARY: It is possible that the jump start terminal point cover was not installed, or not properly installed on the affected vehicles.
REMOTE CONTROL IS NOT DETECTED: Vehicle cannot be opened or closed using comfort access, engine start is not possible, and the vehicle may not start when placing the key against the steering column.
TICKING NOISE FROM DRIVERS FOOTWELL DURING LIGHT BRAKING WHILE COASTING: A ticking sound can be heard from the drivers footwell while coasting with the engine OFF. The noise occurs when the pedal is slightly pressed with minimum force without the brake light being activated.
TICKING NOISE FROM DRIVERS FOOTWELL DURING LIGHT BRAKING WHILE COASTING: A ticking sound can be heard from the drivers footwell while coasting with the engine OFF. The noise occurs when the pedal is slightly pressed with minimum force without the brake light being activated.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).